Siemens WT46W572DN Bruksanvisning

Siemens Torktumlare WT46W572DN

Läs nedan 📖 manual på svenska för Siemens WT46W572DN (4 sidor) i kategorin Torktumlare. Denna guide var användbar för 12 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/4

Dryer

This leaflet provides you with a brief overview of the important information and improvements

that you need to know about your new dryer before using it for the first time.

If you think that the laundry is slightly too damp, use the fine adjustment for the drying

result. You can find instructions on how to set required degrees of dryness in the

section “Fine adjustment of the drying result” or “Adjust drying level” in your

instructions for use.

If you are drying thin and thick or multi-layered fabrics together, these will dry

differently. To ensure that the laundry dries evenly, you must sort it according to the

type of fabric and the structure. If required, select a time programme to finish the

drying.

Take note of whether the drying cycle was interrupted after a service display (for

example, Empty the container or Please empty the condensation container, or Clean

the fluff filter or Please clean the lint filter), which means that the drying cycle is not

yet complete. Correct the fault and continue the programme. See the chapter “What

to do if...” in the instructions for use.

Residual moisture from the laundry

The laundry feels slightly damper

The laundry is not evenly dry…

The laundry is still noticeably damp…

The main points to begin with en

During drying, fluff and hair from the laundry is trapped by the fluff filter.

A blocked or partially cleaned fluff filter reduces the flow of air. This

means that the dryer does not reach its maximum performance. The

fluff filter must therefore be cleaned after each drying cycle. Rinse the

filter regularly under running water and carefully dry it. See also the

notes on “Care and cleaning” in the instruction manual.

After each drying cycle

Cleaning the fluff filter

After each drying cycle, empty the condensation container because,

under certain circumstances, the next drying programme will be

cancelled as a result of the condensation container being full. You must

also regularly clean the filter in the condensation container under

running water or in the dishwasher. See also the information on “Care

and cleaning” in the instruction manual.

Emptying the condensation container

Further important information can be found in your instructions for use and installation manual

or care instructions. Pay particular attention to the chapter “What to do if...” and “After-sales

service”.

– Warm laundry feels damper than it actually is.

– Thanks to the heat pump technology, your laundry is always dried at gentle

temperatures in any programme.

However, you must observe the maximum load and type of laundry in order to

achieve optimum results.

– You must also observe the information in the chapter “Notes on laundry” in the

instructions for use.

The fluff filters and condensation containers must always be

cleaned or emptied after each drying cycle.

9110/ 9000689281

*689281*

Normal noise during operation Information

Before putting your laundry into the dryer, remove all objects

(especially lighters, metal parts or similar objects) from

pockets. Note the maximum load quantity. You must also

observe the information in the chapter “Notes on laundry” in

the instruction manual.

Removing objects before drying

The buttons are sensitive and it is sufficient to lightly touch them. If you select a button

more than once (especially when setting the options), then you must let the button go

after each selection in order to activate the sensor. Your selection will be followed by

a button acknowledgement.

Selecting buttons more than once

The drying operation can be paused for a short period to add more laundry, remove

laundry or for programme changes. Depending on the model, the display “Finished

in” is reset and restarted or stopped. After a while, the display is then corrected. To

ensure that the heat exchanger is automatically cleaned, programmes must then

always be allowed to continue until they end. Do not cancel a drying cycle before the

programme automatically ends.

Interrupting/changing the programme

Cleaning agents and agents for pretreating laundry (e.g. stain removers, prewash

sprays, etc.) must not come into contact with the surfaces of the dryer. If necessary,

immediately wipe away spray residue and other residues/droplets with a damp cloth.

You must also observe the information in the chapter “Care and cleaning” in the

instruction manual.

Laundry additives/care and cleaning

When a programme is selected, the anticipated drying time for the maximum load is

displayed. While drying, the appliance's sensors detect the actual load and its level

of moisture, and they correct the programme length. This is shown in the display by

jumps in the “Finished in” time.

“Finished in” appears in the display

--:--

The compressor in the dryer generates a humming noise. The

volume and pitch of this may vary.

Humming noise

From time to time, the compressor in the dryer is cooled by a fan

and this creates a whirring sound.

Whirring

The start of the automatic cleaning cycle for the heat exchanger

causes a clicking noise.

Clicking

Rushing water can be heard during the automatic cleaning cycle.

Noise

The process of pumping the condensation into the condensation

container generates pumping noises.

Pumping

Rattling noises may be caused by the laundry moving if hard parts,

such as buttons, zips, buckles or similar parts, are part of the

laundry.

Rattling

Humming...

Click...

Shsh...

Slurp...

Sssssss...

Rattle...

Please note: During drying, the compressor, the pump and the movement of the laun-

dry generate noises which are entirely normal.

During the automatic cleaning cycle, “cln”

(Clean) or “Heat exchanger is being rinsed”

appears in the display.

During the automatic cleaning cycle, “cln”

(Clean) or “Heat exchanger is being rinsed”

appears in the display.

You must pay particular attention to the safety information and the chapter “What to

do if...” in the instructions for use.

Produktspecifikationer

Varumärke:	Siemens
Kategori:	Torktumlare
Modell:	WT46W572DN
Enhetsplacering:	Vrijstaand
Färg på produkten:	Zilver
Dörrgångjärn:	Rechts
Inbyggd display:	Ja
Vikt:	74000 g
Bredd:	595 mm
Djup:	651 mm
Höjd:	1726 mm
Barnlås:	Ja
Frys nettokapacitet:	86 l
Avfrostningsfunktion:	Ja
Dörröppningsriktning utbytbar:	Ja
Kylskåpets nettokapacitet:	178 l
Kylskåp invändig belysning:	Ja
Antal hyllor i kylskåp:	7
Antal fryshyllor:	3
antal stjärnor:	4*
Total nettokapacitet:	264 l
Äggställ:	Ja
Inbyggd frys:	Ja
Strömförsörjning:	AC 220 - 240V, 50Hz
Larm för öppen dörr:	Ja
Energianvändning per dag:	0.96 kWh/24u
Antibakteriell funktion:	Ja
Iskubshållare:	Ja