Citizen Cal 3741 Bruksanvisning

Citizen Titta Cal 3741

Läs nedan 📖 manual på svenska för Citizen Cal 3741 (9 sidor) i kategorin Titta. Denna guide var användbar för 8 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/9

CITIZEN QUARTZ

ANALOG DEPTH METER

WITH CHRONOGRAPH

Model No. AY5XXX

Cal. No. 374

• INSTRUCTION MANUAL

CTZ-B6757

This watch is an analog (hand) display diver’s

watch equipped with an electronic depth meter.

The familiar watch-face format is convenient to

confirm depths while diving. Further, a

chronograph function finds uses in a variety of

activities beside diving. (Please note that the

depth meter function should be used only as an

auxiliary instrument).

“Highly reliable water resistant for use at depths

of up to 200 metres”

The high-reliability water resistant conforms to ISO

standards for diving watches.

* ISO diving watch standards are those set forth by

the International Organisation For Standardisation.

Two models of this watch are available:

one with depth readings indicated in metres (m),

the other with readings indicated in feet (ft).

Diving with this watch

WARNING:

Diving can be a safe, enjoyable activity when

diving rules are properly followed. It is always,

however, accompanied by certain risks

including diver’s paralysis and unanticipated

accidents. Before diving please obtain proper

diving instruction and be sure to conduct

safety checks. Please use this watch only after

you have read and fully understand the

operating procedures and cautions in these

instructions. Using this watch other than as

indicated in these instructions may result in

failure of the watch to function properly.

Please refer to the diagram on the left when

reading this instruction manual.

*Never manipulate the crown or press the buttons

during a dive.

This illustration shows a watch using meters to

indicate depth readings.

All repairs of this product, including battery

replacement, should be conducted at a

Citizen Service Centre. For repairs and

inspections please contact the place of purchase

or contact a Citizen Service Centre directly.

[Safe Diving]

1. Use this product only after having received

proper instruction in safe diving procedures.

2. Always use the “buddy system”. This watch is

not a substitute for a diving partner.

3. This product is recommended for sports diving

to depths of up to about 30 metres (100ft),

although the depth indicator will measure depths

up to 50 metres (125ft).

4. Early battery replacement is recommended. A new

battery will last approximately 2 years. (However,

this will vary greatly depending on the frequency

of depth meter used. Replace the battery early.)

*Battery replacement should be conducted

only at the Citizen Service Centres.

5. Be sure to rest sufficiently after diving, as

specified by diving rules. Riding in an airplane

or moving to a high altitude too soon after diving

may cause decompression sickness.

6. Use the depth meter function of this watch only

as an auxiliary or back up instrument.

7. Avoid rapid ascents when diving, as these

adversely affect the human body, including

causing diver’s paralysis. Maintain a safe ascent

speed while diving. An ascent of 10 metres (33ft)

or less per minute is recommended for sports

diving to avoid various possible problems.

[Do not use the depth meter when...]

1. In locations of altitudes exceeding 4,000 metres

(13,124 ft).

2. In temperatures outside of the warranted

temperature range. The warranted temperature

range for the depth meter in this watch is from

10C to 40C/50F to 104F.

3. In potentially dangerous activities or conditions.

This watch is not designed for use in maritime

emergencies or to prevent sea disasters and the

like.

4. A substitute for a pressure gauge is needed.

This watch is not designed to gauge pressures

other than those associated with water depth.

5. Diving using a helium enriched environment.

This watch cannot be used in a helium enriched

environment, as this may cause malfunction or

breakage.

CAUTION

Operating instructions

This watch has three modes: Time Mode, Diving

Mode and Chronograph Mode.

[Name of Parts]

[Switching modes]

Switch between the three modes simply by pressing

button 1 .

Time Mode

Switch to the Time Mode from the Diving Mode by

pressing button 1continuously for 2 seconds.

Switch to the Time Mode from the Chronograph

Mode by pressing button 1once.

About the Time Mode 1. The Time Mode displays

both 12 and 24 hour

time.

2. With the exception of the

second hand, the time

may be read even while

using the other modes.

Display in the Time Mode

Please refer to the fold-out watch diagram located

on the opening page of this manual.

A – Points to Exit

B – Points to 0

C – Minute hand

E – Hour hand

F – Second hand

G – 24-hour time hand

[Setting the time and date]

Make sure that the watch is in the Time Mode by

confirming that the function hand A is pointing to

EXIT.

1. Unscrew the crown in the indicated direction to

release it, and pull it out two steps. The second

hand F will spin rapidly and stop at 0.

2. Set the hours and minutes by turning the crown.

Check the 24-hour time hand to confirm whether

the hands are set appropriately to AM or PM.

3. Push the crown back to its original position.

4. Hold the crown down and turn it to screw lock it

back it place.

1. Unscrew the crown in the indicated direction to

release it, and pull it out one step.

2. Set the date by turning crown. (If the crown is

turned in the wrong direction there will be no effect.)

3. Push the crown back to its original position.

4. Hold the crown down and turn it to screw lock it

back in place.

* Setting the date between the hours of 9 pm and

5 am may result in the date not changing by the

next day.

* Do not attempt to set the time or date when in a

mode other than the Time Mode.

Diving Mode From the Time Mode, or

Chronograph Mode, switch to the

Diving Mode by pressing button

1continuously for 2 seconds.

[Stop using this product while diving when...]

1. The low-battery warning indicator approaches

the end of its life, the display switches

automatically from the depth meter display to

the time display, and the second hand begins

to move in 2-second increments.

2. The watch’s depth readings differ greatly from

those of other depth measuring instruments.

3. The watch stops or exhibits any abnormal

functioning. (Avoid knocking the watch against

diving equipment, rocks or other hard objects.)

* Service for this watch should be conducted

only by Citizen Service Centres.

About the screw lock

1. Always return the crown to its original position

and lock it when finished setting the watch.

2. Do not press any of the buttons while the crown

is pulled out. Doing so may cause a mode

change and disturb the position of the hands.

3. Do not pull out or turn the crown when it is

wet. Doing so may allow water to seep inside

the watch and cause malfunction.

About depth readings

1. After switching to the Diving Mode, depth readings

will commence automatically when diving begins.

2. The depth will be measured and displayed in

1 metre (2.5ft) increments up to 50 metres (125ft).

Display in the Diving Mode

Please refer to the fold-out watch diagram located

on the opening page of this manual.

A – Depth indicator hand (function hand)

B – Points to DV

C – Minute hand

E – Hour hand

G – 24-hour time hand

F – Second hand

*If the hands A, B do not point to the correct position,

please readjust them according to the “ALL RESET”

instructions.

Reading the Depth

While diving, the number indicated by the depth

indicator hand A (the function hand) is the present

diving depth. The depth indicator hand begins to

function at a depth of 1 metre (2.5ft). It registers

depths of less than 1 metre (2.5ft) as 0. At depths of

over 50 metres (125ft), the hand stops on the over

Zone Mark (53 minutes) and remains there until

returning to depths less than 50 metres (125ft).

Measurements and Range

Display range: 0m (0ft) to 50m (125ft)

Display increment: 1 metre (2.5ft)

Measurement internal: Once/second

[Maximum depth memo function]

This watch automatically records the maximum

depth reached during a dive (in 1 metre (2.5ft)

increments). This memo is retained until the watch

is set to the Diving Mode again of 1 metre (2.5ft) or

more is reached.

Calling the maximum depth memo

1. While in the Time Mode or Diving

Mode (a depth of 0 is displayed)

press button 2. The function hand A

will display the maximum depth.

2. Pressing button 2a second time or leaving the

memo displayed continuously for 30 seconds will

release the maximum depth memo display.

Note:

1. A depth less than 1 metre (2.5ft) is not recorded.

2. The data in the maximum depth memo will be

cleared when the battery reaches the end of its life.

Be sure to record necessary memo information in

a log book.

3. The first time this function is used, it may display

data that was used in product testing.

4. Depths over 50 metres (125ft) will be recorded as

the Over Zone Mark.

Additional functions

The watch automatically returns to the Time Mode

if the function hand remains at 0 metre (0ft) for

longer than 30 minutes in the Diving Mode.

If the depth meter is functioning abnormally for

some reason, the function hand will point to the

Over Zone Mark when the watch is switched to

the Diving Mode, and depth measurement will

not be possible. In such a case, switch back to

the Time Mode.

[Making accurate depth readings]

1. Switch the watch to the Diving Mode shortly

before diving.

2. When there is a great difference between the

air and temperature, immerse the watch in the

water for 2-3 minutes before switching it to the

diving mode.

3. Confirm that the mode hand points to the DV

and the function hand points to 0 when the

watch is switched to the Diving Mode. If the

hands are in the wrong position please refer to

ALL RESET on page 23.

4. Avoid too rapid descents and ascents when

diving. The function hand will not adjust quickly

enough during descents or ascents faster than

about 1 metre (2.5ft) per minute. Slowdown or

stop in order to obtain an accurate depth

reading.

*Never pull out or turn the crown or press the

buttons while diving. Doing so may cause

water to penetrate the case.

[High altitude and freshwater diving]

When the Diving Mode is activated, the depth is

calibrated at 0 metre (0ft) based on the

surrounding air pressure. This enables the watch

to be used while diving at high-altitudes and/or in

lakes, as long as the Diving Mode is activated, at

that altitude.

However, an accurate measurement is not

possible at altitudes over 4,000 metres (13,124ft).

Do not use this watch when diving in such places.

Further, this watch displays changes in depth

based on a standard of seawater (density 1.025).

Depths indicated in fresh water will actually be

about 2.5% over indicated.

Be sure to complete appropriate safety training

before in fresh water or at high altitudes.

(Example) 20 metres (50ft) (indicated depth) x

1.025 = 20.5 metres (51.25ft) (actual depth).

Produktspecifikationer

Varumärke:	Citizen
Kategori:	Titta
Modell:	Cal 3741

Behöver du hjälp?

Om du behöver hjälp med Citizen Cal 3741 ställ en fråga nedan och andra användare kommer att svara dig

Ditt namn*

Din e-post*

Skriv din fråga här

Titta Citizen Manualer

Citizen Cal 411X Bruksanvisning

6 Oktober 2024

Citizen CAL U700 Bruksanvisning

5 Oktober 2024

Citizen CAL 4633 Bruksanvisning

5 Oktober 2024

Citizen CAL B800 Bruksanvisning

4 Oktober 2024

Citizen CAL 5513 Bruksanvisning

30 September 2024

Citizen Modern CA4582-54E Bruksanvisning

24 September 2024

Citizen Classic 8700 BL8160-07X Bruksanvisning

24 September 2024

Citizen CAL 9510 Bruksanvisning

24 September 2024

Citizen CAL B470 Bruksanvisning

24 September 2024

Citizen CAL H461 Bruksanvisning

23 September 2024

Titta Manualer

Nyaste Titta Manualer

Lorus W207 Bruksanvisning

27 Oktober 2024

Invicta Specialty 31308 Bruksanvisning

27 Oktober 2024

Timex Ironman TW5M244009J Bruksanvisning

26 Oktober 2024

Timex MK1 TW2R68800VQ Bruksanvisning

26 Oktober 2024

Casio Edifice EQB-1000TR-2AER Bruksanvisning

24 Oktober 2024

Casio Collection MTP-1259PD-7BEF Bruksanvisning

24 Oktober 2024

Casio G-Shock GA-810B-1A9ER Bruksanvisning

24 Oktober 2024

Casio Collection SGW-450HD-1BER Bruksanvisning

24 Oktober 2024

Casio Edifice EQB-1000XD-1AER Bruksanvisning

24 Oktober 2024

Casio Collection MTP-1222A-2AVEF Bruksanvisning

24 Oktober 2024