Dual MGH37BT Bruksanvisning

Dual Radio MGH37BT

Läs nedan 📖 manual på svenska för Dual MGH37BT (22 sidor) i kategorin Radio. Denna guide var användbar för 15 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/22

MGH37BT

INSTALLATION/OWNER'S MANUAL

AM/FM Gauge Hole Receiver

Front and Rear Inputs

MGH37BT OPERATION

Mounting

Please read entire manual before installation.

Before You Start

• Disconnect negative battery terminal. Consult a qualified technician for instructions.

• Avoid installing the unit where it would be subject to high temperatures, such as from

direct sunlight, or where it would be subject to dust, dirt or excessive vibration.

Getting Started

• Once a suitable location has been determined, drill the hole and secure the stereo

using the metal mounting bracket. If the bracket needs to be shortened, remove the

appropriate number of breakaway segments using a pair of pliers.

Fuse:

When replacing the fuse, make sure

new fuse is the correct type and

amperage. Using an incorrect fuse

could damage the radio.

Tip:

When a suitable ground wire is

not present in the vehicle wiring

harness, connect the black ground

wire to the vehicle chassis.

Break Lines

Color Connection

Red 12V Ignition / Accessory

Black Ground

Blue Remote Turn-on B (+)

Grey Right Front (+)

Grey/Black Right Front (-)

White Left Front (+)

White/Black Left Front (-)

Violet Right Rear (+)

Violet/Black Right Rear (-)

Green Left Rear (+)

Green/Black Left Rear (-)

Yellow Camera Input (RCA)

MGH37BT OPERATION

Installation

Mounting the Radio

1. Choose a mounting location on the dash board or instrument panel that will

allow room behind to run radio cables to the power source. Consider how you will use

the AUX IN, LINE OUT and USB connectors and route the appropriate extension cables

to an accessible area.

2. Cut a hole in the dash board using the template provided in the back of this manual. At

least 3 3/4” depth is needed to mount the radio.

IMPORTANT! Do not mount this unit where it can be submerged in water.

3. Slide the included spring washers (B) over the screw posts (A) and attach the screw

posts to the back of the radio.

4. Place the radio in front of the dashboard opening so the wiring can be brought through

the opening.

5. After completing the wiring connections, turn the radio on to confirm operation (vehicle

accessory switch must be on). If the radio does not operate, recheck all wiring until the

problem is corrected. Once proper operation is achieved, turn the accessory switch off

and proceed with final mounting of the radio. Refer to the “Wiring Diagram” on page 5.

NOTE: Before final installation, test the wiring connections to make sure the unit is con-

nected properly and the system works.

6. Insert the radio into the mounting hole.

7. Place the “U” bracket (C) over the screw posts and secure the radio to the dash using

the included hex nuts (D). If necessary, cut the score marks (E) on either side of the

mounting bracket to custom fit the bracket length for your application. See Figure A.

3 Inch Hole

Produktspecifikationer

Varumärke:	Dual
Kategori:	Radio
Modell:	MGH37BT
Färg på produkten:	Grey, White
Vikt:	4500 g
Sladdlängd:	6 m
Ljudnivå:	- dB
Årlig-energiförbrukning:	- kWu
Snäll:	Cilinderstofzuiger
Luftfiltrering av dammsugare:	HEPA
Räckvidd:	9 m
Smutsavskiljningsmetod:	Filtrerend
Typ av rengöring:	Droog
Dammkapacitet:	1.8 l
Maximal ineffekt:	700 W
Typ av dammsugare:	Zakloos
Typ av rör:	Telescopisch
Förvaring/förvaringsfäste:	Ja
Bärhandtag:	Ja
Indikator för full dammbehållare:	Ja
Antal fartyg:	1
Korrekt användning:	Thuis
Rengör ytor:	Carpet, Hard floor
Spaltverktyg:	Ja
Motorskyddsfilter:	Ja
AC-ingångsspänning:	220 - 240 V
AC-ingångsfrekvens:	50 - 60 Hz