Fisher And Paykel OB60SD13PLX1 Bruksanvisning

Fisher And Paykel Ugn OB60SD13PLX1

Läs nedan 📖 manual på svenska för Fisher And Paykel OB60SD13PLX1 (12 sidor) i kategorin Ugn. Denna guide var användbar för 4 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/12

OB60SDPT models

BUILT-IN OVEN

INSTA L LA T I ON G UIDE

NZ AU G B I E

591 94 2B 0 6. 22

! WARNING!

Electric Shock Hazard

Failure to follow this advice may result in

electric shock or death.

• Before carrying out any work on the

electrical section of the appliance, it must

be disconnected from the mains electricity

supply.

• Connection to a good earth wiring system is

absolutely essential and mandatory.

• Alterations to the domestic wiring system

must only be made by a qualified electrician.

! WARNING!

Fire Hazard

Failure to follow this advice may result in

overheating, burning, and injury.

• Do not use adapters, reducers, or branching

devices to connect this appliance to the

mains power supply.

! WARNING!

Cut Hazard

Failure to use caution could result in injury.

• Take care: some edges are sharp.

IMPORTANT!

SAVE THESE INSTRUCTIONS

The models shown in this installation guide may not be available in all markets and are subject to

change at any time. For current details about model and specification availability in your country,

please go to our website www.fisherpaykel.com or contact your local Fisher & Paykel dealer.

WARNING!

To avoid hazard, follow these instructions carefully

before installing or using this appliance.

• Please make this information available to the person

installing the appliance—doing so could reduce your

installation costs.

• This appliance must be installed and connected to

the mains power supply only by a suitably qualified

person according to these installation instructions and

in compliance with any applicable local building and

electricity regulations. Failure to install the appliance

correctly could invalidate any warranty or liability claims.

• If the power supply cable is damaged, it must be

replaced by the manufacturer, its service agent or

similarly qualified person in order to avoid a hazard.

• Isolating switch: make sure this oven is connected to a

circuit which incorporates an isolating switch providing

full disconnection from the power supply in accordance

with the wiring rules.

• The oven must be earthed.

• Do not use adaptors, reducers or branching devices to

connect the oven to the mains electricity supply, as they

can cause overheating and burning.

• The appliance must not be installed behind a decorative

door in order to avoid overheating.

• Please take extra care not to damage the lower trim of

the oven during installation. The trim is important for

correct air circulation and allows the door to open and

close without obstruction. The manufacturer does not

accept any responsibility for damage resulting from

incorrect installation.

SAFETY AND WARNINGS

Screws (2) Metal side shelves

fixing nut (2)

Ensure that:

the countertop and oven cavity are square and level, and are the required dimensions

the installation will comply with all clearance requirements and applicable standards and regulations

the isolating switch will be easily accessible to the customer with the oven installed

the electrician provides sufficient free length of power supply cable to reach from the bottom rear of the cavity to at least 1.5 metres in front of the bottom edge of the opening

the cable may enter the cavity from the side, top or bottom, but top entry must be at the rear of the cavity

the oven connection socket (if fitted) is outside the cavity if the oven is flush to the rear wall

the oven will rest on a surface that can support its weight

the height from the floor suits the customer

you consult local building authorities and by-laws if in doubt regarding installation

IMPORTANT!

Some environmental factors and cooking habits can cause condensation in and around the oven during use. To protect surrounding cabinetry from possible damage caused by frequent or

excessive condensation, we recommend moisture-proofing the oven cavity.

zthe oven door can open fully without obstruction.

zthe power supply cable does not touch any hot metal parts.

zthe isolating switch is easily accessible to the customer with the oven installed.

zyou complete the ‘Final checklist’ at the end of the installation.

zIf, after following the instructions given, correct performance cannot be achieved, please contact your nearest Fisher & Paykel Authorised Service Centre, Customer Care, or contact us

through our local website listed at the end of this document.

PARTS SUPPLIED