Nec PlasmaSync 42VP4 Bruksanvisning

Nec Övervaka PlasmaSync 42VP4

Läs nedan 📖 manual på svenska för Nec PlasmaSync 42VP4 (60 sidor) i kategorin Övervaka. Denna guide var användbar för 7 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Sida 1/60
NEC plasma display
NEC plasma display
NEC plasma display
NEC plasma display NEC plasma display
External Control Manual
External Control Manual
External Control Manual
External Control ManualExternal Control Manual
(for PX-50XM3/PX-42XM2/PX-42VP4)
Application
Application
Application
Application Application
These specifications are applicable to NEC plasma monitors and
communications control from external equipment.
"Please also support the command of VP series and refer to the manual of the
conventional model about specification."
Connections
Connections
Connections
Connections Connections
Connections should be made as described below.
External equipment
e.
g
.
,
Personal com
p
ute
r
plasma monitor
1) Connector on the plasma monitor side: EXTERNAL CONTROL connector.
T
T
T
TType of connector: D-Sub 9-pin male
ype of connector: D-Sub 9-pin male
ype of connector: D-Sub 9-pin male
ype of connector: D-Sub 9-pin maleype of connector: D-Sub 9-pin male
No. Pin Name
1 No Connection
2 RXD (Receive data)
3 TXD (Transmit data)
4 DTR (DTE side ready)
5 GND
6 DSR (DCE side ready)
7 RTS (Ready to send)
8 CTS (Clear to send)
9 No Connection
2
2) Connector on the external equipment side: Serial port (RS-232C) connector.
See the specifications of the equipment that is to be connected for the type of
connector and the pin assignment.
3) Wiring
Use a crossed (reverse) cable.
Use a crossed (reverse) cable.
Use a crossed (reverse) cable.
Use a crossed (reverse) cable.Use a crossed (reverse) cable.
Wire the cable so that each pair of data lines cross between the two devices.
These data line pairs are RXD (Receive data) and TXD (Transmit data), DTR
(DTE side ready) and DSR (DCE side ready), and RTS (Ready to send) and CTS
(Clear to send).
Communication Parameters
Communication Parameters
Communication Parameters
Communication ParametersCommunication Parameters
(1) Communication system Asynchronous
(2) Interface RS-232C
(3) Baud rate 9600 bps
(4) Data length 8 bits
(5) Parity Odd
(6) Stop bit 1 bit
(7) Communication code Hex
3

Produktspecifikationer

Varumärke: Nec
Kategori: Övervaka
Modell: PlasmaSync 42VP4

Behöver du hjälp?

Om du behöver hjälp med Nec PlasmaSync 42VP4 ställ en fråga nedan och andra användare kommer att svara dig




Övervaka Nec Manualer

Övervaka Manualer

Nyaste Övervaka Manualer