Ozito PX5PAK-005U Bruksanvisning

Ozito Inte kategoriserad PX5PAK-005U

Läs nedan 📖 manual på svenska för Ozito PX5PAK-005U (2 sidor) i kategorin Inte kategoriserad. Denna guide var användbar för 7 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/2

CHARGER SAFETY WARNINGS

DESCRIPTION OF SYMBOLS

SPECIFICATIONS

Input: 200-250V AC 50-60Hz

Output: 21V DC, 3A

Battery Charge Time: 30Min - PXBP-150U (18V 1.5Ah)

40Min - PXBP-200U (18V 2.0Ah)

60Min - PXBP-300U (18V 3.0Ah)

75Min - PXBP-400U (18V 4.0Ah)

120Min - PXBP-520U (18V 5.2Ah)

100Min - PXUBP-520U (18V 5.2Ah Ultra)

1. Charging Unit

2. Charging Unit LED

ozito-diy.co.uk

FAST CHARGER

ORIGINAL INSTRUCTIONS

PXCG-030U

Art.-No.: 30.003.95

I.-No.: 11018

Danger! Read the operating instructions to reduce the risk of inquiry.

Caution! The charging unit is allowed to be used only

for the lithium-ion batteries of the Power X Change range!

For use in dry rooms only.

Double Insulated (Safety Class II)

The reprinting or reproduction by any other means, in whole or in part, of documentation and papers

accompanying products is permitted only with the express consent of the iSC GmbH.

Subject to technical changes

Danger!

The equipment and packaging material are not toys. Do not let children play

with plastic bags, foils or small parts. There is a danger of swallowing or

suffocating!

ELECTRICAL SAFETY

WARNING! When using mains-powered tools, basic safety precautions, including the

following, should always be followed to reduce risk of ﬁre, electric shock, personal injury

and material damage.

Read the whole manual carefully and make sure you know how to switch the tool off in an emergency, before operating

the tool.

Save these instructions supplied with this tool for future reference.

Before you connect the charger to the mains supply make sure that the data on the rating plate are identical to the mains

data.

This tool charger is double insulated; therefore no earth wire is required.

If the supply cord is damaged, it must be replaced by an electrician or a power tool repairer in order to avoid a hazard.

Note: Double insulation does not take the place of normal safety precautions when operating this tool. The insulation

system is for added protection against injury resulting from a possible electrical insulation failure within the tool.

The power supply for this products charger should be protected by a residual current device (rated at 30mA or less). A

residual current device reduces the risk of electric shock.

This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities,

or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the

appliance by a person responsible for their safety.

Children should be supervised to ensure that they do not play with the appliance.

Danger! Read all safety regulations and instructions. Any errors made in following the safety

regulations and instructions may result in an electric shock, re and/or serious injury.

Keep all safety regulations and instructions in a safe place for future use.

This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental

capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use

of the appliance by a person responsible for their safety.

Replacing the power cable If the power cable for this equipment is damaged, it must be replaced by the manufacturer or

OEM after-sales service or by similarly trained personnel to prevent hazards.

a) The charging unit is not allowed to be used for non-rechargeable, normal batteries.

b) Sufcient ventilation is required.

c) The current and voltage information on the battery pack must be the same as that on the charging unit.

d) Do not expose the charging unit to splashwater or rain.

e) The charging unit must be disconnected from the socket outlet before the rechargeable battery is inserted into or

removed from the charging station.

f) Do not throw old or damaged batteries into water or  re. Follow the environmental protection directives.

g) A defective or no longer chargeable battery must be treated as special waste. Dispose of it at a special collection point.

Do not dispose of it with your normal household waste or throw it into water or re.

h) Place the charging unit away from all sources of heat.

i) To reduce the risk of electric shock, pull the power plug out of the socket outlet by the plug itself and not by the cable

when you want to disconnect the charging unit from the power supply.

j) Do not take the charging unit apart. Take it to an authorized repair center if servicing or repairs are needed. Incorrect

assembly can result in an electric shock and even death or  re.

k) Children must always be supervised in order to ensure that they do not play with the equipment.

DECLARATION OF CONFORMITY

Yang/Product-ManagementWeichselgartner/General-Manager

explains the following conformity according to EU directives and norms for

the following product

Fast Charger PXCG-030U (Ozito)

2014/29/EU

2005/32/EC_2009/125/EC

X 2014/35/EU

2006/28/EC

X 2014/30/EU

2014/32/EU

2014/53/EC

2014/68/EU

90/396/EC_2009/142/EC

89/686/EC_96/58/EC

X 2011/65/EU

2006/42/EC

Annex IV

Noti ed Body:

Noti ed Body No.:

Reg. No.:

2000/14/EC_2005/88/EC

Annex V

Annex VI

Noise: measured L

WA = dB (A); guaranteed LWA = dB (A)

P = KW; L/Ø = cm

Noti ed Body:

2012/46/EU

Emission No.:

Standard references: EN 60335-1; EN 60335-2-29;

EN 62233; EN 55014-1; EN 55014-2; EN 61000-3-2; EN 61000-3-3

Landau/Isar, den 02.03.2018

First CE: 18 Archive-File/Record: NAPR018733

Art.-No.: 30.003.95 I.-No.: 11018 Alex KurzDocuments registrar:

Subject to change without notice Wiesenweg 22, D-94405 Landau/Isar

ISC GmbH · Eschenstraße 6 · D-94405 Landau/Isar

Thermal cut out protection

1. CHARGING A BATTERY

Charger LED Indicator Lights

LED Indicator Situation

GREEN (Flashing) Stand By (no battery pack is inserted)

RED (Flashing) Battery is charging (low charge)

RED (Illuminated) Battery is fast charging (mid charge)

GREEN (Illuminated) Battery is 85% - 100% charged and is ready for use.

BOTH(Illuminated) Battery pack is too hot or too cold (charging will begin

automatically when battery reaches correct charging

temperature).

BOTH (Flashing) The battery is deffective, charging is no longer

possible. Do not charge. Contact Ozito Customer

Service.

CAUTION: THE CHARGER SHOULD BE PROTECTED BY

A RESIDUAL CURRENT DEVICE (RATED AT 30MA OR

LESS).

2. Align and then slide the ribs on

the battery into the recess in the

charger.

1. Connect the charger to the power

supply and the LED will ash

green showing power is being

supplied to the charger.

3. The red LED will illuminate while

the battery charges.

4. The green LED will illuminate once

the battery is charged.

2. MAINTENANCE

• Disconnect the charger from power source before cleaning.

• Keep the charger in a dry place out of reach of children.

• If the enclosure of the charger requires cleaning, do not use solvents. Use a dry, soft

cloth only to wipe down the surface. Never let any liquid get inside the charger; never

immerse any part of the drill into a charger.

• There are no other parts inside the charger which require maintenance. Do not

take the charger apart. If the charger is damaged, contact your supplier or the

manufacturer.

Mounting the charging unit on a wall

The charging unit can be mounted to a wall or workbench.

The correct dimensions for drill holes can be found on the back of the charging unit.

Note: When mounting on a wall you must use suitable screws, e.g. M3 pan-head

screws, in order to prevent damage to the housing and risk of falling.

PXCG-030U

WARRANTY

All of our products undergo strict quality checks to ensure that they reach you in perfect condition.

In the unlikely event that your device develops a fault, please contact our service department at the

address shown on this guarantee card. You can also contact us by telephone using the customer

service number shown. Please note the following terms under which guarantee claims can be made:

1. These warranty terms regulate additional warranty services, which the manufacturer mentioned

below promises to buyers of its new products in addition to their statutory guarantee claims are not

affected by this guarantee. Our guarantee is free of charge to you.

2. The warranty services only covers defects due to material or manufacturing faults on a product

which you have bought from the manufacturer mentioned below are limited to either the rectication

of said defects on the product or the replacement of the product, whichever we prefer.

Please note that our devices are not designed for use in commercial, trade or professional

applications. A guarantee contract will not be created if the device has been used by commercial,

trade or industrial business or has been exposed to similar stresses during the guarantee period.

3. The following are not covered by our guarantee:

- Damage to the device caused by a failure to follow the assembly instructions or due to incorrect

installation, a failure to follow the operating instructions (for example connecting it to an incorrect

mains voltage or current type) or a failure to follow the maintenance and safety instructions or by

exposing the device to abnormal environmental conditions or by lack of care and maintenance.

- Damage to the device caused by abuse or incorrect use (for example overloading the device or the

use or unapproved tools or accessories), ingress of foreign bodies into the device (such as sand,

stones or dust, transport damage), the use of force or damage caused by external forces (for example

by dropping it).

- Damage to the device or parts of the device caused by normal or natural wear or tear or by normal

use of the device.

4. Your Product is guaranteed for a period of 12 months from the original date of purchase and is

intended for DIY (Do It Yourself) use only. Warranty excludes consumable parts. Guarantee claims

should be submitted before the end of the guarantee period within two weeks of the defect being

noticed. No guarantee claims will be accepted after the end of the guarantee period. The original

guarantee period remains applicable to the device even if repairs are carried out or parts are

replaced. In such cases, the work performed or parts tted will not result in an extension of the

guarantee period, and no new guarantee will become active for the work performed or parts tted.

This also applies if an on-site service is used.

IN ORDER TO MAKE A CLAIM UNDER THIS WARRANTY YOU MUST RETURN THE PRODUCT TO THE

PLACE OF PURCHASE WITH YOUR REGISTER RECEIPT.

Please refer to the restrictions of this warranty concerning wearing parts, consumables and missing

parts as set out in the service information in these operating instructions.

CUSTOMER SERVICE

HELPLINE

GB: 0151 294 4488

IRL: 1850 882711

Ozito-diy.co.uk

OZITO UK Champion’s Business Park, Unit 10, 1st Floor, Arrowe Brook Road,

Upton, Wirral, Merseyside, CH49 0AB

This charger is compatible with batteries from the 18V Ozito Power X Change range

available through your local Bunnings Warehouse: Product availability may differ

between countries.

• PXBP-150U: 1.5Ah Battery

• PXBP-200U: 2.0Ah Battery

• PXBP-300U: 3.0Ah Battery

• PXBP-400U: 4.0Ah Battery

• PXBP-520U: 5.2Ah Battery

• PXUBP-520U: 5.2Ah Ultra Battery

ONLINE MANUAL

Scan this QR Code with your

mobile device to take you to the

online manual.

Produktspecifikationer

Varumärke:	Ozito
Kategori:	Inte kategoriserad
Modell:	PX5PAK-005U
Bredd:	51 mm
Djup:	30 mm
Höjd:	0.8 mm
Gränssnitt:	SATA III
Förvaringstemperatur:	-45 - 85 °C
SSD-kapacitet:	240 GB
SSD-formfaktor:	mSATA
Minnestyp:	TLC
Läshastighet:	550 MB/s
Skrivhastighet:	530 MB/s
Överföringshastighet:	6 Gbit/s
Drifttemperatur (TT):	0 - 70 °C
Maskinvarukryptering:	Nee
NVMe:	Nee
Optisk enhetskontroll:	Phison PS3111-S11