Robbe Arcus II Bruksanvisning

Läs nedan 📖 manual på svenska för Robbe Arcus II (24 sidor) i kategorin Radiostyrda leksaker. Denna guide var användbar för 3 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Sida 1/24
INSTRUCTIONS AND USER MANUAL
www. .comrobbe
V1_05/2019
Standard Version No.: 2649
Night Version No.: 2650 RTF Version No.: 2651
E N G L I S H
2
I N S T R U C T I O N S A N D U S E R M A N U A L
GENERAL INFOR MATIO N
The model is designed for the components specied by us. Unless otherwise stated, servos and
other electronic components are designed for standard supply voltage. Recommended cell
count for Lipo batteries also refers to standard Lipos voltage of 3.7V per cell. If you use other ser-
vos, a different motor and controller, batteries, or propellers, please make sure they t rst. In the
event of deviations, corrections and adjustments must be made by yourself.
-Before starting construction, always put the servos into neutral. To do this, switch on the remo
te control and move the joysticks and trim buttons (save the one for the throttle) to the middle
position. Connect the servos to the corresponding outputs of the receiver and supply them with a
suitable power source. Please observe the connection diagram and the operating instructions of
the remote control system manufacturer.
Do not leave your model in the blazing sun or in your vehicle for long periods of time. Too high
temperatures can lead to deformation/distortion of plastic parts or blistering of covering foils.
Before the rst ight, check the wing symmetry, tail unit and fuselage. All parts of the model should
have the same spacing from the left and right wing or tail plane to the centre of the fuselage or
the same angle.
If necessary, rebalance the propellers if vibrations are noticeable when the motor is running up.
Bubble formation in the covering foils normal to a certain extent due to temperature and humidity
differences and can be easily eliminated with a foil iron or hairdryer.
-For models in shell construction („full GFRP/CFRP“), burrs may occur at the seams due to the pro
duction process. Carefully remove them with ne sandpaper or a le.
SAFE TY INSTR UCTIONS FOR CONTRO LLERS
GENERAL SAFETY INFORMATION
Be sure to read the safety instructions carefully before operating your model.
Always follow the procedures and settings recommended in the instructions.
If you are using remote-controlled model aircraft, helicopters, cars or ships for the rst time, we
recommend that you ask an experienced model pilot for help.
Remote-controlled models are not toys in the usual sense and may only be used and operated by
young people under 14 years of age under the supervision of adults.
Their construction and operation requires technical understanding, careful craftsmanship and
safety-conscious behaviour.
Mistakes or negligence during construction, ying or driving can result in considerable damage to
property or personal injury.
Since the manufacturer and seller have no inuence on the proper construction/assembly and
operation of the models, these risks are expressly pointed out and any liability is excluded.
Propellers on aircraft and all moving parts in general pose a constant risk of injury. Avoid touching
such parts at all costs.
Note that motors and controllers can reach high temperatures during operation. Avoid touching
such parts at all costs.
Never stay in the danger area of rotating parts with electric motors with connected drive battery.
Overcharging or incorrect charging can cause the batteries to explode. Make sure the polarity is
correct.
Protect your equipment and Models from dust, dirt and moisture. Do not expose the equipment to
excessive heat, cold or vibration.
Use only recommended chargers and charge your batteries only up to the specied charging
time. Always check your equipment for damage and replace defects with original spare parts.
Do not use equipment that has been damaged or got wet due to a fall, even if it is dry again!
Either have it checked by your specialist dealer or in the Robbe Service or have it replaced.
Hidden faults can occur due to wetness or a crash, which lead to a functional failure after a short
operating time.
Only the components and accessories recommended by us may be used.
Do not make any changes to the remote control which are not described in these instructions.
Observe the technical data of the controller.
Observe the polarity of all connection cables.
Avoid short circuits at all costs.
Install or package the regulator so that it cannot come into contact with grease, oil or water.
Ensure adequate air circulation.
Never reach into the turning circle of the propeller during start-up Risk of injury
Important information:
The receiver system is powered by the built-in BEC system of the controller.
For commissioning, always move the throttle stick to the „Motor off“ position and switch on the
transmitter. Only then connect the battery. To switch off always disconnect the connection battery
motor controller, rst
then turn off the transmitter. During the functional test, move the servos of the rudders to neutral
position with the remote control (stick and trimming lever on the transmitter to the middle position).
Please make sure to leave the throttle stick in the lowest position so that the engine does not start.
For all work on
to the parts of the remote control, motor or controller, follow the instructions supplied with the units.
Also read the instructions of the battery and the charger carefully before commissioning.
Check the engine mounting bolts in the fuselage regularly for tightness.
SAFE TY NOTE FO R MO DE L OP ERATION
Attention, danger of injury!
Always keep a safe distance from your model aircraft.
Never y over spectators, other pilots or yourself.
Always perform ight gures in a direction away from the pilot or spectators.
Never endanger people or animals.
Never y near power lines or residential areas.
Do not operate your model near locks or public shipping.
Do not operate your model on public roads, motorways, paths and squares, etc., but only in
approved locations.
Do not operate the model in thunderstorms.
Before each ight, check your remote control system for sufcient function and range.
After ying, remove all batteries from the model.
Do not „aim“ the transmitter antenna at the model during operation. In this direction, the transmitter
has the lowest radiation. The best position of the antenna is to the side of the model.
Use of devices with image and/or sound recording function:
If you equip your model with a video or image recording device (e.g. FPV cameras, action scams
etc.) or the model is already equipped with such a device at the factory, please note that you
could violate the privacy of one or more persons by using the recording function. An overight or
driving on private ground without the appropriate permission of the owner or approaching private
ground can also be regarded as an invasion of privacy. You, as the operator of the model, are sole-
ly and fully responsible for your actions.
In particular, all applicable legal requirements must be observed, which can be found in the roof
associations or the relevant authorities. Failure to comply can result in substantial penalties.
E N G L I S H
3
I N S T R U C T I O N S A N D U S E R M A N U A L
CO NFOR MITY
Modellbau Lindinger GmbH hereby declares that this device complies with
the essential requirements and other relevant regulations of the correspon-
ding CE directives. The original declaration of conformity can be found
on the Internet at www.robbe.com, in the detailed product view of the
respective device description or on request. This product can be operated
in all EU countries.
WARR ANTY
Our articles are equipped with the legally required 24 months warranty. Should you wish to assert a
justied warranty claim, always contact your dealer, who is responsible for the warranty and the pro-
cessing. During this time, any functional defects that may occur, as well as manufacturing or other
problems, will be rectied.
Material defects corrected by us free of charge. Further claims, e.g. for consequential damages, are
excluded.
The transport to us must be free, the return transport to you is also free. Freight collect shipments can-
not be accepted. We cannot accept liability for transport damage and loss of your consignment.
We recommend appropriate insurance.
To process your warranty claims, the following requirements must be met:
Attach the proof of purchase (receipt) to your shipment.
The units have been operated in accordance with the operating instructions.
Only recommended power sources and original robbe accessories have been used.
There is no moisture damage, external interference, reverse polarity, overloading or mechanical
damage.
Attach relevant information for nding the fault or defect.
This symbol means that small electrical and electronic devices must be dis-
posed of at the end of their useful life, separated from the household refuse.
Dispose of the device at your local municipal collection point or recycling
centre. This applies to all countries of the European Union and other Europe-
an countries with a separate collection system.
DISPOSAL
INSURANCE
Ground-based models are usually covered by personal liability insurance. Additional insurance or
extension is required for aircraft models. Check your insurance policy (private liability) and take out
suitable insurance if necessary.
DISCLAIMER
Modellbau Lindinger GmbH cannot monitor compliance with the assembly and operating instruc-
tions or the conditions and methods for installation, operation, use and maintenance of the model
components.Therefore, we accept no liability for losses, damage or costs arising from or in any
way connected with incorrect use and operation.To the extent permitted by law, the obligation to
pay damages, irrespective of the legal grounds, shall be limited directly to the invoice value of the
claims arising from the event causing the damage.
FLIGHT INST RUC TIONS
Before the rst ight, observe the instructions in the „Safety Instructions“ section.
When ying the model, you should choose a day with as little wind as possible
A large, at area without obstacles (trees, fences power lines etc.) is suitable for the rst ights.
Please carry out a functional test of the drive train / power set and remote control.
After assembling the model on the aireld, check once again that all model components such as
wing, tail units, wing mounts, engine, linkages, etc. are rmly and properly fastened.
For a hand start a helper should be present, who can throw the model with enough thrust into the
air.
The start usually takes place against the wind.
Do not stall the model near the ground
Do not initiate tight turns in the immediate vicinity of the ground.
Check the reactions of the model to the rudder deections. If necessary, adjust after landing to
increase or decrease the deections accordingly.
The minimum ight speed must be at an adequate safety altitude.
Initiate the landing with sufcient speed
SAFE TY INSTR UCTIONS FOR REC HARG EABLE BATTERIE S
Do not immerse the battery in water or other liquids.
Do not heat, throw into re or microwave.
Do not short-circuit or charge with reversed polarity
Do not expose, deform or throw the battery
Do not solder directly on the battery
Do not change or open the battery
Only charge the battery with suitable chargers, never connect it directly to a power supply unit.
Never charge or discharge the battery or charger on a ammable surface.
Never leave the battery unattended during charging or discharging processes.
Never charge or discharge the battery in direct sunlight or near heaters or re.
Do not use the battery in places subject to high static discharge.
All this can cause the battery to be damaged, explode or even catch re!
Keep the battery away from children
Keep leaked electrolyte away from re, as it is highly ammable and may ignite.
The electrolyte liquid should not get into the eyes, if it does, rinse immediately with plenty of clear
water and then see a doctor.
-The electrolyte liquid can also escape from clothes and other objects with a lot of water or was
hed off.
Observe the safety instructions of the battery manufacturer and the charger manufacturer.
Made in China
+14
This product is not a toy.
Operate only under the
direct supervision of adults.

Produktspecifikationer

Varumärke: Robbe
Kategori: Radiostyrda leksaker
Modell: Arcus II

Behöver du hjälp?

Om du behöver hjälp med Robbe Arcus II ställ en fråga nedan och andra användare kommer att svara dig




Radiostyrda leksaker Robbe Manualer

Radiostyrda leksaker Manualer

Nyaste Radiostyrda leksaker Manualer