GE JSS26BDBB Bruksanvisning

GE Ugn JSS26BDBB

Läs nedan 📖 manual på svenska för GE JSS26BDBB (12 sidor) i kategorin Ugn. Denna guide var användbar för 8 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/12

229C4053P557-2

31-10567-2 05-04 JR

Installation

30” Electric

Instructions Slide-In Range

BEFORE YOU BEGIN

Read these instructions completely

and carefully.

•IMPORTANT — Save these

instructions for local inspector’s use.

•IMPORTANT — Observe all

governing codes and ordinances.

•Note to Installer – Be sure to leave these

instructions with the Consumer.

•Note to Consumer – Keep these

instructions for future reference.

•Skill level – Installation of this appliance

requires basic mechanical skills.

•Completion time – 1 to 3 hours

• Proper installation is the responsibility of

the installer.

• Product failure due to improper installation

is not covered under the Warranty.

WARNING — This appliance must

be properly grounded.

FOR YOUR SAFETY:

CAUTION: —For Personal Safety

remove house fuse or open circuit breaker

before beginning installation. Failure to do so

could result in serious injury or even death.

ANTI-TIP DEVICE

WARNING —To reduce the risk

of tipping, the appliance must be secured by

properly installed Anti-Tip bracket packed

with this appliance.

If the Anti-Tip device supplied with the range

does not fit this application, use the universal

Anti-Tip device WB2X7909.

WARNING —

• All ranges can tip

• Injury to persons could result

• Install Anti-Tip bracket packed

with range

• See Installation Instructions

If you pull the range out and away from the

wall for any reason, make sure the Anti-Tip

bracket is engaged when the range is pushed

back against the wall.

Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: www.GEAppliances.com

Installation Instructions

FOR YOUR SAFETY:

All rough-in and spacing dimensions must be

met for safe use of your range. Electricity to

the range can be disconnected at the outlet

without moving the range if the outlet is in

the preferred location (remove lower drawer).

To reduce the risk of burns or fire when

reaching over hot surface elements, cabinet

storage space above the cooktop should be

avoided. If cabinet storage space is to be

provided above the cooktop, the risk can

be reduced by installing a range hood that

sticks out at least 5″beyond the front of the

cabinets. Cabinets installed above a cooktop

must be no deeper than 13″.

Be sure your appliance is properly installed

and grounded by a qualified technician.

PREPARE TO INSTALL THE RANGE

TOOLS YOU WILL NEED

Straight Edge

Drill with 1/8″Bit

Hand or Saber Saw

Pencil

Safety Glasses

Tape Measure

REMOVE SHIPPING MATERIALS

Remove all parts from the plastic bag found

inside the prepack of the oven and save

packaging tape.

ANTI-TIP DEVICE INSTALLATION

Before placing range in the counter, check the

factory location of the stability device on the

back of the range. For convenience you can

hook the stability chain in the upper set of

holes. Make sure there is no structural

interference when using the upper set of holes.

Decide on a location

that has no electrical

wiring or plumbing.

With the long screw

provided anchor the

chain to the floor or wall.

Make sure the

screw is going

into the wall plate

or stud at the

base of the wall

at least 3/4″.

Attach the stability chain so that it lines up

with the bracket on the back of the range.

Tug the chain to make sure it is securely

fastened.

Take the packaging

tape and temporarily

attach the loose end

of the chain to the

rear of the countertop.

Slide the range

into the counter

leaving enough

space behind to attach

the chain to the bracket.

Backguard (some models)

Mainback

Bracket Optional

Location

Chain

Long

Screw

Washer

Tape

Wall

Plate

Washer

and

Screw

Bracket Factory

Location

Fig. 1

Fig. 2

Fig. 3

Fig. 4

Chain

MINIMUM CLEARANCES (CONT.)

MINIMUM DIMENSIONS BETWEEN

COOKTOP AND CABINETS OR WALLS

Electrical Outlet Area

(Back of counter in cutout not shown for clarity)

• The distance from the floor to the top

of the counter must be at least 35-7/8″.

The maximum countertop height is 38″.

Make sure the wall coverings, countertop and

cabinets around the cooktop can withstand

the heat (up to 200°F) generated by the range.

NOTE: Dimension for Wall to Front of Door

Handle (door closed).

*28″FOR MODELS – JSP26, JSS26, JSC26,

JSS16, RS734, RS504

**28-1/2″FOR MODELS – JSP39, JSP38, JSP31,

JSP28, RS744, RS622, JS960, JSP40, JSP34

Installation Instructions

MINIMUM CLEARANCES

• The distance from the floor to the top

of the counter must be at least 35-7/8″.

The maximum counter height is 38″.

•30″ranges conform to U.L. requirements

for 0″spacing from vertical walls above

countertops. However, some kitchen cabinet

finishes can be damaged by heat from the

range surface elements. Where varnished

wood or plastic film finishes are used,

a minimum clearance of 6″must be

maintained.

• For listed over-the-range microwave

ovens, the microwave ovens can be

installed above the cooktop as per

manufacturer’s installation instructions.

•The range may be placed with 0″clearance

(flush) at the back wall and side walls if the

range side trims extend beyond the cabinet

fronts at least 1/4″.

• See Figures 1 and 2 for all rough-in and

spacing dimensions. These dimensions

must be met for safe use of your range.

The location of the electrical outlet may

be changed as needed, but electricity to

the range can be disconnected at the outlet

without moving the range if the outlet is

in the suggested location (remove lower

drawer).

ANTI-TIP DEVICE INSTALLATION

(CONT.)

Slip the nearest link of the chain onto the

bracket. Pull to make sure it is as snug as

possible.

Slide the range all the way back. It is

normal to have some slack in the chain,

but it should not be excessive.

0”

18” Min.

30” Min.

0”

6”

Min.

6”

41⁄ ”2

21⁄ ”4

30”

36”

30”

Acceptable

electrical

outlet area.

Backguard (some models)

Mainback

Bracket Optional

Location

Chain

Bracket Factory

Location

281⁄2”** Wall to front

of door handle

(door closed) 45”

with door open

Fig. 5

Fig. 6

Fig. 7

28”*

1⁄ ”4

5”

Produktspecifikationer

Varumärke:	GE
Kategori:	Ugn
Modell:	JSS26BDBB
Färg på produkten:	Zwart
Vikt:	3400 g
Bredd:	319 mm
Djup:	336 mm
Höjd:	100 mm
Ljudnivå:	- dB
Mobila operativsystem som stöds:	Android, iOS
Batterikapacitet:	- mAh
Varaktighet:	60 min
Batteri/Batterispänning:	14.4 V
Fjärrstöd för smartphone:	Ja
Form:	D-shape
Återgår automatiskt till basstationen:	Ja
Dammkapacitet (totalt):	- l
Uppladdningsbar:	Ja
Fjärrstyrd:	Ja
Understödda golvtyper:	Carpet, Hard floor, Laminate, Linoleum, Tiles, Wood
Antal borstar:	1
Wifi:	Ja
AC-ingångsspänning:	110 - 220 V
Batteriteknik:	Lithium-Ion (Li-Ion)