Sony SRS-XB100 Bruksanvisning

Sony högtalare SRS-XB100

Läs nedan 📖 manual på svenska för Sony SRS-XB100 (3 sidor) i kategorin högtalare. Denna guide var användbar för 8 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/3

5-047-815- (1)41

SRS-XB100 Model: YY7856E

Printed in China

https://www.sony.net/

Wireless Speaker

Reference Guide

Model: YY7856E

The term “product” in this document refers to the unit or its accessories.

Do not expose the unit to naked flame sources (for example, lighted

candles).

Do not install the product in a confined space, such as a bookcase or

built-in cabinet.

The nameplate and important information concerning safety are

attached in the following locations:

• the bottom of the unit

Do not expose the batteries (battery pack or batteries installed) to

excessive heat, such as sunshine, fire or the like, for a long time.

Do not subject the batteries to extreme low temperature conditions that

may result in overheating and thermal runaway.

Do not dismantle, open, or shred secondary batteries.

In the event of a secondary battery leaking, do not allow the liquid to

come in contact with the skin or eyes. If contact has been made, wash

the affected area with copious amounts of water and seek medical

advice.

Secondary batteries need to be charged before use. Always refer to

the manufacturer’s instructions or product manual for proper charging

instructions.

After extended periods of storage, it may be necessary to charge and

discharge the secondary batteries several times to obtain maximum

performance.

Dispose of properly.

This product has magnet(s) which may interfere with pacemakers,

programmable shunt valves for hydrocephalus treatment, or other

medical devices. Do not place this product close to persons who use

such medical devices. Consult your doctor before using this product if

you use any such medical device.

This unit has been tested and found to comply with the limits set out in

the EMC regulation using a connection cable shorter than 3 m.

Never insert the USB plug when the main unit or charging cable is wet.

If the USB plug is inserted while the main unit or charging cable is wet,

a short circuit may occur due to liquid (tap water, seawater, soft drink,

etc.) or foreign matter on the main unit or charging cable, and cause

abnormal heat generation or malfunction.

Licenses

• This product contains software that Sony uses under a licensing

agreement with the owner of its copyright. We are obligated to

announce the contents of the agreement to customers under

requirement by the owner of copyright for the software. Please

access the following URL and read the contents of the license.

https://rd1.sony.net/help/speaker/sl/23c/

• Use of the Made for Apple badge means that an accessory has

been designed to connect specifically to the Apple product(s)

identified in the badge, and has been certified by the developer

to meet Apple performance standards. Apple is not responsible

for the operation of this device or its compliance with safety and

regulatory standards.

Disclaimer regarding services offered by third parties

• Services offered by third parties may be changed, suspended,

or terminated without prior notice. Sony does not bear any

responsibility in these sorts of situations.

Notes on waterproof and dustproof

features

(Read before using the unit)

The supplied accessories are neither waterproof nor

dustproof.

Waterproof and dustproof performance of the unit

The unit, with the cap fastened securely, has a waterproof specification

of IPX7 as specified in “Degree of protection against water immersion”

of the IEC60529 “Ingress Protection Rating (IP Code)”, and a dustproof

specification of IP6X as specified in “Degrees of protection against solid

foreign objects”.

• The supplied accessories and the connectors of this unit (USB) are

neither water resistant nor dustproof. To reduce the risk of fires or

electric shocks, do not expose the unit to water or droplets while using

any connectors (USB).

Note that malfunctions as a result of water immersion or dust

intrusion caused by misuse by the customer are not covered by the

warranty.

To avoid the deterioration of waterproof and

dustproof performance

Carefully note the precautions below to ensure proper use of the unit.

• This unit does not have a design that is resistant to water pressure. Use

of the unit in a location where high water pressure is applied, such as

in the shower, may cause a malfunction.

• Do not pour high-temperature water or blow hot air from a hair dryer

or any other appliance on the unit directly. Also never use the unit in a

place subject to high temperatures, such as in a sauna or near a heat

source.

CAUTION : Handle the cap with care. The cap plays a very

important role in maintenance of the water resistant and dustproof

performance. When using the unit, make sure that the cap is closed

completely. When closing the cap, be careful not to allow foreign objects

inside. If the cap is not closed completely the water resistant and

dustproof performance may deteriorate and may cause a malfunction of

the unit as a result of water or dust particles entering the unit.

Cap

Passive radiator

How to care for the unit

You can use the unit more comfortably and for a longer period of time

by following the maintenance procedure below.

• If the surface of the unit gets dirty in the following cases, wash the unit

with fresh water (tap water, etc.) promptly to remove the dirt. Leaving

dirt on its surface may cause the surface to discolor or deteriorate, or

the unit to malfunction.

Ex.

– When salt, sand, etc. is stuck on the unit after using it on a beach,

pool side, etc.

– When the unit is stained with foreign substances (sunscreen, suntan

oil, etc.)

• The sound quality may change when water enters the speaker or

passive radiator section of the unit. It is not malfunction. Wipe off the

moisture on its surface, and put the unit on a dry soft cloth to drain the

collected water inside the unit. Then, dry the unit in an airy place until

no moisture remains.

Note

• If the surface of the unit gets dirty, do not use detergent, thinner,

benzine, alcohol, etc. to clean the unit because it will affect the water

repellent function of the unit.

• Especially in cold regions, be sure to wipe off the moisture after using

the unit. Leaving moisture on its surface may cause the unit to freeze

and malfunction.

Precautions

On placement

• To eliminate the risk of malfunctions, avoid the following locations

when placing or leaving this unit.

– A place subject to high temperatures, such as under direct sunlight or

lighting equipment, near a heat source, or in a sauna

– Inside a vehicle with the windows closed (especially in summertime)

– A place exposed to hot air, such as from a hair dryer

• Place this unit on a flat, level surface. When placed on a sloped surface,

the unit may fall over or fall off the surface due to its own vibration,

resulting in injuries, malfunctions, or performance degradation.

• Depending on the conditions where this unit is placed, it may fall over

or fall off the surface. Do not leave any valuables near the unit.

• This unit is not anti-magnetic. Keep objects susceptible to magnetism

(recorded tapes, watches, cash cards and credit cards with magnetic

coding, etc.) away from the unit. When you carry around the unit, keep

this in mind as well.

Other notes

• Do not use or leave the unit in an extremely cold or hot environment

(temperature outside the range of 5 °C – 35 °C). If the unit is used or left

in outside the above range, the unit may automatically stop to protect

internal circuitry.

• If you use this unit for a long time, the temperature of this unit may

rise, but it is not a malfunction.

• At high temperature, the charging may stop or the volume may reduce

to protect the battery.

• Even if you do not intend to use the unit for a long time, charge

the battery to its full capacity once every 6 months to maintain its

performance.

Trademarks

• Android is a trademark of Google LLC.

• The BLUETOOTH® word mark and logos are registered trademarks

owned by Bluetooth SIG, Inc. and any use of such marks by

Sony Group Corporation and its subsidiaries is under license.

• Apple, the Apple logo, iPhone, iPod and iPod touch are trademarks of

Apple Inc., registered in the U.S. and other countries.

• IOS is a trademark or registered trademark of Cisco in the U.S. and

other countries and is used under license.

• USB Type-C® and USB-C® are registered trademarks of

USB Implementers Forum.

All other trademarks and registered trademarks are trademarks or

registered trademarks of their respective holders. In this manual, ™ and

® marks are not specified.

Specifications

BLUETOOTH®

Frequency band 2.4 GHz band (2.400 0 GHz - 2.483 5 GHz)

General

Power DC 5 V 0.5 A (using a commercially-available USB AC

adaptor capable of feeding in 0.5 A (500 mA)) or, using

built-in lithium-ion battery

Lithium-ion battery life

Approx. 16 hours*1

– Volume level: 36

Approx. 5 hours*1

– Volume level: 50 (MAX.)

Time required for charging the built-in rechargeable battery

Approx. 4.5 hours*2 *3

Operating temperatures

5 °C – 35 °C

Battery charging temperatures

5 °C – 35 °C

Dimensions (including projecting parts and controls)

Approx. mm × 95 mm (dia × h)76

Mass (including battery)

Approx. g274

Included items Wireless Speaker (1)

USB Type-C® cable (USB-A to USB-C)*4 (1)

Strap (1) (attached to the unit)

Documents (1 set)

*1 The built-in battery life above is measured using our specified music

source. Actual performance time may vary from the listed time due

to the volume, songs played, surrounding temperature, and usage

conditions.

*2 Time required for the empty battery to be fully charged (100%) while

the unit is powered off.

*3 Provided that a USB AC adaptor capable of delivering an output

current of 0.5 A (500 mA) is used for battery charging connection.

A charging cable exclusively designed for the unit. Do not use the

cable for any other purposes.

System requirements for charging battery using USB

Using a commercially-available USB AC adaptor capable of delivering an

output current of DC 5 V 0.5 A (500 mA).

Design and specifications are subject to change without notice.

https://rd1.sony.net/help/speaker/7856/h_zz/

Produktspecifikationer

Varumärke:	Sony
Kategori:	högtalare
Modell:	SRS-XB100
Färg på produkten:	Zwart
Vikt:	60 g
Bredd:	60 mm
Djup:	93 mm
Höjd:	7.8 mm
Sladdlängd:	0.05 m
Förpackningens vikt:	66 g
Förpackningens bredd:	85 mm
Djuppackning:	160 mm
Förpackningshöjd:	15 mm
Användarmanual:	Ja
LED-indikatorer:	Stroom
Batterikapacitet:	2500 mAh
Nuvarande:	1 A
Medföljande kablar:	Lightning, USB
Ursprungsland:	China
Certifiering:	CE, FCC
Form:	Rechthoek
Hållbarhetscertifikat:	RoHS
Inspänning:	5 V
Laddningskälla:	USB
Kompatibla produkter:	iPhone 4S, iPhone 5S, iPhone 5c, IPhone 6, IPhone 6S, IPhone 6 Plus, IPhone 6S Plus, Galaxy S5, Galaxy S6
Utström:	1 A
Spännande:	5 V
Laddare kompatibilitet:	Mobile phone/Smartphone, Tablet, MP3/MP4, GPS, E-book reader
Antal samtidigt anslutna enheter (max):	1
Mikro-USB-kontakt:	Ja
Antal mikro-USB-anslutningar:	1
Lightning-kontakt:	Ja
Batteriteknik:	Lithium-Polymeer (LiPo)
Antal battericeller:	1
Antal adaptrar ingår:	1 stuk(s)
Antal laddningscykler:	500
Laddningstid för batteri/ackumulator (USB):	4 uur
Medföljande adaptrar:	Lightning