Chief SLM215 Bruksanvisning
Chief
Projektor tillbehör
SLM215
Läs nedan 📖 manual på svenska för Chief SLM215 (1 sidor) i kategorin Projektor tillbehör. Denna guide var användbar för 4 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare
Sida 1/1
I N S T A L L A T I O N I N S T R U C T I O N S
Milestone AV Technologies, Inc., and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone
makes no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation
or use of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, ex-
pressed or implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this
document.
© 2008 Chief Manufacturing, 8401 Eagle Creek Parkway, Savage, MN 55378
• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918
8850-000145 Rev.A
3/17/08
SLB-215 and SLM-215 Interface Brackets
for Sharp XV-Z90U, Sharp Vision Theago DT-200
SLB and SLM series Interface brackets are designed for use with Chief RPA, RPM, and Smart-Lift series projector mounts. See the specific
installation instructions provided with the mount for additional installation information.
Unpack carton and verify kit contents. If any listed parts are missing, immediately contact a Chief Customer Service representative by calling
1-800-582-6480.
WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer!
Installation:
WARNING: OVERTIGHTENING OF SCREWS CAN DAMAGE PARTS AND LEAD TO SERIOUS PERSONAL INJURY AND DAMAGE
TO EQUIPMENT! DO NOT over tighten screws when installing interface brackets.
NOTE: Step 1 is only required when installing an SLB Interface bracket. If an SLM bracket is being installed proceed to step 2.
1. Screw four thumb screws onto four 10-24 x 5/8" Philips pan head screws. DO NOT fully tighten thumb screws at this time.
2. Turn projector upside down on a flat surface.
3. Place the interface bracket onto the bottom of the projector lining up the four mounting holes in the bracket with the four threaded inserts
in the bottom of the projector.
4. Using the four M4 X 10mm mounting screws, start them into the mounting holes by hand and secure all four fasteners at this time.
NOTE: Security screws can be substituted when mounting Interface bracket to projector by using the parts and installation instructions in the
All-Points Security Kit.
(1) Interface Bracket (4) Washer, Flat, M4
(4) 10-24 Thumb Nuts ** (4) Screw, Pan head, M4 x 10mm
(1) All-Points Security Kit
**Only used when installing SLB Interface brackets.
SLB-215
SLM-215
Towards front of
Towards front of
Projector
Projector
Produktspecifikationer
Varumärke: | Chief |
Kategori: | Projektor tillbehör |
Modell: | SLM215 |
Behöver du hjälp?
Om du behöver hjälp med Chief SLM215 ställ en fråga nedan och andra användare kommer att svara dig
Projektor tillbehör Chief Manualer
1 Januari 2025
1 Januari 2025
1 Januari 2025
1 Januari 2025
1 Januari 2025
1 Januari 2025
1 Januari 2025
1 Januari 2025
1 Januari 2025
1 Januari 2025
Projektor tillbehör Manualer
- Projektor tillbehör Sony
- Projektor tillbehör Panasonic
- Projektor tillbehör BenQ
- Projektor tillbehör Manhattan
- Projektor tillbehör Optoma
- Projektor tillbehör Vision
- Projektor tillbehör Sanyo
- Projektor tillbehör Nec
- Projektor tillbehör Da-Lite
- Projektor tillbehör Barco
- Projektor tillbehör Sanus
- Projektor tillbehör Peerless-AV
- Projektor tillbehör Vogels
- Projektor tillbehör Auna
- Projektor tillbehör Viewsonic
- Projektor tillbehör Omnitronic
- Projektor tillbehör Newstar
- Projektor tillbehör Peerless
- Projektor tillbehör Chipolino
- Projektor tillbehör Gabor
- Projektor tillbehör Konig & Meyer
- Projektor tillbehör XGIMI
- Projektor tillbehör Speaka
- Projektor tillbehör Tempest
- Projektor tillbehör Premier Mounts
- Projektor tillbehör Gravity
- Projektor tillbehör Elite Screens
- Projektor tillbehör Kingpin Screens
- Projektor tillbehör Kanto
- Projektor tillbehör V7
- Projektor tillbehör Christie
- Projektor tillbehör Lindy
- Projektor tillbehör Unicol
- Projektor tillbehör Roadinger
- Projektor tillbehör My Wall
- Projektor tillbehör Smart Media
- Projektor tillbehör NeoMounts
- Projektor tillbehör SMK-Link
Nyaste Projektor tillbehör Manualer
10 Januari 2025
7 Januari 2025
27 December 2024
27 December 2024
23 December 2024
23 December 2024
23 December 2024
20 December 2024
20 December 2024
20 December 2024