Cisco Aironet 2600i Bruksanvisning

Cisco Åtkomstpunkt Aironet 2600i

Läs nedan 📖 manual på svenska för Cisco Aironet 2600i (40 sidor) i kategorin Åtkomstpunkt. Denna guide var användbar för 13 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF
Sida 1/40
G ETTING S GTARTED UIDE
Cisco Aironet 2600 Series Access Points
July, 2012
P/N: 78-20842-01
1About this Guide
2Introduction to the Access Point
3Safety Instructions
4Unpacking
5Configurations
6Access Point Ports and Connectors
7Configuring the Access Point
8Mounting the Access Point
9Deploying the Access Point on the Wireless Network
10 Troubleshooting
11 Declarations of Conformity and Regulatory Information
12 Configuring DHCP Option 43 and DHCP Option 60
13 Access Point Specifications
2
1 About this Guide
This Guide provides instructions on how to install and configure your Cisco Aironet 2600 Series
Access Point. The 2600 Series Access Point is referred to as the 2600 series or the access point in this
document.
2 Introduction to the Access Point
The 2600 series supports high-performing Spectrum Intelligence which sustains three spatial stream
rates over a deployable distance with high reliability when serving clients. The 2600 series provides
high reliability and overall wireless performance.
The 2600 series offers dual-band radios (2.4 GHz and 5 GHz) with integrated and external antenna
options. The access points support full inter-operability with leading 802.11n clients, and support a
mixed deployment with other access points and controllers.
The 2600 series access point is available in both controller-based (Unified) and standalone
(Autonomous) configurations and supports:
•Simultaneous single-band or dual-band (2.4 GHz/5 GHz) radios
•Integrated antennas on 2602I access point models (AIR-CAP2602I-x-K9)
•External antennas for rugged 2602E access point models (AIR-CAP2602E-x-K9)
Note The ‘x’ in the model numbers represents the regulatory domain. Refer to “Regulatory
Domains” section on page 6 for a list of supported regulatory domains.
The features of the 2600 series are:
•Processing sub-systems (including CPUs and memory) and radio hardware which supports:
–
Network management
–
CleanAir—Automatic detection, classification, location and mitigation of RF interference
(not available on autonomous or standalone models)
–
ClientLink 2.0—BeamForming to 802.11n clients as well as legacy 802.11a/g OFDM clients
–
VideoStream
–
Location
–
WIDS/WIPS
–
Security
–
Radio Resource Management (RRM)
–
Rogue detection
3
–
Management Frame Protection (MFP)
–
Throughput, forwarding, and filtering performance scaled to meet 3 spatial stream, 450 Mbps
data-rates
•32 MB flash size
•802.11af/at
–
CDP (Cisco Discovery Protocol)
•2.4 GHz and 5 GHz 802.11n radios with the following features:
–
3TX x 4RX
–
3-spatial streams, 450 Mbps PHY rate
–
Spectrum intelligence
–
DPD (Digital Pre-Distortion) technology
–
Cisco Vector Beamforming—Implicit Co-phase beamforming for .11ag clients and 1
spatial-stream and 2 spatial-stream clients
–
Radio hardware is capable of explicit compressed beamforming (ECBF) per 802.11n standard
3 Safety Instructions
Translated versions of the following safety warnings are provided in the translated safety warnings
document that is shipped with your access point. The translated warnings are also in the Translated
Safety Warnings for Cisco Aironet Access Points, which is available on Cisco.com.
Warning
IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury.
Before you work on any equipment, be aware of the hazards involved with electrical
circuitry and be familiar with standard practices for preventing accidents. Use the
statement number provided at the end of each warning to locate its translation in the
translated safety warnings that accompanied this device.
Statement 1071
SAVE THESE INSTRUCTIONS
Warning
Read the installation instructions before you connect the system to its power source.
Statement 1004

Produktspecifikationer

Varumärke: Cisco
Kategori: Åtkomstpunkt
Modell: Aironet 2600i

Behöver du hjälp?

Om du behöver hjälp med Cisco Aironet 2600i ställ en fråga nedan och andra användare kommer att svara dig


Åtkomstpunkt Cisco Manualer

Cisco

Cisco Aironet 3600i Bruksanvisning

18 Oktober 2024
Cisco

Cisco Aironet 3600e Bruksanvisning

18 Oktober 2024
Cisco

Cisco MR12 Bruksanvisning

14 Oktober 2024
Cisco

Cisco Aironet 3700P Bruksanvisning

11 Oktober 2024
Cisco

Cisco 541N Bruksanvisning

9 Oktober 2024
Cisco

Cisco Aironet 1815m Bruksanvisning

8 Oktober 2024
Cisco

Cisco AIR-CAP702I-I-K9 Bruksanvisning

4 Oktober 2024
Cisco

Cisco Aironet 1142N Bruksanvisning

27 September 2024
Cisco

Cisco Meraki MR74 Bruksanvisning

21 September 2024
Cisco

Cisco Meraki MR72 Bruksanvisning

19 September 2024

Åtkomstpunkt Manualer

Nyaste Åtkomstpunkt Manualer

Comtrend

Comtrend WAP-PC1750W Bruksanvisning

26 Oktober 2024
Allied Telesis

Allied Telesis AT-TQm5403 Bruksanvisning

26 Oktober 2024
Hawking Technologies

Hawking Technologies HW17ACM Bruksanvisning

26 Oktober 2024
Trendnet

Trendnet TEW-738APBO Bruksanvisning

18 Oktober 2024
Draytek

Draytek VigorAP 920R Bruksanvisning

13 Oktober 2024
Netgear

Netgear WNDAP360 Bruksanvisning

12 Oktober 2024
Engenius

Engenius ENS1200 Bruksanvisning

5 Oktober 2024
TP Link

TP Link Festa F65-Wall Bruksanvisning

4 Oktober 2024
TP Link

TP Link EAP110-Outdoor V3 Bruksanvisning

1 Oktober 2024
Fortinet

Fortinet FortiAP 24D Bruksanvisning

30 September 2024