GE JV337XWH Bruksanvisning

GE Fläktkåpa JV337XWH

Läs nedan 📖 manual på svenska för GE JV337XWH (12 sidor) i kategorin Fläktkåpa. Denna guide var användbar för 2 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/12

Use and Care of Recirculation Hood Model JN327

and Ventilating Hood Models JV327, JV337 & JV347

IMPORTANT SAFETY

INFORMATION

READ ALL INSTRUCTIONS

BEFORE USING.

WARNING—TO REDUCE THE RISK

OF FIRE, ELECTRIC SHOCK OR

INJURY TO PERSONS, OBSERVE

THE FOLLOWING:

A. Use this unit only in the manner intended by

the manufacturer. If you have any questions,

contact the manufacturer.

B. Before servicing or cleaning unit, switch

power off at service panel and lock the service

disconnecting means to prevent power from

being switched on accidentally. When the service

disconnecting means cannot be locked, securely

fasten a prominent warning device, such as a tag,

to the service panel.

CAUTION—For general ventilating use only.

Do not use to exhaust hazardous or explosive

materials and vapors.

When you get your new hood…

• Have it installed and properly grounded by

a qualied technician in accordance with the

installation instructions.

• Have the installer show you the location of

the hood circuit breaker or fuse and mark it

for easy reference.

• Take the time to read our suggestions for best use.

WARNING—TO REDUCE THE RISK

OF FIRE, ELECTRIC SHOCK OR

INJURY TO PERSONS, OBSERVE

THE FOLLOWING:

A. Installation work and electrical wiring must be

done by qualified person(s) in accordance with

all applicable codes and standards, including

fire-rated construction.

B. Sufficient air is needed for proper combustion

and exhausting of gases through the flue

(chimney) of fuel burning equipment to prevent

back drafting. Follow the heating equipment

manufacturer’s guidelines and safety standards

such as those published by the National Fire

Protection Association (NFPA), and the

American Society for Heating, Refrigeration

and Air Conditioning Engineers (ASHRAE),

and the local code authorities.

C. When cutting or drilling into wall or ceiling,

do not damage electrical wiring and other

hidden utilities.

D. Ducted fans must always be vented to the

outdoors.

WARNING—To reduce the risk of fire,

use only metal ductwork.

When using your hood…

• Never leave surface units unattended at high

settings. Boilover causes smoking and greasy

spillovers that may ignite and spread if hood is

used. Use surface unit heat settings recommended

by the manufacturer and adequate-size utensils.

• Never use your cooking appliance for warming

or heating the room. The electrical wiring of

your range hood may not withstand the resulting

excessive heat.

• Keep the hood clean and clean grease lter

or replace charcoal lter as recommended to

maintain good venting and to avoid grease res.

WARNING—TO REDUCE THE RISK

OF A RANGE TOP GREASE FIRE:

A. Never leave surface units unattended at high

settings. Boilovers cause smoking and greasy

spillovers that may ignite. Heat oils slowly on

low or medium settings.

B. Always turn hood ON when cooking at high

heat or when cooking aming foods.

C. Clean ventilating fans frequently. Grease should

not be allowed to accumulate on fan or filter.

D. Use proper pan size. Always use cookware

appropriate for the size of the surface element.

(continued next page)

GE Quality Product

IMPORTANT SAFETY

INSTRUCTIONS (continued)

WARNING—TO REDUCE THE RISK

OF INJURY TO PERSONS IN THE

EVENT OF A RANGE TOP GREASE

FIRE, OBSERVE THE FOLLOWING:

A. SMOTHER FLAMES with a close-fitting lid,

cookie sheet, or metal tray, then turn off the burner.

BE CAREFUL TO PREVENT BURNS. If the

flames do not go out immediately, EVACUATE

AND CALL THE FIRE DEPARTMENT.

B. NEVER PICK UP A FLAMING PAN—

You may be burned.

C. DO NOT USE WATER, including wet dishcloths

or towels—a violent steam explosion will result.

D. Use an extinguisher ONLY if:

1. You know you have a Class ABC extinguisher,

and you already know how to operate it.

2. The re is small and contained in the area

where it started.

3. The re department is being called.

4. You can ght the re with your back to an exit.

*Based on “Kitchen Firesafety Tips” published by NFPA.

WARNING: The electrical wiring and fan

motor in this range hood are not intended

for use with, or provided with, a solid state

speed control. Any such alteration from

original factory wiring concept could result

in damage to the unit and/or create an

electrical safety hazard.

READ AND SAVE THESE

INSTRUCTIONS

Models: JN327 & JV347—non-ducted installations only

Your hood is equipped with a replaceable charcoal lter.

When the fan is operated, air is drawn through the filter

and discharged into the room through the hood.

Model: JV327—ducted installations only

Your hood is equipped with a metal grease lter.

When the fan is operated, air is drawn through the

lter and discharged to the outside.

Models: JV337 & JV347—ducted installations only

Your hood is equipped with a reusable metal grease

lter. When the fan is operated, air is drawn through

the lter and discharged to the outside.

CAUTION—before operating the hood:

•Install the lamp bulb (not provided). See the

Lamp Replacement instructions.

If You Need Service…

• Do not attempt to repair or replace any part of

your hood unless it is specifically recommended

in this book. All other servicing should be referred

to a qualified technician.

• Disconnect hood circuit breaker or fuse before

performing any service.

Replaceable charcoal lter

Grease

lter

(Model JV347 has a lamp cover.)

Lamp

holder

Grease lter

(Model JV347 has a lamp cover.)

Lamp

holder

Lamp

holder

To Operate

Lamp Switch

Models: JN327, JV327, JV337

Press for OFF and ON.

Lamp Switch

Model: JV347

Rotate clockwise, rst position for NIGHT LIGHT,

second position for BRIGHT LIGHT.

Fan Switch

Models: JN327, JV327, JV337

CENTER position OFF, DOWN position LOW SPEED,

TOP position HIGH SPEED.

Model: JV347

Rotate Clockwise, FIRST position HIGH, SECOND

position MEDIUM, THIRD position LOW.

Care and Cleaning

Replaceable Charcoal Filter—Used in

non-ducted installations only.

Models: JN327, JV347—non-ducted installations only

The charcoal lter cannot be cleaned. It must be

replaced.

DO NOT RINSE OR PLACE THE CHARCOAL

FILTER IN A DISHWASHER.

The efficiency of your hood depends upon a clean filter.

The frequency of filter replacement depends on hood

use and the type of cooking you do. See replacement

guidelines below for your non-ducted model installation.

NEVER OPERATE THE HOOD WITHOUT THE

FILTER IN PLACE.

When to replace the lter:

JN327 and JV347 (non-ducted installations only)—The

lter should be replaced after 6 to 12 months. Order and

replace with genuine GE part: WB02X10700.

To remove: Pull down on the center of the front edge of

the lter. The lter will then slip out of the retaining tabs

on the back.

To replace:

Slip the back edge of the filter into the retaining

tabs and push the front edge up until it snaps in place.

Reusable Metal Grease Filter—Used in

ducted installations only.

Models: JV327, JV337, JV347—ducted installations only

The eciency of your hood depends on a clean lter.

Frequency of cleaning depends on hood use and the type

of cooking you do. HOWEVER, THE GREASE FILTER

SHOULD BE CLEANED AT LEAST ONCE A MONTH.

NEVER OPERATE THE HOOD WITHOUT THE

FILTER IN PLACE.

To remove: Pull down on the center of the front edge of

the lter. The lter will then slip out of the retaining tabs

on the back.

To clean: Soak and then agitate it in a hot water and

detergent solution. Light brushing can be used to remove

embedded dirt. Rinse, shake and let it dry before replacing.

To replace: Slip the back edge of the lter into the

retaining tabs and push the front edge up until it snaps

into place.

With careful handling, the metal lter will last for years.

If a new replacement becomes necessary, order the part

from your dealer. Order genuine GE part: WB02X8391.

Hood

Clean grease laden surfaces of the hood frequently.

Use warm detergent solution. About 1 tablespoon of

ammonia may be added to the water. TAKE CARE TO

NOT COME IN CONTACT WITH FILTERS AND

OTHER NON-ENAMELED SURFACES. The hood

shell can be washed, rinsed and dried with a soft cloth.

Motor and Fan

To Clean Motor and Fan

1. DISCONNECT THE HOOD POWER SUPPLY AT

THE HOUSEHOLD DISTRIBUTION PANEL BY

REMOVING THE FUSE OR SWITCHING OFF

THE CIRCUIT BREAKER.

2. Remove the lter.

3. Wipe the fan blade and motor with cloth, dampened

only in ammonia and warm water solution.

4. Replace the lter.

5. Reconnect the hood power supply.

CAUTION: Be certain when cleaning the hood

surfaces you do not touch the lamp bulb with moist

hands or cloth. A warm or hot lamp bulb may break

if touched with a moist surface. ALWAYS let lamp

cool COMPLETELY before cleaning around it.

Vents (JN327 & JV347)

Fan switch Lamp switch

Produktspecifikationer

Varumärke:	GE
Kategori:	Fläktkåpa
Modell:	JV337XWH
Färg på produkten:	Zwart
Antal per paket:	1 stuk(s)
Kompatibilitet:	B2283HS-B3, XUB2390HS-B1, B2482HS-B1, B2483HS-B3, XUB2492HSU-B1\nXB2474HS-B2, XUB2595WSU-B1
Typ produkt:	Steun
Harmoniserad systemkod (HS):	85299018