Hoover HDO725 W Bruksanvisning

Hoover Ugn HDO725 W

Läs nedan 📖 manual på svenska för Hoover HDO725 W (16 sidor) i kategorin Ugn. Denna guide var användbar för 2 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/16

INSTRUCTIONS FOR USE

INSTALLATION

ELECTRICAL CONNECTION

BEFORE USING THE OVEN

SAFEGUARDING THE ENVIRONMENT

PRECAUTIONS AND GENERAL RECOMMENDATIONS

OVEN ACCESSORIES

CARE AND CLEANING

TROUBLE-SHOOTING GUIDE

AFTER SALES SERVICE

DECLARATION OF CONFORMITY CE

CONTROL PANEL

ELECTRONIC PROGRAMMER

OVEN FUNCTIONS

Technical information for the installer

The oven has been designed to be installed under a worktop surface.

Do not lift the oven by the handle, but hold it by the sides.

Make sure that the appliance was not damaged during transport.

The oven and unit dimensions are shown in the below figures.

The units in contact with the oven must be heat-resistant (min. 85°C).

If the plastic laminates or the sealing material are not sufficiently heat resistant, this may result in the formation

of bubbles, deformation of the surface or detachment of the coating.

Insert the oven in the unit cavity, lifting it by the sides and being careful not to trap the power cable.

The oven and housing dimensions are illustrated in the below figures.

For correct ventilation, follow the ventilation opening directions shown in the figure 1.

Two systems can be used to fit your appliance to a chosen furniture layout:

A. Between two side panels of two distinct cabinet units without the aid of a support shelf, by fitting four support

steel brackets provided with the product. (fig. 3).

B. Between two side panels each fixed to the side of a cabinet unit without the aid of a support shelf. In this case

only the two lower support brackets will be necessary (fig. 4).

Note: In both of the above cases you must measure 717 mm from the underside of the worktop and mark the correct

position of the lower support brackets before fixing them to the sides. With reference to (fig. 3), ensure the side

support brackets are positioned 40 mm from the front of the cabinet door exterior surface, as illustrated, before

securing them to the cabinet sides. If necessary, this product can be installed in a housing unit (fig. 2). The housing

unit will not be a standard one but will have to be of a size that can accommodate the full height of the oven -

minimum height 717 mm. This housing unit will need to fulfil the ventilation requirements.

Fasten the oven using the screws.

Fig. 1 Fig. 2

Fig. 3 Fig. 4

NOTE:

INSTALLATION

Produktspecifikationer

Varumärke:	Hoover
Kategori:	Ugn
Modell:	HDO725 W
Färg på produkten:	Zwart, zilver
Vikt:	138 g
Bredd:	54 mm
Höjd:	18 mm
Sladdlängd:	2.043 m
Förpackningens vikt:	150 g
Förpackningens bredd:	130 mm
Djuppackning:	220 mm
Förpackningshöjd:	- mm
Användarmanual:	Ja
Kabellåsspårtyp:	Noble
Material:	Zink staal
Hållbarhetscertifikat:	RoHS
Antal per paket:	1 stuk(s)
Bästa användningen:	Notebook
(Ytter) huvudpaketets höjd:	230 mm
(Ytter) huvudförpackningens bredd:	290 mm
(Ytre) huvudpaketets längd:	325 mm
Kvantitet per (yttre) huvudkartong:	40 stuk(s)
Harmoniserad systemkod (HS):	83014090
Slot typ:	Combinatieslot
Egenskaper:	1
Antal kombinationer:	10000