PAC C2R-CHYNA Bruksanvisning

PAC Inte kategoriserad C2R-CHYNA

Läs nedan 📖 manual på svenska för PAC C2R-CHYNA (1 sidor) i kategorin Inte kategoriserad. Denna guide var användbar för 10 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF
Sida 1/1
Pacic Accessory Corporation 1502 S. Santa Fe St. Santa Ana, CA 92705
Voice: 714-835-3022 • Fax: 714-835-3233
www.pac-audio.com
10-12-06
DISCLAIMER: Under no circumstances shall the manufacturer or the distributors of the C2R-CHYNA parts be held liable for consequential
damages sustained in connection with the C2R-CHYNA. The manufacturer and it’s distributors will not, nor will they authorize any
representative or any other individual to assume obligation or liability in relation to the C2R-CHYNA other than its replacement.
Installation:
1. Only for Vehicles Without a Factory Amplifier: Connect the aftermarket radio’s front and rear speaker wires to the 22 pin plug.
2. The 22 pin harness has two yellow and two black wires. Connect both yellows to the radio’s +12v constant wire and both blacks
to the radio’s ground wire.
3. The Accessory wire is located on the 6 pin harness - connect this wire to the radio’s accessory wire. The accessory wire supplies
+12v, 1 amp max, when key is in the Accessory or Ignition position.
4. 11 pin plug: Orange/White - Connect this wire to the radio’s Illumination input wire only.
Note: Do not connect these wires to any other circuit besides the radio’s wire harness.
5. When all connections are made, connect the 22 pin plug into the vehicle’s 22 pin harness.
9
78
0111
1 amp
fuse holder
1#2#
tuptuO yrosseccA
.xam pma1 stlov21+
22 pin
Chrysler R
6 pin
Orange/White = Illumination
Yellow x 2 = +12v Constant
Black x 2 = ground
Gray = Right Front (+)
Gray/Black = Right Front (-)
White = Left Front (+)
White/Black = Left Front (-)
Violet = Right Rear (+)
Violet/Black = Right Rear (-)
Green = Left Rear (+)
Green/Black = Left Rear (-)
Red = +12v Accessory output
To optional SWI-CAN interface for retaining steering wheel audio controls
11 pin
C2R-CHYNA
C2R-CHYNA
C2R-CHYNA
C2R-CHYNA
C2R-CHYNA
Radio Replacement interface for 2004+
Chrysler, Dodge and Jeep vehicles
with Factory Radio Models REF, REC, RAQ and RAK.
1
23456
For Use with Aftermarket Radios to Retain Accessory Power
• Retains Accessory Power for Approximately 10 Minutes or Until A Door is Open

Produktspecifikationer

Varumärke: PAC
Kategori: Inte kategoriserad
Modell: C2R-CHYNA

Behöver du hjälp?

Om du behöver hjälp med PAC C2R-CHYNA ställ en fråga nedan och andra användare kommer att svara dig


Inte kategoriserad PAC Manualer

PAC

PAC RP4-GM31 Bruksanvisning

26 September 2024
PAC

PAC NU-GM51 Bruksanvisning

26 September 2024
PAC

PAC NAV-1129 Bruksanvisning

26 September 2024
PAC

PAC LP7-2R Bruksanvisning

26 September 2024
PAC

PAC LP7-4 Bruksanvisning

26 September 2024
PAC

PAC GMK367B Bruksanvisning

26 September 2024
PAC

PAC CP1-FRD1 Bruksanvisning

26 September 2024
PAC

PAC C2A-CHY5 Bruksanvisning

26 September 2024
PAC

PAC NU-GM3 Bruksanvisning

26 September 2024
PAC

PAC CP1-TSL1 Bruksanvisning

26 September 2024

Inte kategoriserad Manualer

Nyaste Inte kategoriserad Manualer

Philips

Philips 43PUL7672 Bruksanvisning

27 Oktober 2024
Manhattan

Manhattan 461504 Bruksanvisning

27 Oktober 2024
Sungrow

Sungrow SG125HV Bruksanvisning

27 Oktober 2024
Schneider

Schneider CCT724319 Bruksanvisning

27 Oktober 2024
Technoline

Technoline WS 250 Bruksanvisning

27 Oktober 2024
Livarno

Livarno IAN 354423 Bruksanvisning

27 Oktober 2024
Kupper

Kupper 12152 Bruksanvisning

27 Oktober 2024
JennAir

JennAir CARBON24L Bruksanvisning

27 Oktober 2024
Medion

Medion Life E74001 (MD 81035) Bruksanvisning

27 Oktober 2024
POLARIS

POLARIS Sportsman Touring 850 SP (2015) Bruksanvisning

27 Oktober 2024