Bauknecht EKIO7640IN Bruksanvisning

Bauknecht Ugn EKIO7640IN

Läs nedan 📖 manual på svenska för Bauknecht EKIO7640IN (5 sidor) i kategorin Ugn. Denna guide var användbar för 2 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/5

EN11

YOUR SAFETY AND THAT OF OTHERS IS VERY IMPORTANT

This manual and the appliance itself provide important safety messages, to be read and always observed.

All messages relevant to safety specify the potential risk to which they refer and indicate how to reduce the risk of

injury, damage and electric shocks due to incorrect use of the appliance. Make sure to comply with the following:

- The appliance must be disconnected from the power supply before carrying out any installation operation.

- Installation and maintenance must be carried out by a specialised technician, in compliance with the

manufacturer’s instructions and the local safety regulations in force. Do not repair or replace any part of the

appliance unless specifically stated in the user manual.

- The appliance must be earthed.

- The power cable must be long enough for connecting the appliance, fitted in the cabinet, to the power supply.

- For installation to comply with the current safety regulations, an omnipolar switch with minimum contact gap

of 3mm is required.

- Do not use multi-sockets or extension cords.

- Do not pull the appliance’s power cable.

- The electrical parts must not be accessible to the user after installation.

- The appliance is designed solely for domestic use for cooking food. No other use is permitted (e.g. heating

rooms). The Manufacturer declines any liability for inappropriate use or incorrect setting of the controls.

- The appliance and its accessible parts become hot during use. Care should be taken to avoid touching heating

elements. Children less than 8 years old shall be kept away unless continuously supervised.

- The accessible parts can become very hot during use. Children must be kept away from the appliance and

watched over to ensure they do not play with it.

- Do not touch the appliance heating elements during and after use. Do not allow the appliance to come into

contact with cloths or other flammable materials until all the components have cooled sufficiently.

- Do not place flammable materials on or near the appliance.

- Overheated oils and fats catch fire easily. Pay attention when cooking food products rich in fat and oil.

- This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory

or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction

concerning use of the appliance in a safe way and understand hazards involved. Children shall not play with the

appliance. Cleaning and user maintenance shall not be made by children without supervision.

- A separator panel (not supplied) must be installed in the compartment under the appliance.

- If the surface is cracked, switch off the appliance to avoid the possibility of electric shock.

- The appliance is not intended to be operated by means of an external timer or separate remote control system.

- Unattended cooking on a hob with fat or oil can be dangerous and may result in fire. NEVER try to extinguish a

fire with water, but switch off the appliance and then cover flame e.g. with a lid or a fire blanket.

Danger of fire: do not store items on the cooking surfaces.

- Do not use steam cleaners.

- Metallic objects such as knives, forks, spoons and lids should not be placed on the hob surface since they can get hot.

- After use, switch off the hob element by its control and do not rely on the pan detector.

IMPORTANT SAFETY INSTRUCTIONS

This is the danger symbol, regarding safety, warning of potential risks to users and others.

All safety messages will be preceded by the danger symbol and the following words:

DANGER Indicates a hazardous situation which, if not avoided, will result in serious

injury.

WARNING Indicates a hazardous situation which, if not avoided, could cause serious

injury.

ENGLISH Installation Page 2 Instructions for use Page

EN12

Disposal of packing

The packing material is 100% recyclable and marked with the recycling symbol ( ). The various parts of the packing must not be dispersed in the environment, but

disposed of in compliance with local regulations.

Disposal

This appliance is marked in conformity with European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE).

By ensuring that this appliance is correctly disposed of, the user can help prevent potentially negative consequences for the environment and health.

The symbol on the appliance or the accompanying documentation indicates that this product should not be treated as domestic waste but must be taken to an

appropriate collection point for recycling WEEE.

Energy saving

For optimum results, it is advisable to:

• Use pots and pans with bottom width equal to that of the cooking zone.

• Only use flat-bottomed pots and pans.

• When possible, keep pot lids on during cooking.

• Use a pressure cooker to to save even more energy and time.

• Place the pot in the middle of the cooking zone marked on the hob.

- This appliance, intended to come into contact with food products, complies with Regulation ( ) no. 1935/2004, and has been designed, manufactured and

marketed in conformity with the safety requirements of “Low Voltage” Directive 2006/95/EC (replacing 73/23/EEC as amended) and protection requirements of

“EMC” Directive 2004/108/EC.

Use a magnet to check if the pot is suitable for the induction hob: pots and pans are unsuitable if not magnetically detectable.

- Make sure pots have a smooth bottom, otherwise they could scratch the hob. Check dishes.

- Never place hot pots or pans on the surface of the hob’s control panel. This could result in damage.

SAFEGUARDING THE ENVIRONMENT

DECLARATION OF CONFORMITY

BEFORE USE

IMPORTANT: The cooking zones will not switch on if pots are not the right size. Only use pots bearing the symbol “INDUCTION SYSTEM” (Figure

opposite). Place the pot on the required cooking zone before switching the hob on.

EXISTING POTS AND PANS

RECOMMENDED POT BOTTOM WIDTHS

NOOK

28 cm

17 cm 28 cm

21 cm

15 cm 21 cm

18 cm

14,5 cm

16 cm

12 cm 18 cm

10 cm 14,5 cm

16 cm

12 cm

23 cm

18 cm

Max. Min.

18 x 23 cm

EN13

After unpacking the product, check for any damage during transport. In case of problems, contact the dealer or the After-Sales Service.

PREPARING THE CABINET FOR FITTING

Electrical connections

Important!

•Electrical connection must be made before connecting the oven to the

electricity supply.

•The appliance must be earthed.

•For electrical connection, refer exclusively to the instructions given in the

following paragraph, ignoring the connections indicated on the underside of

the hob.

Connecting the cable to the terminal block

1. Remove the terminal block screws and the jumpers.

2. Connect the wires to the terminal block as shown in the wiring diagram below.

3. Secure the cable with the cable clamp next to the protective black sheath.

4. Remove the terminal block cover (A), undoing the screw and inserting the

cover in the terminal block hinge (B). Close the cover (C) and screw it on the

terminal block.

Connection to the oven

WARNING

Do not connect the oven to the power supply before you have

finished connecting the cooktop.

•Before connecting the oven to the power supply, make sure that the cooktop

is among the ones listed in the cooktop/oven pairing product sheet provided.

•Connect the hob connectors (E) to the oven connectors (D), matching the

colours and the alignment of the housing guides visible on the top of the

connectors.

•Then make the connection by pushing the connectors all the way in, making

sure that the tongue clicks into place.

•Unscrew the nut of the earth screw (K) on the top cover of the oven and

insert the yellow/green earth wire, leaving the washer in place. Screw the nut

back onto the screw and tighten it as far as it will go.

•Cover the connected cables (H) with the metal cover (F), taking care that the

cables are not trapped under the cover.

•Tighten the two screws (G) to secure the metal cover provided with the oven.

INSTALLATION

WARNING - The lower part of the product must not be accessible after installation.

- In case of installation of an undertop oven, do not interpose the separator panel.

• In order to ensure the correct operation of the product, do not obstruct the minimum required clearance between the hob and the top of the unit (min. 5 mm).