Electrolux EFG513 Bruksanvisning

Electrolux Fläktkåpa EFG513

Läs nedan 📖 manual på svenska för Electrolux EFG513 (11 sidor) i kategorin Fläktkåpa. Denna guide var användbar för 16 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/11

Operating instructions

Mode d'emploi

Bedienungsanleitung

Gebruiksaanwijzing

Istruzioni per l'uso

Part 1 INSTALLATION

INSTRUCTIONS

1 - GENERAL INFORMATION

This built-in group is especially designed to

be fitted inside a decorative canopy. Featuring

a very powerful fan unit this appliance allows

the decorative canopy not only to look

attractive but also to be very good in perform-

ance. Thanks to the pyramid shape and the

compact size, this group can be easily fitted in

slim lined canopies.

To ensure a satisfying use from this appliance

we recommend to comply with the installa-

tion and operating instructions carefully.

2 - COMPONENTS

The appliance is made up of the following

components (fig. 1):

-N. 1 cooker hood C

-N. 1 evacuation spigot R

3 - SAFETY WARNINGS

3.1 - When used in the extraction mode the

cooker hood ducting must not be connected

to a central heating flue (radiators or water

heaters). In connection with the discharge

of exhaust air, the requirements of the

authorities concerned have to be observed.

3.2 - Before connection to the mains supply

make sure that the mains voltage corres-

ponds with the voltage on the rating plate.

3.3 - Connect the hood to the mains supply via

a double pole switch which has 3mm clear-

ance between the contacts.

3.4 - This appliance must be earthed.

3.5 - When installed, the hood must be posi-

tioned at least 65 cm above a cooking

appliance.

3.6 - Never do flambé cooking under this coo-

ker hood.

3.7 - Never leave frying pans unattended dur-

ing use as overheated fat and oil may catch

fire.

3.8 - Before carrying out any kind of mainte-

nance or cleaning, disconnect the hood

from the mains supply.

3.9 - If the room where the cooker hood is to

be used contains a fuel burning appliance

such as a central heating boiler then this

must be of the room sealed or balanced

flue type. If other types of flue or appli-

ance are fitted ensure that there is an

adequate supply of air to the room.

4 - INSTALLATION

This hood is supplied with specially designed

butterfly type fixing brackets S (fig. 1) and

can be installed following these instructions:

4.1 - Fitting the group inside a decorative

canopy

1 - Cut a rectangular hole into the underside

of the canopy in accordance with the table

below leaving 15 mm from the lateral and

back edges of the canopy (fig. 2):

2 - Cut a hole in the upper part of the ca-

nopy, where you prefer to have the air-out-

let, according to the diameter of the duct

and following the instructions of the table

below.

3 - Fix the ducting spigot R in the upper

part of the hood (see paragraph 4.3 1b).

4 - Insert the upper part of the hood through

the hole cut in the underside of the canopy

(ensuring that the butterfly catches S are

loose enough so that they spring open) and

hook onto the base of the canopy.

5 - Access to the securing screws in the but-

terfly brackets is through two holes in the

lower casing as illustrated in fig. 3. Turn the

screws clockwise until the hood is firmly

attached to the cabinet.

4.2 - Electrical connection

WARNING: THIS APPLIANCE

MUST BE EARTHED

1 - It is imperative that the safety measures

contained in paragraphs 3.2, 3.3, 3.4 are

strictly observed.

2 - Before connection to the mains supply

check that the circuitry is sound. After the

connection has been tested switch on the

Hood Measure A Measure B

540 mm 523 mm 333 mm

720 mm 703 mm 333 mm

DUCT MEASURE C

Ø 100 mm 105 mm

Ø 120 mm 125 mm

mains supply and check that the worktop

illumination lamp and three fan speeds func-

tion correctly.

4.3 - Ducting or recirculation fitting

1 - Ducting fitting:

a - The cooker hood can be ducted to the

outside using either a fire retardant rigid or

flexible ducting of 100 or 120 mm diameter.

The choice is left to the installer (fig. 4).

b - The ducting spigot R supplied has an air

outlet of 100 mm diameter. To adapt the

spigot to 120 mm diameter cut along the

slot as illustrated in fig. 5 using a sharp knife.

c - Connect the ducting spigot R to the

cooker hood by placing the spigot over the

rectangular outlet on the top of the upper

assembly and secure the spigot using two of

the screws provided as illustrated in fig. 6.

The ducting can now be connected to the

spigot A ensuring that an air tight sealed is

obtained.

d - If the hood is provided with the charcoal

filter fitted, the filter should be removed (see

paragraph 3.3 2 2nd Part).

2 - Recirculation fitting:

a - Fit the charcoal filter inside the hood

(see paragraph 3.3 2, 2nd Part).

b - Connect spigot R to the hole cut on top

of the canopy for the air outlet in the same

way as for the ducting fitting.

c - When the hood is installed in the recir-

culation mode, the air is recirculated into

the kitchen through a pipe connecting spigot

R to the upper part of the canopy (fig. 7).

Part 2 OPERATION AND

MAINTENANCE

INSTRUCTIONS

1 - SAFETY WARNINGS

It is most important that all the warnings

contained in paragraph 2 of the Installa-

tion instructions are strictly observed.

Moreover, special attention should be paid

to the following warnings appertaining to

the use and maintenance of the cooker hood.

1.1 - This appliance is designed to be operated

by adults.

1.2 - The grease filters and charcoal filters

should be cleaned or replaced as recom-

mended by the manufacturer or more

frequently if the hood is used consistently

for more than 4 hours per day.

1.3 - When using a gas hob in conjunction with

this cooker hood never leave the burners

of the hob uncovered while the hood is in

use, or when the pans have been remo-

ved. Switch off the gas when removing

the pan.

1.4 - Always ensure that the flame is kept at

the correct intensity to prevent the flame

from licking round from the bottom of

the pan; this will save energy and will

avoid a dangerous concentration of heat.

1.5 - This hood should be used for the purpose

for which it was designed; to remove

odours from cooking in the kitchen.

2 - OPERATION

2.1 - Functions

Controls are located on the lower part of the

appliance and control the power to the fan, the

worktop illumination and the speed of the fan.

2.2 - Controls

The cooker hood functions are controlled by

three slide switches as illustrated in fig. 8.

- Switch L controls the worktop illumination,

- Switch M controls the power to the fan mo-

tor,

- Switch V controls the fan speed

Position 1, low speed, should be selected

when simmering or using one pan; which

keeps the noise level at a minimum.

Position 2, medium speed, should be selected

for normal cooking. This speed offers the best

Produktspecifikationer

Varumärke:	Electrolux
Kategori:	Fläktkåpa
Modell:	EFG513
Färg på produkten:	Wit
Inbyggd display:	Ja
Vikt:	227 g
Bredd:	122 mm
Djup:	52 mm
Höjd:	118 mm
Kraftkälla:	Batterij/Accu
Anslutningsteknik:	Draadloos
Måttenhet temperatur:	F, °C
Batteri/Batterispänning:	1.5 V
Larmfunktion:	Ja
Indikation på lågt batteri:	Ja
Frekvens:	433 MHz
Klockfunktion:	Ja
Färgskärm:	Ja
Mätfunktioner:	Indoor hygrometer, Indoor thermometer, Outdoor hygrometer, Outdoor thermometer
Väderprognos:	Ja
Type beeldscherm:	LCD
Batterityp:	AAA
Antal batterier (mottagare):	3
Min/Max temperaturminne:	Ja
Fuktighetsmätområde (utomhus) (HH):	20 - 99 procent
Temperaturmätningsområde (utanför) (TT):	-20 - 50 °C
Antal batterier (sensor):	2
Fuktighetsmätområde (inomhus) (HH):	20 - 99 procent
Temperaturmätningsområde (inuti) (TT):	-10 - 50 °C
DCF radioklocka:	Ja
Utomhussensorområde:	30 m
Indikator för veckodag:	Ja
Månfas:	Nee