Hori Fighting Stick α Bruksanvisning

Hori Kontroller Fighting Stick α

Läs nedan 📖 manual på svenska för Hori Fighting Stick α (7 sidor) i kategorin Kontroller. Denna guide var användbar för 10 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Sida 1/7
Controller
Instruction Manual
Thank you for purchasing this product.
Before using this product please read the instructions carefully.
After reading the instruction manual, please keep it for reference.
Caution
Caution Parents/Guardians:
Please read the following information carefully.
This product contains small parts. Keep away from children under 3 years old.
Keep this product away from small children or infants. Seek medical attention immediately if any
small parts are swallowed.
Long cord. Strangulation hazard.
Keep the product away from dusty or humid areas.
Do not use this product if it has been damaged or modified.
Do not get this product wet. This may cause an electric shock or malfunction.
Do not place this product near heat sources or leave under direct sunlight for an extended period.
Overheating may cause malfunction.
Do not touch the metal parts of the USB plug.
Do not apply strong impact or weight on the product.
Do not pull roughly or bend the cable of the product.
Do not disassemble, modify or attempt to repair this product.
If product needs cleaning, use only a soft dry cloth. Do not use any chemical agents like benzene
or thinner.
Do not use this product for anything other than its intended purpose. We are not responsible for
any accidents or damages in the event of use other than the intended purpose.
Included
Xbox Series X|S / Xbox One / Windows 10
【 】Subpanel
Mode Toggle Switch
Key Lock Switch
Mic LED
Share Button
Xbox®
Guide button
View Button
RSB Button
LSB Button
Status LED
Profile LED
Audio Control Button
Profile Button
Mic On/Off Button
Joystick (D-Pad)
RB Button
LB Button
RT Button
LT Button
Y Button
X Button
B Button
A Button
Menu Button
USB Connector Controller Cable
Quick Release
Platform
* Functions as PC controller through XInput.
This product does not support DirectInput.
USB Port, Internet ConnectionSystem requirements
Important
Before using this product with the Xbox Series X|S / Xbox One system,please read the included
instructions carefully.
Please check that your Xbox Series X|S / Xbox One is updated to the latest system firmware.
This product is designed for the Xbox Series X|S, but it can also be used with the
Xbox One and Windows 10 by following the instructions in this manual.
Layout
【 】Front View
Headphone/Mic Jack
12
Open the chassis while sliding the sliding lock button.
Open the top case to a vertical position and place the product on a sturdy surface.
Please note that damage (such as damaged buttons and quick disconnect blade
connectors and covers, broken cables, etc.) caused by user modifications other than
replacing buttons or panel art are not covered by warranty.
Please de-static yourself before touching inside of the product.
Do not connect the USB plug into the Xbox Series X/ Xbox Series S/ Xbox One console or
Windows 10 USB port.
Do not remove buttons or connectors during gameplay.
Do not directly touch the metal inside the product with your bare hands.
Be careful to not get your hands, fingers, hair, or cables caught when opening or closing the chassis.
Open the chassis for maintenance or replace the design sheet to customize your
Fighting Stick α.
How to Open the Chassis
When installing a button, push the button in until
the stopper clicks into place.
* After installing, make sure that there is no gap between
the button and housing cover.
When installing a button, insert the blade connectors
as far as it will go.
Refer to the cable wiring diagram below when wiring
each button.
2) As shown in the figure, push the two stoppers little
by little to remove them from the housing cover.
* Parts may be damaged if too much force is used.
* Be careful to not cut your hands on the edges of the buttons
holes on the housing cover.
1) Remove the quick disconnect blade connectors
connected to each button.
* When disconnecting the blade connectors, do not pull it out
by holding only the wiring cable.
How to Remove a Button
When performing maintenance, please refer to the How to Remove a Button
section and the Cable Wiring Diagram as shown below.
Maintenance and Design Customization
Remove
Housing
Cover
Stopper
While
pressing
While
pressing
Blade connector

Produktspecifikationer

Varumärke: Hori
Kategori: Kontroller
Modell: Fighting Stick α

Behöver du hjälp?

Om du behöver hjälp med Hori Fighting Stick α ställ en fråga nedan och andra användare kommer att svara dig




Kontroller Hori Manualer

Kontroller Manualer

Nyaste Kontroller Manualer