American International SBK926 Bruksanvisning

American International Inte kategoriserad SBK926

Läs nedan 📖 manual på svenska för American International SBK926 (4 sidor) i kategorin Inte kategoriserad. Denna guide var användbar för 10 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/4

SBK926 Mounting Kit

Subaru

2009-13 FORESTER

2008-11 IMPREZA

2008-14 IMPREZA WRX

VEHICLE APPLICATIONS

1. Open the Passenger door and remove the end cover exposing the (1) Phillips screw

securing the right end of the Vent/Trim panel to the right end side of the dash.

2. Remove the (1) Phillips screw securing the right end of the Vent/Trim panel to the

side of the dash, and carefully starting with the Vent end, pry the trim panel forward

working toward the radio. It is not necessary to remove the trim completely, just

unclip to the left side of the radio and rest out of the way.

3. Carefully unclip and remove the Vent/radio trim bezel.

4. Remove the (4) Phillips screws securing the radio to the sub-dash, pull the radio

forward, disconnect all attached harnesses and antenna lead and remove radio.

DASH DISASSEMBLY

KIT ASSEMBLY INSTRUCTIONS

1. Insert left and right mounting brackets to rear of kit as shown in Figure A

and secure to rear of kit fascia using (4) small phillips screws included in kit.

2. Insert pocket into lower section of the brackets and snap into rear pocket

support tabs.

3. Insert ISO mountable radio between ISO mount brackets and loosely

attach to sides of radio using screws provided with radio when possible

or screws supplied with kit.

4. Slide radio forward or backward for desired look and tighten screws.

Single ISO Mount Applications

Fig A THERE IS A

SPACE IN BOTH

LEFT AND RIGHT

UPPER BRACKET

TABS FOR

SCREWDRIVER

TO PASS

THROUGH.

Double DIN Mount Applications

Fig B

1. Insert IMB-926 L&R into rear of kit & attach using 4 screws supplied w/kit

(See Fig B for bracket tab removal).

2. Insert ISO mountable radio between ISO mount brackets and loosely attach

to sides of radio using screws provided with radio when possible or hardware

included with kit.

3. Slide radio component forward or backward for desired look and tighten screws.

4. Attach a rear support bracket to the rear of the new radio and adjust as necessary

to support the weight of the radio.

THERE IS A

SPACE IN BOTH

LEFT AND RIGHT

UPPER BRACKET

TABS FOR

SCREWDRIVER

TO PASS

THROUGH.

REMOVE SHADED MOUNTING

TABS ON BOTH LEFT AND

RIGHT SIDES OF KIT

Produktspecifikationer

Varumärke:	American International
Kategori:	Inte kategoriserad
Modell:	SBK926
Färg på produkten:	Zwart
Vikt:	144.5 g
Höjd:	25.4 mm
Diameter:	47.625 mm
Kompatibilitet:	DWM-02, DWZ