Kicker DXA250.4 Bruksanvisning

Kicker mottagare DXA250.4

Läs nedan 📖 manual på svenska för Kicker DXA250.4 (32 sidor) i kategorin mottagare. Denna guide var användbar för 9 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF
Sida 1/32
DXA
AMPLIFIERS
Owner’s Manual
DXA250.4
Manual del Propietario | Español
AMPLIFICADOR DEL LA SERIE DXA.4
Benutzerhandbuch | Deutsch
MONOVERSTÄRKER DER DXA.4-SERIE
Manuel d’utilisation | Française
AMPLIFICATEUR DE SÉRIE DXA.4
2014 DXA 4-Channel Amps Rev A.indd 1
2014 DXA 4-Channel Amps Rev A.indd 1
2014 DXA 4-Channel Amps Rev A.indd 1
2014 DXA 4-Channel Amps Rev A.indd 12014 DXA 4-Channel Amps Rev A.indd 1 8/2/2013 4:44:10 PM
8/2/2013 4:44:10 PM
8/2/2013 4:44:10 PM
8/2/2013 4:44:10 PM8/2/2013 4:44:10 PM
2
DXA.4-SERIES AMPLIFIER
OWNER’S MANUAL
INSTALLATION
Mounting: Choose a structurally sound location to mount your KICKER amplifi er. Make sure there are no items
behind the area where the screws will be driven. Choose a location that allows at least 4” (10cm) of open
ventilation for the amplifi er. If possible, mount the amplifi er in the climate-controlled passenger compartment. Drill
four holes using a 7/64” (3mm) bit and use the supplied #8 screws to mount the amplifi er.
Wiring: Disconnect the vehicle’s battery to avoid an electrical short. Then, connect the ground wire to the
amplifi er. Make the ground wire short, 24” (60cm) or less, and connect it to a paint-and-corrosion-free, solid,
metal area of the vehicle’s chassis. Adding an additional ground wire of this same gauge (or larger) between the
battery’s negative post and the vehicle chassis is recommended.
PERFORMANCE
Authorized KICKER Dealer:
Purchase Date:
Serial Number:
Model: DXA250.4
RMS Power [Watts]
@ 14.4V, 4Ω stereo, ≤ 1% THD+N
@ 14.4V, 2Ω stereo, ≤ 1% THD+N
@ 14.4V, 4Ω mono, ≤ 1% THD+N
30 x 4
60 x 4
125 x 2
Length [in, cm] 12-7/16, 32
Height [in, cm] 2-3/8, 6
Width [in, cm] 7-3/16, 18
Frequency Response [Hz] 10–20k
Signal-to-Noise Ratio [dB] >95, A-weighted, re: rated power
Input Sensitivity Low Level: 125mV–5V
High Level: 250mV–10V
Selectable Electronic Crossover HI, LO or OFF; Variable 50–200Hz @ 12dB/Octave
KickEQ™ Bass Boost Variable 0–12dB @ 40Hz
Pro Tip: To get the best performance from your new KICKER Amplifi er and extend the warranty by 1 year, use
genuine KICKER accessories and wiring.
MODEL: DXA250.4
2014 DXA 4-Channel Amps Rev A.indd 2
2014 DXA 4-Channel Amps Rev A.indd 2
2014 DXA 4-Channel Amps Rev A.indd 2
2014 DXA 4-Channel Amps Rev A.indd 22014 DXA 4-Channel Amps Rev A.indd 2 8/2/2013 4:44:13 PM
8/2/2013 4:44:13 PM
8/2/2013 4:44:13 PM
8/2/2013 4:44:13 PM8/2/2013 4:44:13 PM
3
The DXA amplifi er has dual input sensitivity differential RCA inputs which will receive either high or low level
signals from your car stereo’s source unit. A high-level signal can be run from the source unit’s speaker outputs
to the stereo RCA input on the end panel of the amplifi er using the KICKER KISL as shown (make sure you set
the DXA amplifi er’s input level switch to “HI”). Alternatively, the signal can be delivered to the amplifi er using the
low-level RCA outputs on the source unit. Set the input level switch on the end panel of the amplifi er to “LO”.
Keep the audio signal cable away from factory wiring harnesses and other power wiring. If you need to cross this
wiring, cross it at a 90 degree angle.
Install a fuse within 18” (45cm) of the battery and in-line with the power cable connected to your amplifi er. If you
ever need to remove the amplifi er from the vehicle after it has been installed, the ground wire should be the last
wire disconnected from the amplifi er--just the opposite as when you installed it.
source unit
high-level speaker
outputs
to amplifi er
shield
+
–
core conductor KICKER KISL (optional)
from source unit high-
level speaker outputs
OR
to amplifi er
POWER WIRING
12V
battery
external fuse
remote turn-on
(see page 6)
bare-metal
chassis ground
bare-metal
chassis ground
≤18”
(45cm)
≤24”
(60cm)
Model External Fuse
(sold separately)
Power/Ground Wire KICKER Wiring Kit
DXA250.4 1 x 60 Ampere 8 Gauge PK8, ZCK84
2014 DXA 4-Channel Amps Rev A.indd 3
2014 DXA 4-Channel Amps Rev A.indd 3
2014 DXA 4-Channel Amps Rev A.indd 3
2014 DXA 4-Channel Amps Rev A.indd 32014 DXA 4-Channel Amps Rev A.indd 3 8/2/2013 4:44:13 PM
8/2/2013 4:44:13 PM
8/2/2013 4:44:13 PM
8/2/2013 4:44:13 PM8/2/2013 4:44:13 PM

Produktspecifikationer

Varumärke: Kicker
Kategori: mottagare
Modell: DXA250.4

Behöver du hjälp?

Om du behöver hjälp med Kicker DXA250.4 ställ en fråga nedan och andra användare kommer att svara dig


mottagare Kicker Manualer

Kicker

Kicker KXMA1500.1 Bruksanvisning

24 September 2024
Kicker

Kicker KXA800.5 Bruksanvisning

24 September 2024
Kicker

Kicker PXA200.2 Bruksanvisning

24 September 2024
Kicker

Kicker PXA500.1 Bruksanvisning

24 September 2024
Kicker

Kicker KXA400.4 Bruksanvisning

24 September 2024
Kicker

Kicker KXA1200.1 Bruksanvisning

24 September 2024
Kicker

Kicker IQ500.4 Bruksanvisning

24 September 2024
Kicker

Kicker KXA800.1 Bruksanvisning

24 September 2024
Kicker

Kicker KXA1600.1 Bruksanvisning

24 September 2024
Kicker

Kicker IQ500.1 Bruksanvisning

24 September 2024

mottagare Manualer

Nyaste mottagare Manualer

Alto

Alto D1 Bruksanvisning

16 Januari 2025
Alto

Alto MC700.4 Bruksanvisning

16 Januari 2025
Alto

Alto MC250.4 Bruksanvisning

16 Januari 2025
Alto

Alto MC250.8 Bruksanvisning

16 Januari 2025
Alto

Alto D4 Bruksanvisning

16 Januari 2025
Alto

Alto D3 Bruksanvisning

16 Januari 2025
Alto

Alto MC500.4 Bruksanvisning

16 Januari 2025
S.M.S.L

S.M.S.L PA200 Bruksanvisning

15 Januari 2025
Peavey

Peavey CKd 608 Bruksanvisning

15 Januari 2025
Wavtech

Wavtech link700.4plus Bruksanvisning

14 Januari 2025