IFM E33340 Bruksanvisning

Läs nedan 📖 manual på svenska för IFM E33340 (3 sidor) i kategorin Inte kategoriserad. Denna guide var användbar för 9 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Sida 1/3
Installation Instructions
Universal process adapter RD52
E33340
704966/01 02/2011
UK
2
B
C
A
Grease thread and sealing (B) of the
coupling nut (C) with paste (A).
The paste must be suitable and ap-
proved for the application and compat-
ible with the elastomers used.
D
Slip the coupling nut onto the sensor (D)
from the bottom.
F
E
A
D
Grease the sensor thread with the paste
(A) (see above ).
Place the sealing ring (E) in the groove
(F) of the sensor.
The adapter is supplied with an EPDM
O-ring. More sealing rings are available as
accessories:
FKM O-ring, order no. E30123.
PEEK sealing ring, order no. E30124.
Use a new adapter when changing from a
PEEK seal to O-ring sealing.
3
UK
G
H
Screw the sensor into the adapter (G)
until it is hand-tight. When doing so,
avoid mechanical effects on the sealing
areas, the hygienic area and the pres-
sure measuring cell..
Make sure that the O-ring (H) is correctly
positioned.
I
Clamp the sensor + adapter into a
lamping device (I). Tighten the clamping
device only slightly so that the adapter
does not warp.
Tighten the sensor using a spanner until
you can feel the end stop (this corre-
sponds to a maximum tightening torque
of 35 Nm). Note: Further tightening may
affect the sealing effect.
Insert the unit in a universal process connection RD52.
Tighten the coupling nut.

Produktspecifikationer

Varumärke: IFM
Kategori: Inte kategoriserad
Modell: E33340

Behöver du hjälp?

Om du behöver hjälp med IFM E33340 ställ en fråga nedan och andra användare kommer att svara dig




Inte kategoriserad IFM Manualer

Inte kategoriserad Manualer

Nyaste Inte kategoriserad Manualer