Kenwood Excelon CA-GRL14RG Bruksanvisning

Kenwood Inte kategoriserad Excelon CA-GRL14RG

Läs nedan 📖 manual på svenska för Kenwood Excelon CA-GRL14RG (2 sidor) i kategorin Inte kategoriserad. Denna guide var användbar för 6 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Sida 1/2
Take the time to read through this instruction manual.
Familiarity with installation and operation procedures will help you obtain the best performance from your new product.
© 2023 JVCKENWOOD Corporation
CA-GRL14RG
METAL MESH SPEAKER GRILLES DESIGNED AND ENGINEERED FOR
2015+ HARLEY-DAVIDSON® ROAD GLIDE® MOTORCYCLES
INSTRUCTION MANUAL
JVCKENWOOD Corporation
Important Notes
©2023 JVCKENWOOD Corporation. All Rights Reserved. KENWOOD® and eXcelon®
are registered trademarks of JVCKENWOOD Corporation. Harley-Davidson®, Electra
Glide®, Road Glide®, Street Glide®, Ultra Classic®, Tri Glide®, CVO™, Screamin Eagle®
and Tour-Pak® are trademarks or registered trademarks of Harley-Davidson, Inc. and/
or its affiliates and if used or implied are for reference only. There is no affiliation
between Harley-Davidson, Inc. and/or its aliates and JVCKENWOOD Corporation
and/or its aliates. All other trademarks are the property of their respective owners.
Specications subject to change without notice.
Metal Mesh Speaker Grilles Installation Instructions
Installation procedure
1. Each factory grille will need to be removed from the inner fairing by prying up on
them. Start with your ngers, but if you must use a tool, use something with a 90° end,
being extra careful not to scratch your inner fairing.
2. On the back of each stock grille, you will see a rubber gasket and 2 white clips. These
gaskets and clips need to be removed from the factory grilles and re-installed on the
KENWOOD grilles.
3. Once the gaskets and clips are installed onto the new grilles, simply press the new
grilles back onto your inner fairing.
NOTE: The factory clips in step 2 must be removed
carefully. Using your thumbnails or a at edge under
each side, gently pry the 2 ends apart (see Fig 1.1)
and pull up to release each clip from the stock grille.
If you put a flat edge under one end only, the clip
cannot release and could break.
Fig 1.1
For updated information (the latest Instruction Manual, etc.),
please visit the following website:
https://manual.kenwood.com/en_contents/search/
NOTE: On the back side of the grilles, you will see tabs that are part
of the metal mesh which are folded over to secure the mesh to the
plastic trim ring. Folding these tabs back up allows the ring and mesh
to separate easily for paint etc. For custom applications, the metal
mesh is thick enough that it should not warp during powder coating,
polishing, chroming, or other similar processing.

Produktspecifikationer

Varumärke: Kenwood
Kategori: Inte kategoriserad
Modell: Excelon CA-GRL14RG

Behöver du hjälp?

Om du behöver hjälp med Kenwood Excelon CA-GRL14RG ställ en fråga nedan och andra användare kommer att svara dig




Inte kategoriserad Kenwood Manualer

Inte kategoriserad Manualer

Nyaste Inte kategoriserad Manualer