Sani-Lav 727F Bruksanvisning

Sani-Lav Sjunka 727F

Läs nedan 📖 manual på svenska för Sani-Lav 727F (6 sidor) i kategorin Sjunka. Denna guide var användbar för 8 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/6

F L O O R M O U N T S I N K 1

Operating Manual for Floor Mount Stainless Steel Sink

Models 727F and 727F-0.5

of Domestic and Foreign Parts

Columbia does not recommend use with harsh chemicals.

Product Compliance

NSF/ANSI 2 Food Equipment, NSF/ANSI 61, Section 9, ASME A112.18.1/CSA B125.1

F L O O R M O U N T S I N K

COLUMBIA SPECIFICATIONS

800.626.2117 columbiasinks.com info@columbiasinks.com

Parts List

(1) Floor mount sink

(1) Leg assembly set

(6) Nuts, bolts and washers for leg assembly

(4) Washers and nuts for connection sink to leg assembly set

(1) 8” on center faucet

(1) Faucet mounting kit

(1) Strainer assembly with basket

Trouble Shooting Guide

Problem Possible Cause To Diagnose Remedy

Water drips from

the spout or from

under the lever.

1. Seat washer is worn

2. Seat is worn

3. O-rings are worn

Shut cold water source off. See if

water still leaks from the spout. If

leaks continues repair hot side if

not repair cold side.

Recommend

installing hot

or cold faucet

repair kit.

Go to for more information on replacement parts and installation videos.columbiasinks.com

WARNING: This product can expose you to chemicals including Chromium (hexavalent compounds),

Lead, and Phthalates (DEHP) which are known to the State of California to cause cancer and birth defects

or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

NOTE: Lead content originates from Brass components in valves and faucets and is certied under

NSF/ANSI 372 as containing less than 0.25% lead in wetted surfaces.

Notice for California Consumers

Tools Required

Tape measure

Adjustable wrench

Drill motor and drill bits

Pipe wrench

Level

Safety glasses

Screw drivers: phillips and standard

Pencil

Socket wrench

Installation Instructions

Step 1

1. 1. Attach upper and lower leg support brackets to legs with hardware (provided).

2. Place wash station sink on the leg assembly. Secure legs to bowl with hardware provided.

3. Place wash station sink at the desired location.

4. Mark the floor where the mounting holes are at the base of the legs. See illustration A.

5. Drill holes as required for mounting hardware. Hardware not included.

Step 2

1. Install Faucet to the sink using faucet mounting kit provided. We recommend using pipe thread

sealant instead of Teflon tape.

2. Install strainer assembly to the drain hole.

3. Connect hot and cold water supply lines (not included) to the back of faucets.

Step 3

1. Position wash station sinks to pre-drilled holes and secure sink to the floor.

2. Connect waste line or drain pipe to the strainer assembly. Not included.

3. Connect water supply lines (Hot and Cold) to the water source. Not included.

4. Remove aerator from the spout and flush the water system.

5. Replace aerator to the spout.

6. Check for leaks and tighten connections if necessary.

Step 4

1. Seal gap between bowl and leg assembly as shown in illustration B.

2. When mounting against wall, it is recommended sealing the top of the backsplash to wall as

shown on illustration C.

Installation Instructions

Step 1

1. 1. Attach upper and lower leg support brackets to legs with hardware (provided).

2. Place wash station sink on the leg assembly. Secure legs to bowl with hardware provided.

3. Place wash station sink at the desired location.

4. Mark the floor where the mounting holes are at the base of the legs. See illustration A.

5. Drill holes as required for mounting hardware. Hardware not included.

Step 2

1. Install Faucet to the sink using faucet mounting kit provided. We recommend using pipe thread

sealant instead of Teflon tape.

2. Install strainer assembly to the drain hole.

3. Connect hot and cold water supply lines (not included) to the back of faucets.

Step 3

1. Position wash station sinks to pre-drilled holes and secure sink to the floor.

2. Connect waste line or drain pipe to the strainer assembly. Not included.

3. Connect water supply lines (Hot and Cold) to the water source. Not included.

4. Remove aerator from the spout and flush the water system.

5. Replace aerator to the spout.

6. Check for leaks and tighten connections if necessary.

Step 4

1. Seal gap between bowl and leg assembly as shown in illustration B.

2. When mounting against wall, it is recommended sealing the top of the backsplash to wall as

shown on illustration C.

Illustration A

Illustration B

Illustration C

F L O O R M O U N T S I N K

COLUMBIA SPECIFICATIONS

800.626.2117 columbiasinks.com info@columbiasinks.com

Front Side

Top

Hole Conﬁgurations

.5” dia. Floor

Mounting

Holes 7.5”

on Center

1.5” Leg

Thickness

.75” From

Edge of Leg

to First Hole

Floor Mounting Detail

.875” [22mm]

dia. hole

8in

203.2mm

6in

152.4mm

6in

152.4mm

6.25in

158.8mm

Supply Line Detail

Back Splash

1/2”

Male NPT

Hot

from Wall

Cold

from Wall

9.5in

241.3mm

7in

178.9mm

27in

685.8mm

15.25in

387.4mm

6.25in

158.8mm

6in

152.4mm

8in

203.2mm

6in

152.4mm

20in

508mm

2in

50.8mm

14in

355.6mm

1.5in

38.1mm

1.5in

38.1mm

17in

431.8mm

17.5in

444.5mm

R.5in

12.7mm

2in

50.8mm

3.937in

100mm

45deg

R.75in

19.1mm

.75in

19.1mm

3in

76.2mm

12in

304.8mm

7.5in

190.5mm

2.25in

57.2mm

2.5in

63.5mm

15.5in

393.7mm

11in

279.4mm

Produktspecifikationer

Varumärke:	Sani-Lav
Kategori:	Sjunka
Modell:	727F
Färg på produkten:	Zwart
Vikt:	58550 g
Bredd:	1957 mm
Djup:	100 mm
Höjd:	1160 mm
Förpackningens vikt:	75900 g
Förpackningens bredd:	2110 mm
Djuppackning:	225 mm
Förpackningshöjd:	1283 mm
Användarmanual:	Ja
Mobila operativsystem som stöds:	Android 11.0
Blåtand:	Ja
Monteringsverktyg:	Ja
Skärm diagonal:	86 "
Upplösning:	3840 x 2160 Pixels
Pekskärm:	Ja
RAM-kapacitet:	4 GB
RAM-typ:	DDR3
Typ av anslutningskontakt:	3,5 mm
Ethernet LAN:	Ja
Betraktningsvinkel, horisontell:	178 °
Betraktningsvinkel, vertikal:	178 °
Medföljande kablar:	AC, HDMI, USB Type-C
Typiskt kontrastförhållande:	1200:1
Ljusstyrka:	410 cd/m²
Snabbstartsguide:	Ja
Ursprungsland:	China
Antal USB 2.0-portar:	1
VGA (D-Sub) port(ar):	1
Antal HDMI-portar:	3
Antal Ethernet LAN (RJ-45)-portar:	1
Inbyggda högtalare:	Ja
Antal inbyggda högtalare:	2
Strömförbrukning (i standby):	0.5 W
Strömförbrukning (max):	520 W
Certifiering:	CE, Energy Star, FCC, RoHS, UL, TUV, WEEE
Display, antal färger:	1,07 miljard kleuren
HD typ:	4K Ultra HD
Processorarkitektur:	ARM Cortex-A55
RS-232 port:	1
Ljudutgång:	1
Respons tid:	8 ms
Pixelpitch:	493.5 x 493.5 mm
VESA montering:	Ja
Panelmonteringsgränssnitt:	800 x 600 mm
Antireflexskärm:	Ja
Bildförhållande:	16:9
Kontrastförhållande (dynamisk):	4000:1
Ethernet LAN, dataöverföringshastigheter:	10,100,1000 Mbit/s
Stöder Windows:	Ja
Förvaringstemperatur:	-20 - 60 °C
Typ av panel:	IPS
LED backlight-type:	Direct-LED
Maximalt internminne:	32 GB
Förvaringsfuktighet:	10 - 90 procent
Mac-kompatibilitet:	Ja
Hårdhet:	9H
Antal samtidiga beröringspunkter:	20
Inkluderar en penna:	Ja
Power högtalare:	32 W
Antal USB Type-C-portar:	1
USB-kabelns längd:	1.8 m
Fjärrkontroll ingår:	Ja
Wifi:	Ja
AC-ingångsspänning:	100 - 240 V
AC-ingångsfrekvens:	50 - 60 Hz
Strömförbrukning (typiskt):	350 W
Drifttemperatur (TT):	0 - 40 °C
Relativ luftfuktighet i drift (VV):	10 - 90 procent
Batterier-ingår:	Ja
Antal paket:	1
Arbetsplats:	1895.04 x 1065.96 mm
Inbyggd projektor:	Nee
OPS-plats:	80