Sharp SKMD30E9ES Bruksanvisning

Sharp Magnetron SKMD30E9ES

Läs nedan 📖 manual på svenska för Sharp SKMD30E9ES (12 sidor) i kategorin Magnetron. Denna guide var användbar för 4 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/12

E 1

30" EXTENSION KIT: SKMD30E9ES INSTALLATION INSTRUCTIONS

IMPORTANT NOTES TO THE INSTALLER

• Read all of the Installation Manual that is included with the Microwave Drawer before installing the extension kit.

• Observe all governing codes, ordinances, and safety instructions.

• Be sure to leave these instructions with the consumer.

Parts included:

Left Side Trim (qty. 1) Right Side Trim (qty. 1) Mounting Brackets (qty. 2)

Bracket Screws (qty. 8)

Trim Screws (qty. 4)

Install the extension kit after properly installing the microwave drawer in the cabinet. See steps below.

Note that the side trims are marked "L" and "R" on the back side.

T I N S KB 28 9M R R 0

MICROWAVE DRAWER STANDARD MOUNT, MEASUREMENTS AND INSTALLATION INSTRUCTIONS

JA. 215/8" (549.28 mm)

B. 411 /16" (119.06 mm)

C. 13/4" (44.45 mm)

D. 217/8" (555.63 mm)

E. 235/8" (600.07 mm)

F. 16" (406.4 mm)

G. 1419/ " (370.68 mm)32

H. 117/ " (38.89 mm) door thickness32

I. 15" (381 mm) auto drawer opening

J. 4" (101.60 mm)

Figure 1

E 2

1. Prepare cabinet opening as shown in Figure 2.

2. Place the drawer adjacent to the wall or cabinet opening. Plug the

power supply cord into the electrical outlet.

3. Carefully guide the drawer into the prepared opening. Avoid

contact with the sides of the cutout opening and pinching the cord

between the oven and the wall.

4. Slidethedrawerallthewaybackuntilthesiderailsareushwith

the face of the cabinet.

5. Open the drawer. Using the 4 holes on the drawer as a template,

pre-drill the cabinet using a

1/16" (1.6 mm) bit. Secure the drawer

with the 4 screws supplied. See Figure 3.

Side

Rail

Figure 3

6. Close drawer to complete oven installation. See Figure 4.

Figure 4

Figure 2

A. 6" (152.40 mm)

B. Suggested electrical outlet location*

C. Anti-Tip block

D. 5" (127 mm)

E. 31

/2" (88.90 mm)

F. 4" (101.60 mm)

G. 221/8" (561.98 mm) opening

H. 1413

/16" (376.24 mm) to bottom of Anti-Tip block

I. Allow 7/8" (22.22 mm) overlap

J. 231/2" (596.90 mm) minimum depth

K. Allow 7/16" (11.11 mm) overlap

L. 36" (914.40 mm) countertop height

M. Allow 7/16" (11.11 mm) minimum space

N. Floor must support 100 lb (45.4 kg)

O. Allow 41/8" (104.4 mm) minimum space

P. 159/16" (395.3 mm) opening

Q. 30" (762.0 mm) minimum width

Figures 1 and 2 contain many Microwave Drawer measurements for

reference when planning the drawer’s location.

This Microwave Drawer can be installed below any electric or gas

wall oven.

* Can also be installed using an electrical outlet in an adjacent

cabinet within the area where the provided electrical cord can

reach. Power cord access hole in cabinet should be a minimum

11/ " diameter hole and deburred of all sharp edges.2

IMPO RTANT Always allow sufcient power cord length to the

electrical outlet to prevent tension.

Always check electrical codes for requirements.

E 3

7. Remove the 2 trim screws from each mounting bracket to begin

installation.

Note: The mounting brackets come assembled to the side

trims.

8. Open the drawer to properly align brackets to microwave side

rails. See Figure 5.

Bracket

Side rails

Align sides and bottom of the 30"

mounting brackets to the sides and bottom

of the microwave drawer side rails

Figure 5

9. Using the 4 holes on each bracket as a template, pre-drill the

cabinet using a 1/16" (1.6 mm) bit. Secure the mounting brackets

to cabinet with the 8 bracket screws provided. See Figure 6.

Figure 6

10. Place side trims on top of the mounting brackets, aligning the

screw holes.

Note: Each side trim is marked "L" and "R" on the back

side to indicate Left and Right.

11. Mount the Left and Right 30" trim extensions using the 4 trim

screws provided. See Figure 7.

Figure 7

Produktspecifikationer

Varumärke:	Sharp
Kategori:	Magnetron
Modell:	SKMD30E9ES
Färg på produkten:	Zwart
Snäll:	Blender voor op aanrecht
Antal hastigheter:	5
Tillgångar:	1000 W
Innehåll behållare/burk:	1.5 l
Varierande hastighet:	Ja
Antihalkfötter:	Ja
Turboknapp:	Ja
Knivmaterial:	Roestvrijstaal
Blandningsskålsmaterial:	Glas