IFM E33304 Bruksanvisning

Läs nedan 📖 manual på svenska för IFM E33304 (3 sidor) i kategorin Inte kategoriserad. Denna guide var användbar för 4 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Sida 1/3
Installation instructions
Aseptoflex Vario adapter
with O-ring / PEEK sealing ring
E332xx
E333xx
704965/01 02/2011
UK
2
1 Installation sensor - adapter
C
B
A
Grease the sensor thread with
paste (A).
The paste must be suitable and ap-
proved for the application and com-
patible with the elastomers used.
Place the sealing ring (B) in the
groove (C) of the sensor.
Screw the sensor into the adapter
until it is hand-tight. When doing
so, avoid mechanical effects on the
sealing areas, the hygienic area and
the pressure measuring cell.
D
Clamp the sensor + adapter into a
clamping device (D). Tighten the
clamping device only slightly so that
the adapter does not warp.
Tighten the sensor using a spanner
until you can feel the end stop (this
corresponds to a maximum tighten-
ing torque of 35 Nm). Note: Further
tightening may affect the sealing
effect.
3
UK
The adapter is supplied with an EPDM O-ring. More sealing rings are available as
accessories:
FKM O-ring, order no. E30123.
PEEK sealing ring, order no. E30124.
Use a new adapter when changing from a PEEK seal to O-ring sealing.
2 Mounting to the process connection
Fix the sensor + adapter are fixed to the process connection using a fixing ele-
ment (coupling nut, clamp flange, etc.).
If it is not possible to slide the fixing element down over the top of the unit: slide
it up over the bottom of the unit before the adapter is mounted.
Use in hygienic areas to EHEDG:
Make sure that the sensors are integrated into the system in accord-
ance with EHEDG.

Produktspecifikationer

Varumärke: IFM
Kategori: Inte kategoriserad
Modell: E33304

Behöver du hjälp?

Om du behöver hjälp med IFM E33304 ställ en fråga nedan och andra användare kommer att svara dig




Inte kategoriserad IFM Manualer

Inte kategoriserad Manualer

Nyaste Inte kategoriserad Manualer