Sani-Lav U1818F Bruksanvisning
Läs nedan 📖 manual på svenska för Sani-Lav U1818F (6 sidor) i kategorin Sjunka. Denna guide var användbar för 5 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare
Sida 1/6
1
F L O O R M O U N T U T I L I T Y S I N K
Operating Manual for Floor Mount Stainless Steel Utility Sink
Models U1818F and U1818F-0.5
of Domestic and Foreign Parts
Columbia does not recommend use with harsh chemicals.
Product Compliance
NSF/ANSI 2 Food Equipment, NSF/ANSI 61, Section 9, ASME A112.18.1/CSA B125.1
2
C O L U M B I A S P E C I F I C AT I O N S
800.626.2117 columbiasinks.com info@columbiasinks.com
©2021 Columbia Products
F L O O R M O U N T U T I L I T Y S I N K
Installation Instructions
Step 1
1. 1. Attach upper and lower leg support brackets to legs with hardware (provided).
2. Place wash station sink on the leg assembly. Secure legs to bowl with hardware provided.
3. Place wash station sink at the desired location.
4. Mark the floor where the mounting holes are at the base of the legs. See illustration A.
5. Drill holes as required for mounting hardware. Hardware not included.
Step 2
1. Install Faucet to the sink using faucet mounting kit provided. We recommend using pipe thread
sealant instead of Teflon tape.
2. Install strainer assembly to the drain hole.
3. Connect hot and cold water supply lines (not included) to the back of faucets.
Step 3
1. Position wash station sinks to pre-drilled holes and secure sink to the floor.
2. Connect waste line or drain pipe to the strainer assembly. Not included.
3. Connect water supply lines (Hot and Cold) to the water source. Not included.
4. Remove aerator from the spout and flush the water system.
5. Replace aerator to the spout.
6. Check for leaks and tighten connections if necessary.
Step 4
1. Seal gap between bowl and leg assembly as shown in illustration B.
2. When mounting against wall, it is recommended sealing the top of the backsplash to wall as
shown on illustration C.
Parts List
(1) Floor mount sink
(1) Leg assembly set
(6) Nuts, bolts and washers for leg assembly
(4) Washers and nuts for connection sink to leg assembly set
(1) 8” on center faucet
(1) Faucet mounting kit
(1) Strainer assembly with basket
Trouble Shooting Guide
Problem Possible Cause To Diagnose Remedy
Water drips from
the spout or from
under the lever.
1. Seat washer is worn
2. Seat is worn
3. O-rings are worn
Shut cold water source off. See if
water still leaks from the spout. If
leaks continues repair hot side if
not repair cold side.
Recommend
installing hot
or cold faucet
repair kit.
Go to for more information on replacement parts and installation videos.columbiasinks.com
WARNING: This product can expose you to chemicals including Chromium (hexavalent compounds),
Lead, and Phthalates (DEHP) which are known to the State of California to cause cancer and birth defects
or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
NOTE: Lead content originates from Brass components in valves and faucets and is certied under
NSF/ANSI 372 as containing less than 0.25% lead in wetted surfaces.
Notice for California Consumers
Tools Required
Tape measure
Adjustable wrench
Drill motor and drill bits
Pipe wrench
Level
Safety glasses
Screw drivers: phillips and standard
Pencil
Socket wrench
Illustration A
Illustration B
Illustration C
7.5” (191mm)
45º
20.5” (520.7mm)
2” (51mm)
Hole Configurations
Front Side
12” (228.6mm)
1.5” (38mm)
14.75”(374.6mm)
25.5” (647.7mm)
4” (101.6mm)
21” (533.4mm)
10.5”
(266.7mm)
10.5”
(266.7mm)
20.5”
(520.7mm)
3.5” drain hole
(88.9mm)
17”
(431.8mm)
1.5” (38mm)
2” (51mm)
Top
18” (457.2mm)
10.5”
(266.7mm)
1.5” (38mm)
mounting holes
9” (228.6mm)
on center
.5” R
(12.7mm)
.5” R (12.7mm)
8” (203.2mm)
Floor Mounting Detail
.5” dia. Floor
Mounting Holes
9” on Center
1.5” Leg
Thickness
.75” From
Edge of Leg
to First Hole
Back Splash
Supply Line Detail
1/2” Male NPT
Hot
from Wall
Cold
from Wall
.875” (22mm)
dia. holes (2)
6.5”
(165.1mm)
6.5”
(165.1mm)
4.5” (114.3mm)
8”
(203.2mm)
3
C O L U M B I A S P E C I F I C AT I O N S
800.626.2117 columbiasinks.com info@columbiasinks.com
©2021 Columbia Products
F L O O R M O U N T U T I L I T Y S I N K
Produktspecifikationer
| Varumärke: | Sani-Lav |
| Kategori: | Sjunka |
| Modell: | U1818F |
Behöver du hjälp?
Om du behöver hjälp med Sani-Lav U1818F ställ en fråga nedan och andra användare kommer att svara dig
Sjunka Sani-Lav Manualer
10 September 2024
10 September 2024
10 September 2024
10 September 2024
10 September 2024
10 September 2024
10 September 2024
10 September 2024
10 September 2024
10 September 2024
Sjunka Manualer
- Sjunka Smeg
- Sjunka Teka
- Sjunka Hotpoint-Ariston
- Sjunka Kernau
- Sjunka Blaupunkt
- Sjunka Concept
- Sjunka CDA
- Sjunka Hendi
- Sjunka Blanco
- Sjunka Rangemaster
- Sjunka Gustavsberg
- Sjunka Franke
- Sjunka Leisure
- Sjunka Nodor
- Sjunka Elkay
- Sjunka Schock
- Sjunka Caple
- Sjunka Roca
- Sjunka Foster
- Sjunka Advance Tabco
- Sjunka Fulgor Milano
- Sjunka Laveo
- Sjunka Deante
- Sjunka Artusi
- Sjunka Tot Mate
- Sjunka Atosa
- Sjunka Kuchinox
- Sjunka Oliveri
- Sjunka Shaws
- Sjunka Seima
Nyaste Sjunka Manualer
8 Januari 2025
3 Januari 2025
2 Januari 2025
31 December 2025
31 December 2025
29 December 2024
29 December 2024
29 December 2024
28 December 2024
28 December 2024