Kicker SubStage SSON12 Bruksanvisning

Kicker Subwoofer SubStage SSON12

Läs nedan 📖 manual på svenska för Kicker SubStage SSON12 (10 sidor) i kategorin Subwoofer. Denna guide var användbar för 3 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF
Sida 1/10
1
SSON12
Designed for 2012 and newer Chevrolet® Sonic vehicles
©2012 Stillwater Designs
SSON12-A2-20121010
2
Subwoofer Assembly
Subwoofer
Power Harness
25A Fuse
Wire Ties x6
Foam Strip
Wire Taps x2
Adapter Harness
Subwoofer Body
Harness
3
Power Wire Routing
1. Disconnect the negative battery cable from the battery.
2. Using a razor knife make a cross shaped incision in the large rubber grommet from inside the vehicle and
feed the power wire from the engine compartment to the cabin. Using a fi sh tape wire is recommended.
Fig. 1
NOTE: If you are installing the optional amplifi er system, install the power wire for it at this time.
3. Pull the wire(s) through the grommet until the sheathing touches the grommet.
4. Remove the fuse box cover under the hood. Remove the fuse from the fuse holder on the subwoofer
power wire and connect the power wire to the accessory lug. Torque to 9 +/- 1.5 Nm. Make sure that the
wires exit on the side closest to the battery. Fig. 2
5. Install the connecter on the end of the power harness inside the cabin. The black connecter should have
a block out plug installed in one side to prevent the power wire from being inserted into the wrong position in
the connecter.
NOTE: If you are installing the optional amplifi er system, it does not matter what order the three wires are
installed on the three-pin connecter, but the terminals can only be inserted one way. If the terminal will not
go into the connecter, simply turn it 180 degrees and try again. Push the terminals in until they click and lock
into place.
Body Harness Routing
6. Remove the driver’s side kick/threshold panel by loosening the
retainer at the top and then pulling loose. Fig. 3
7. Remove the lower portion of the rear seat by pulling straight up
on the front edge.
8. Snap loose the rear drivers side threshold panel located along
the bottom of the door opening.
9. Snap loose the lower portion of the B pillar post cover.
Cut grommet here.
Fig. 1
Fig. 2
Wires should exit in
direction of arrow
Retainer – Rotate
counter-clockwise
Fig. 3
Remember to place your warranty card in the glove box for future use.

Produktspecifikationer

Varumärke: Kicker
Kategori: Subwoofer
Modell: SubStage SSON12

Behöver du hjälp?

Om du behöver hjälp med Kicker SubStage SSON12 ställ en fråga nedan och andra användare kommer att svara dig


Subwoofer Kicker Manualer

Kicker

Kicker 51MWF104 Bruksanvisning

14 Januari 2025
Kicker

Kicker 51MWF124 Bruksanvisning

14 Januari 2025
Kicker

Kicker 51MWE104 Bruksanvisning

10 Januari 2025
Kicker

Kicker 51MWE124 Bruksanvisning

10 Januari 2025
Kicker

Kicker 48CWR154 Bruksanvisning

8 Januari 2025
Kicker

Kicker 50CVX154 Bruksanvisning

2 Januari 2025
Kicker

Kicker 50CVX124 Bruksanvisning

2 Januari 2025
Kicker

Kicker 51CWQ102 Bruksanvisning

26 September 2024
Kicker

Kicker 51CWQ122 Bruksanvisning

26 September 2024
Kicker

Kicker 43C84 Bruksanvisning

26 September 2024

Subwoofer Manualer

Nyaste Subwoofer Manualer

ETON

ETON Graphit 8-2 Bruksanvisning

19 Mars 2025
ETON

ETON Graphit 8-4 Bruksanvisning

19 Mars 2025
ETON

ETON Graphit 10-4 Bruksanvisning

19 Mars 2025
ETON

ETON MW 10 FLAT Bruksanvisning

19 Mars 2025
ETON

ETON PW 8 Bruksanvisning

19 Mars 2025
ETON

ETON USB 6 AR Bruksanvisning

19 Mars 2025
Morel

Morel Ultimo Powerslim 124D Bruksanvisning

12 Mars 2025
Morel

Morel Ultimo Powerslim 104D Bruksanvisning

12 Mars 2025
Rockustics

Rockustics OneSub Bruksanvisning

10 Mars 2025
Hifonics

Hifonics Elite HEW8D4S Bruksanvisning

5 Mars 2025