JBL Northridge E60 Bruksanvisning

JBL högtalare Northridge E60

Läs nedan 📖 manual på svenska för JBL Northridge E60 (4 sidor) i kategorin högtalare. Denna guide var användbar för 3 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/4

E30, E50, E60, E80, E90,

E100, EC35

NORTHRIDGE™E SERIES

OWNER’S GUIDE

5 – 6 ft.

(1.5m–1.8m)

MODELS: E30, E50

SPEAKER PLACEMENT

Proper placement of the

speakers is an important step

in obtaining the most realistic

soundstage possible. These

recommendations are for the

optimum placement of the

loudspeakers. Use these

placement recommendations

as a guide. Slight variations

will not diminish your listen-

ing pleasure.

All of the Northridge E Series

loudspeakers referred to in

this guide are video-shielded

and can safely be placed

near a television.

As front speakers

MODELS: E60, E80, E90, E100

As surround speakers

MODEL: EC35

0 – 2 ft.

(0–0.6m)

The EC35 center channel

loudspeaker is designed to

complement all of the

Northridge E Series loud-

speakers. It is the ideal way

to re-create the cinematic

experience in your home.

MODELS: E30,

E50, E60, E80,

E90, E100

MODEL: EC35

Speakers and electronics ter-

minals have corresponding (+)

and ( ) terminals. It is impor-–

tant to connect both speakers

identically: (+) on the speaker

to (+) on the amplifier and (–)

on the speaker to ( ) on the–

amplifier. Wiring out of“

phase” results in thin sound,

weak bass and poor imaging.

To use the binding-post

speaker terminals, unscrew

the colored collar until the

pass-through hole in the cen-

ter post is visible. Insert the

bare end of the wire through

this hole; then screw the collar

down until the connection

is tight.

The hole in the center of each

collar is intended for use with

banana-type connectors. To

comply with European CE cer-

tification, these holes are

blocked with plastic inserts at

the point of manufacture. To

use banana-type connectors

requires the removal of the

inserts. Do not remove these

inserts if you are using the

product in an area covered by

the European CE certification.

BI-WIRING

The bi-wire connection

method requires one amplifier

and two sets of speaker wires.

By removing the shorting bars,

connections may be made to

the individual network

sections

using four conductors,

one for

each of the four terminals.

For single-wire connection,

leave the shorting bars in

place and connect only a sin-

gle set of speaker wires (two

conductors) to the two upper

terminals.

Bi-Wire Connections

MODELS: E30, EC35, E50

The supplied self-adhesive

rubber feet may be attached

to the bottom corners of your

speakers to protect your

furniture.

MODELS: E60, E80, E90,

E100

These models feature four

rubber feet that enable them

to be placed on a smooth-

surfaced floor, such as tile or

hardwood. Four metal spikes

are supplied for use when the

speaker is to be placed on a

carpeted surface, to decouple

the speaker from the floor and

prevent unwanted damping. To

insert the spikes, gently lay the

speaker on its side (not its

front or back) on a soft,

nonabrasive surface. Each

spike screws into the threaded

insert in the center of each

rubber foot. Make sure all

four spikes are screwed in

completely for stability.

NEVER drag the speaker to

move it, as this will damage

the spikes, the feet and/or the

wood cabinet itself. Always lift

the speaker and carry it to its

new location.

CAUTION: Floorstanding

(tower) loudspeakers have a

high center of gravity and may

become unstable and tip over

during earthquakes, or if

rocked, tipped or improperly

positioned. If this is a concern,

these speakers should be

anchored to the wall behind

them, using the same proce-

dures and hardware custom-

ary for anchoring bookcases

and wall units. The customer

is responsible for proper instal-

lation and proper selection of

hardware.

– +

Amplifier

High Frequency

Low Frequency

Receiver

Speaker Outputs

– +

CENTER

– +

– +– +

– +

Receiver’s Speaker Outputs

LEFT

RIGHT

– +

SPEAKER CONNECTIONS

TROUBLESHOOTING

If there is no sound from

any of the speakers:

• Check that receiver/ampli-

fier is on and that a source is

playing.

• Review proper operation of

your receiver/amplifier.

If there is no sound com-

ing from one speaker:

• “ ” Check the Balance

control on your receiver/

amplifier.

• Check all wires and connec-

tions between receiver/

amplifier and speakers.

• Make sure no wires are

touching other wires or

terminals and creating a

short circuit.

• Make sure all wires are

connected. Make sure none

of the speaker wires are

frayed, cut or punctured.

• In Dolby* Digital or DTS®

modes, make sure that the

receiver/processor is config-

ured so that the speaker in

question is enabled.

• Turn off all electronics and

switch the speaker in ques-

tion with one of the other

speakers that is working cor-

rectly. Turn everything back

on, and determine whether

the problem has followed the

speakers, or has remained in

the same channel. If the

problem is in the same chan-

nel, the source of the prob-

lem is most likely with your

receiver or amplifier, and

you

should consult the owner’s

manual for that product for

further information.

If the

problem has followed the

speaker, consult your dealer

for further assistance or, if

that is not possible, visit

www.jbl.com for further

information.

If the system plays at

low volumes but shuts

off as volume is

increased:

• Check all wires and connec-

tions between receiver/

amplifier and speakers.

• Make sure all wires are

connected. Make sure none

of the speaker wires are

frayed, cut or punctured.

• If more than one pair of

main speakers is being used,

check the minimum imped-

ance requirements of your

receiver/amplifier.

If there is no (or low)

bass output:

• Make sure the polarities

(+ and –) of the left and right

“ ”Speaker Inputs are

connected properly.

• Consider adding a powered

subwoofer to your system for

use with digital surround“.1”

formats.

If there is no sound from

the surround speakers:

• Check all wires and con-

nections between receiver/

amplifier and speakers. Make

sure all wires are connected.

Make sure none of the

speaker wires are frayed,

cut or punctured.

• Review proper operation of

your receiver/amplifier and

its surround sound features.

• Make sure the movie or TV

show you are watching is

recorded in a surround sound

mode. If it is not, check to

see whether your receiver/

amplifier has other surround

modes you may use.

• In Dolby Digital or DTS

modes, make sure your

receiver/processor is config-

ured so that the surround

speakers are enabled.

• Review the operation of your

DVD player and the jacket of

your DVD to make sure that

the DVD features the desired

Dolby Digital or DTS mode,

and that you have properly

selected that mode using both

the DVD player’s menu and the

DVD disc’s menu.

Declaration of Conformity

We, Harman Consumer International

2, route de Tours

72500 Chateau-du-Loir

France

declare in own responsibility that the products

described in this owner’s manual are in compliance

with technical standards:

EN 50081-1:1992

EN 50082-1:1997

Gary Mardell

Harman Consumer International

Chateau-du-Loir, France 7/03

Produktspecifikationer

Varumärke:	JBL
Kategori:	högtalare
Modell:	Northridge E60

Behöver du hjälp?

Om du behöver hjälp med JBL Northridge E60 ställ en fråga nedan och andra användare kommer att svara dig

Ditt namn*

Din e-post*

Skriv din fråga här

högtalare JBL Manualer

JBL Media 2000 Bruksanvisning

21 December 2024

JBL Media Sub Bruksanvisning

21 December 2024

JBL Media Sub 2000 Bruksanvisning

21 December 2024

JBL SCS150 Bruksanvisning

21 December 2024

JBL SAT Pair 135 Bruksanvisning

21 December 2024

JBL SCS125 Bruksanvisning

21 December 2024

JBL SCS135S Bruksanvisning

21 December 2024

JBL SCS136 Bruksanvisning

21 December 2024

JBL SCS135P Bruksanvisning

21 December 2024

JBL Northridge E60 Bruksanvisning

21 December 2024

högtalare Manualer

Nyaste högtalare Manualer

Boompods Zero XL Bruksanvisning

21 December 2024

Sencor SMC BS10 Bruksanvisning

21 December 2024

Harman Kardon HKTS 12 Bruksanvisning

21 December 2024

Harman Kardon HKTS 6 Bruksanvisning

21 December 2024

Harman Kardon HKS 2 Bruksanvisning

21 December 2024

Harman Kardon HKS 9 Bruksanvisning

21 December 2024

Harman Kardon HKTS 8 Bruksanvisning

21 December 2024

Harman Kardon HKS 6 Bruksanvisning

21 December 2024

Harman Kardon HKTS 11 Bruksanvisning

21 December 2024

Harman Kardon HKTS 3 Bruksanvisning

21 December 2024