Netgear ANT2407 Bruksanvisning

Netgear Inte kategoriserad ANT2407

Läs nedan 📖 manual på svenska för Netgear ANT2407 (2 sidor) i kategorin Inte kategoriserad. Denna guide var användbar för 9 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/2

)NSTALLATION'UIDE

Extended wireless network coverage: 400~450 M. The actual indoor range will be

affected by the local environment.

Note: For optimal results in extending wireless range with antenna installations, consult a

qualified professional installer service for a site survey and proper installation. For a list of

devices approved by the FCC for use with the antenna, see the NETGEAR website at

http://tools.netgear.com/legal/fcc_antennas.html.

Warning: Keep the antenna 15 cm (6 in) away from

notebook computers and monitors.

400~450 M

To maximize coverage and performance, place the antenna within the line of sight of your

wireless devices. Minimize partitions and objects that block the line of sight if possible.

The antenna can be placed on a flat surface, wall mounted, or magnet mounted.

• If wall-mounting, place the antenna on an interior wall above cubicles (cubicles

generally include a metal foil). Ideal placement is 2 meters (6.5 feet) high.

• If the wireless access point, router, or gateway, is in an IT room, place the antenna

outside the room against a a wall and close to the ceiling.

The area close to, behind, or beside the antenna will be covered, because the dynamic

range of the WLAN transmitter/receiver and antenna is approximately 100 dB. Even

with 20 dB to 40 dB or attenuation, the signal strength is still strong and

communication is maintained.

• The antenna has magnets in the base, which can be used to mount it on metal cabinets,

white boards, or even the ceiling cross bars (the framework that holds the ceiling

panels up).

Omni-directional

antenna ANT2407

Approximate

coverage area

Magnet mounting

on a whiteboard

Turn off your wireless access point, and connect your ANT2407 antenna. Note that the

antenna has a RP SMA female reverse connector. If your wireless access point is new,

follow the access point installation instructions. If you are upgrading an existing access

point, turn it on again.

Wireless Device with 1 Antenna

Wireless Device with 2 Antennas: Replacing the Primary Antenna

Wireless Device with 2 Antennas: Replacing Both

Wireless access point

February, 2009

Regional Customer Support phone numbers:

This symbol was placed in accordance with the European Union Directive 2002/96 on the

Waste Electrical and Electronic Equipment (the WEEE Directive). If disposed of within the

European Union, this product should be treated and recycled in accordance with the laws of

your jurisdiction implementing the WEEE Directive.

trademarks of NETGEAR, Inc. in the United States and/or other countries. Other brand and product names

are trademarks or registered trademarks of their respective holders. Information is subject to change

without notice.

All countries 1-888-638-4327 Germany 0180 590 59 59 Mexico 1800 123 1786

Argentina 0800 666 9838 Finland 020 7928590 Netherlands 020 568 2987

Australia 1300 361 254 France 0820 887 177 New Zealand 0800 174600

Austria 0820 555 644 Hong Kong 800 964 605 Norway 800 12 500

Belgium 078 15 06 73 Hungary 1 23 55 353 Poland 22 583 4381

Brazil 0800 761 0021 India 1800-425-4327 Russia 810-800-20931032

Bulgaria + 359 2 97 444 70 Italy 0238 591 018 Singapore 800 6011 369

Canada 1-888-NETGEAR Ireland 1800 453019 Slovakia 02 5010 2648

Chile 800 472001 Japan 0120-921-080 Spain 90 099 5462

China 800-830-3815 Korea 080-638-4327 Sweden 0770-93 00 33

Columbia 01800-700-2102 Lux (Deu) 0049 180 590 59 59 Switzerland 0848 000 195

Czech Republic 296 335 656 Lux (Fra) 0033 820 88 71 77 Thailand 1800 060 013

Denmark 80 702 666 Malaysia 1800 880 023 UK 0844 875 4000

US 1-888-NETGEAR

NETGEAR 7 dBi Omni-directional Antenna ANT2407 Specifications

Frequency range 2.4~2.5GHz

Impedance 50 Ohmns

Gain (excluding cable loss) 7 dBi@ 2.45GHz

Operating temperature –10 to 60° C (14 to 140° F)

Storage temperature –10 to 70° C (14 to 158° F)

Humidity 95% RH

Radome material ABS

HPBW/H-plane 360°

HPBW/E-plane 21.6°

Dimensions (l x w x h) 114 x 169 x 302 mm (4.5 x 6.7 x 12 in)

Weight 240 gf

Connector RP SMA Female Reverse

Warranty 2 year

Impedance 50 +/- 5 Ohms

V-Plane Co-Polarization Patterns

H-Plane Co-Polarization Patterns

2.4GHz 2.45GHz 2.5GHz 2.4GHz 2.45GHz 2.5GHz

-15

-10

-5

120

150

180

210

240

270

300

330

-15

-10

-5

-15

-10

-5

120

150

180

210

240

270

300

330

-15

-10

-5

Thank you for selecting NETGEAR products.

After installing your device, locate the serial number of your product and use it to register

your product at http://www.NETGEAR.com/register. Registration is required before you

can use our telephone support service. Registration via our website is strongly

recommended.

Go to http://kbserver.netgear.com for product updates and Web support.

Statement of Conditions

In the interest of improving internal design, operational function, and/or reliability, NETGEAR reserves

the right to make changes to the products described in this document without notice. NETGEAR does not

assume any liability that may occur due to the use or application of the product(s) or circuit layout(s)

described herein.

Federal Communications commission (FCC) Compliance Notice:

Radio Frequency Notice

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference received, including interference that may cause undesired

operation.

To comply with FCC regulations, the ANT2407 should only be used with devices that have been FCC

approved for use with the NETGEAR ANT2407. Check the NETGEAR website at

http://tools.netgear.com/legal/fcc_antennas.html for an updated list of FCC approved devices.

Note: This equipment has been tested and found to comply with the limits for Class B digital devices,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against

harmful interference in residential installation. This equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures: (1) Reorient or relocate the receiving antenna; (2)

Increase the separation between the equipment and receiver; (3) Connect the equipment to an outlet or

circuit different from that to which the receiver is connected; (4) Consult the dealer or an experienced

radio/TV technician for help.

FCC and EU Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.

To avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the

antenna must be less than 20 cm (8 inches) during normal operation.

This device should not be co-located with other transmitters.

For EU, use of any antenna requires careful planning and extra considerations to comply with EU

emissions and health standards and regulations. Antenna installation must comply with the maximum

level authorized by each country.

Produktspecifikationer

Varumärke:	Netgear
Kategori:	Inte kategoriserad
Modell:	ANT2407
Färg på produkten:	Zwart
LED-indikatorer:	Ja
På / Av knapp:	Ja
Typ av strömkälla:	AC
Strömförbrukning (i standby):	3 W
Impedans:	4 Ohm
Medium effekt subwoofer:	300 W
Diameter drivrutin subwoofer (imperiaal):	12 "
Subwoofertyp:	Actieve subwoofer
Subwooferns frekvensområde:	18 - 250 Hz
Subwooferns bredd:	350 mm
Höjd på subwoofern:	368 mm
Subwooferns djup:	420 mm
Vikt subwoofer:	21000 g
XLR in:	Ja
Antal subwoofers:	1
AC-ingångsspänning:	100 - 120 V
AC-ingångsfrekvens:	50 - 60 Hz
Strömförbrukning (typiskt):	325 W
Diameter drivrutin för subwoofer:	300 mm
Crossover subwoofer frekvenser:	60 - 80 Hz