Chief SSM133 Bruksanvisning

Chief Projektor tillbehör SSM133

Läs nedan 📖 manual på svenska för Chief SSM133 (1 sidor) i kategorin Projektor tillbehör. Denna guide var användbar för 12 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/1

I N S T A L L A T I O N I N S T R U C T I O N S

Milestone AV Technologies, and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes

no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use

of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or

implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.

Chief Manufacturing, a products division of Milestone AV Technologies

8401 Eagle Creek Parkway, Savage, MN 55378

• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918

8850-000122 Rev01

a Duchossois Group Company

05/09

SSB-133, SSM-133, SLB-133 and SLM-133 Interface Brackets

SSB-133, SSM-133, SLB-133 and SLM-133 Interface Brackets are designed for use with Chief® Series Projector Mounts. See the specific

installation instructions provided with the mount for additional installation information.

Unpack carton and verify kit contents. If any listed parts are missing, immediately contact a Chief Customer Service representative.

WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND

DAMAGE TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer!

Installation Instructions

WARNING: OVER TIGHTENING OF SCREWS CAN DAMAGE PARTS AND CAN LEAD TO SERIOUS PERSONAL INJURY AND

DAMAGE TO EQUIPMENT! DO NOT over tighten screws when installing interface bracket.

NOTE: Step 1 is only required when installing an SLB/SSB interface bracket. If an SLM/SSM bracket is being installed, proceed to step 2.

1. Screw thumb screws onto 10-24 x 5/8" Phillips pan head screws. DO NOT fully tighten thumb screws at this time.

2. Turn projector upside down on a flat surface.

3. Place 1/4" spacers over front threaded inserts and the 1/2" spacers over the rear threaded inserts in bottom of projector.

4. Place interface bracket onto projector bottom and align the mounting holes in bracket with threaded inserts in projector.

5. Using M4 x 12mm Phillips flat head screws and M4 x 20mm Phillips flat head screws, secure interface bracket to projector and tighten all

fasteners at this time.

NOTE: Security screws can be substituted when mounting interface bracket to projector by using the parts and installation

instructions in the All-Points Security Kit.

(1) Interface Bracket (2) Screw, Phillips Flat Head, Machine, M4 x 12mm ****

(4) 10-24 Thumb Nuts ** (2) Screw, Phillips Flat Head, Machine, M4 x 20mm ****

(1) All-Points Security Kit (2) 1/2" x .194" x 1/2" Round Spacer ****

(2) 1/2" x .218" x 1/4" Round Spacer ****

**Only used when installing SLB/SSB interface brackets. ****Used when mounting surface of projector is recessed.

NOTE: Specific to SSB-style and SSM-style interface bracket installation, all appropriate screws come pre-installed as reflected in the

encircled locations above. DO NOT attempt to substitute and USE ONLY this pre-installed hardware for SSB-style and SSM-style

interface bracket installation.

SLB-133 SLM-133

(

)

(

Note: SSB-style interface

)

Towards front of

projector

Towards front of

projector

Produktspecifikationer

Varumärke:	Chief
Kategori:	Projektor tillbehör
Modell:	SSM133
Höjd:	755.6 mm
Höjd (min):	647.7 mm
Certifiering:	NSF
siffra:	1
Hopfällbar:	Nee
Stapelbar:	Nee
Antal ben/ben:	4 poot/poten
Typ av stol:	Harde stoel
Färg på sätet:	Zilver
Sitsmaterial:	Roestvrijstaal
Färg på benen:	Zilver
Material ben:	Staal
Sitsens-diameter:	355.6 mm