Flymo H400 Bruksanvisning

Flymo Gräsklippare H400

Läs nedan 📖 manual på svenska för Flymo H400 (2 sidor) i kategorin Gräsklippare. Denna guide var användbar för 2 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/2

Original instructions

Please read the operating instructions carefully and observe the notes

given. Use these operating instructions to familiarise yourself with the

product, the proper use and the safety instructions.

For safety reasons, children and young people under the age of 16, as

well as people not familiar with these operating instructions, may not

use this product. Persons with reduced physical or mental abilities may

use the product only if they are supervised or instructed by a respon-

sible person. Children must be supervised to ensure that they do not

play with the product. Never operate the product when you are tired,

ill or under the influence of alcohol, drugs or medicine. Never operate

the machine while people, especially children, or pets are nearby.

v Keep these operating instructions in a safe place.

Intended use:

The FLYMO Cylinder Lawnmower has been designed for cutting lawn

and grass areas of private houses.

Compliance with these operating instructions provided by FLYMO is

a prerequisite for using the cylinder lawnmower correctly.

Please note: The cylinder lawnmower may not be used for cutting

climbing plants or grass on roofs, due to the danger of bodily

harm.

1. SAFETY

General safety instructions:

• While using your product always wear safety glasses.

• While using your product always wear substantial footwear and long

trousers. Do not operate the equipment when barefoot or wearing

open sandals.

• Do not use under wet conditions.

• Use the product only in daylight or good artificial light.

Checks before each operation:

Before use, an inspection is always to be performed In order to determine

that all nuts, bolts and working tools are not worn down or damaged.

Inspect the surface on which the lawnmower is to be used beforehand.

Stones, pieces of wood and wires as well as other solid matter are to be

removed.

Objects, which are contacted by the cutting tools, could be thrown out

uncontrollably.

Search hedges and bushes for hidden objects (e. g. wire fences and

hidden wires).

Thoroughly inspect the area where the lawnmower is to be used and

remove all objects which can be thrown by the lawnmower.

Proper use / Responsibility:

DANGER!

Take note that the rotating blade cylinder could cause

injuries.

v Never place your hands or feet on or under moving parts.

DANGER! Risk of injury!

Cut injury when the blade turns and it is damaged, bent,

out of balance or has chipped edges.

v Do not use the product when the blade is damaged, bent,

out of balance or has chipped edges.

v Do not regrind the blade.

Do not use the lawnmower while people, especially children, or animals

are nearby. The operator is liable for damages.

The safety distance between the blade cylinder and the operator that is

created by the guiding spar is to be always maintained.

When mowing embankments and slopes, special care must be taken:

v Make sure you always keep a safe distance and wear shoes with

anonslip sole. Always cut diagonally to the slope.

Take special care when moving backwards and when pulling the lawn-

mower. Danger of stumbling!

If the cutting tools or the lawnmower run into an obstruction and / or solid

objects, the lawnmower should be properly and thoroughly inspected.

v Only work when visibility is good.

Never leave the lawnmower unattended. If your work is interrupted, store

the mower in a safe place.

Warning! Keep toddlers away when you assemble the unit. Small parts can

be easily swallowed. There is also a risk that the polybag can suffocate

toddlers.

2. OPERATION

Mowing correctly:

To produce a well-maintained lawn we recommend cutting the lawn regu-

larly once a week if possible. The lawn becomes thicker if cut frequently.

Relatively long cut grass (> 1 cm) must be removed so that the lawn does

not become yellow and matted.

After relatively long intervals between mowing (e. g. ), first of all holiday

cut in one direction with the cutting height as high as possible (38 mm),

then cut in the crosswise direction at the cutting height required. The

blades of grass should not be more than 12 cm long if they are to be cut

with a cylinder mower.

If possible only cut the grass when it is dry. If the grass is damp, the

cutting pattern will be uneven.

Adjusting the cutting height:

The cutting height can be set to any position from 12 mm to 38 mm in

4steps.

1. Lay the mower onto the ground, so that it cannot fall over when adjust-

ing the cutting height.

2. Pull both height adjustment mechanisms and allow them to engage at

the required height on the scale.

The height adjustment mechanisms must always be set to the same height

on both sides.

CAUTION! The mower may only be adjusted to a depth in which

the lower blade does not touch the ground when it is uneven.

3. STORAGE

To put into storage:

v Clean cylinder mower before storage (see 4. MAINTENANCE) and

store in a dry place.

4. MAINTENANCE

Cleaning the mower:

DANGER!

Cutting mechanism can cause injuries!

v Wear suitable work gloves when undertaking maintenance.

CAUTION!

Damage to cylinder lawnmower!

v Never clean your cylinder lawnmower with running water,

in particular with water under high pressure.

Always keep the lawnmower clean and remove grass deposits.

Deposits affect the cutting result as well as discharge of grass clippings.

Residual dirt and grass is easily removed immediately after mowing.

1. Remove grass deposits with a brush and a cloth.

2. Oil the blade cylinder and the lower blade with thin oil

(e. g. sprayed oil).

5. TROUBLESHOOTING

DANGER!

Cutting mechanism can cause injuries!

v Wear suitable work gloves when rectifying faults.

20400-85.960.01.indd 1

20400-85.960.01.indd 120400-85.960.01.indd 1 02.03.22 10:42

02.03.22 10:42

02.03.22 10:4202.03.22 10:42

Problem Possible Cause Remedy

Abnormal noises Screws / components loose. v Tighten screws.

Foreign bodies on the blade. Remove foreign bodies.v

Notch in the blade. Remove notches with v

grindstone.

Blades are striking each other

too hard.

v Adjust cutting mechanism.

Lawn is not cleanly cut Blade adjustment incorrect. Adjust cutting mechanism.v

Blade blunt or damaged. Have the blade replaced by v

FLYMO Service.

Grass too long (e. g. after

a relatively long absence).

v Cut lawn shorter with

a sickle.

Adjusting the cutting mechanism:

The cutting gear of your cylinder mower was optimally adjusted before

leaving our company. If, after longer use, a clean cut of the grass is no

longer possible or the blade roller contacts the lower blade, then the

lower blade should be adjusted as follows:

1. Clean the cylinder mower.

2. Lay the mower onto the ground, so that it cannot fall over when

adjusting the cutting mechanism.

3. Check cylinder and lower blade for notches and remove these with

agrindstone if necessary.

4. Unscrew the left and right hexagon screws using a hexagon wrench

(10 mm) anticlockwise until the blade cylinder can only just turn freely.

5. Carefully tighten the left hexagon screw using a hexagon wrench

(10 mm) whilst the blade cylinder rotates, until it lightly contacts the

lower blade.

6. Then unscrew the left hexagon screw again until the blade cylinder

just stops contacting the lower blade (rotates soundlessly).

7. Repeat the process on the right-hand side.

8. Cutting test:

Place a strip of paper in such a way on the lower blade that it points

towards the spindle of the cylinder.

9. Turn cylinder carefully.

If the lower blade is set correctly the paper will be cut off as if with

scissors.

10. Repeat the cutting test at different positions and on all blades on the

blade cylinder.

Regrinding / Repairs:

On safety grounds, only original FLYMO spares may be

used.

Please contact FLYMO Service if it is necessary to replace the cutting

tool, which will only become blunt after several years use if well-main-

tained. Repairs to the cylinder mower and the installation of the blades

can be undertaken by suitable specialist workshops.

Have the cylinder mower checked over in the autumn if possible so

that it is ready for use immediately when the next lawn-mowing season

starts.

For any other malfunctions please contact the FLYMO service depart-

ment.

Let the blade replace by the FLYMO service or a specialist dealer author-

ised by FLYMO.

6. TECHNICAL DATA

Unit Value FLYMO H400

Cutting width cm 40

Cutting height mm 12 – 38

Cutting height adjustment

(4-stages) mm 12, 20, 28, 38

Weight kg 8.3

7. SERVICE / WARRANTY

Service:

Please contact the address on the back page.

Warranty statement:

In the event of a warranty claim, no charge is levied to you for the services

provided.

Husqvarna UK Ltd. grants a warranty for all original FLYMO new products

for two years from the date of original purchase from the retailer, provided

that the devices have been for private use only. This manufacturer’s war-

ranty does not apply to products acquired second hand. This warranty

includes all significant defects of the product that can be proved to be

material or manufacturing faults. This war ranty is fulfilled by supplying

afully functional replacement product or by repairing the faulty product

sent to us free of charge; we reserve the right to choose between these

options. This service is subject to the following provisions:

• The product has been used for its intended purpose as per the recom-

mendations in the operating instructions.

• Neither the purchaser nor a third party has attempted to open or repair

the product.

• Only Original FLYMO replacement parts and wear parts have been used

for operation.

• Presentation of the receipt.

Normal wear and tear of parts and components (such as blades, blade fix-

ing parts, turbines, light bulbs, V-belts / toothed belts, impellers, air filters,

spark plugs), visual changes, wear parts and consumables are excluded

from the warranty.

This manufacturer’s warranty is limited to replacement and repair of prod-

ucts in accordance with the abovementioned conditions. The manufactur-

er’s warranty does not constitute an entitlement to lodge other claims

against us as a manufacturer, such as for damages. This manufacturer’s

warranty does , of course, affect statutory and contractual warranty not

claims against the dealer / retailer.

The manufacturer’s warranty is governed by the law of the Federal

Republic of Germany.

In case of a warranty claim, please return the faulty product, together with

a copy of the receipt and a description of the fault, with postage paid to

the service address.

Consumables:

The blade is a consumable and is not included in the warranty.

PRODUCT LIABILITY

In accordance with the German Product Liability Act, we hereby expressly

declare that we accept no liability for damage incurred from our prod-

uctswhere said products have not been properly repaired by a FLYMO-

approved service partner or where original FLYMO parts or parts author-

ised by FLYMO were not used.

SERVICE ADDRESS AND IMPORTER TO

Great Britain

Husqvarna UK Ltd

Preston Road

Aycliffe Industrial Park

Newton Aycliffe

County Durham

DL5 6UP

Phone:+44 (0) 344 8444558

customer.services@husqvarna.co.uk

Our policy of continuous improvement means that the specification of products may be altered from

time to time without prior notice.

Flymo® and other product and feature names are registered or unregistered trademarks of Flymo S.A.

20400-85.960.01/0322

Husqvarna AB

Drottninggatan 2

SE-561 82 Huskvarna

Sweden

20400-85.960.01.indd 2

20400-85.960.01.indd 220400-85.960.01.indd 2 02.03.22 10:42

02.03.22 10:42

02.03.22 10:4202.03.22 10:42

Produktspecifikationer

Varumärke:	Flymo
Kategori:	Gräsklippare
Modell:	H400
Färg på produkten:	Zwart
Typ av strömkälla:	USB
Trådlös laddning:	Ja
Antal per paket:	1 stuk(s)
USB-strömförsörjning:	Ja
Typ-av-laddare:	Binnen
Laddare kompatibilitet:	Smartphone