Summit RHW20 Bruksanvisning

Summit Fläktkåpa RHW20

Läs nedan 📖 manual på svenska för Summit RHW20 (4 sidor) i kategorin Fläktkåpa. Denna guide var användbar för 4 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF
Sida 1/4
INSTALLATION INSTRUCTIONS
READ AND SAVE
Summit Appliance Range Hoods
THESE INSTRUCTIONS
Warning: TO REDUCE THE RISK OF FIRE OR ELECTRICAL SHOCK, DO NOT USE THIS FAN WITH ANY
SOLID- STATE SPEED CONTROL.
Warning: TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, OR INJURY TO PERSONS, OBSERVE THE
FOLLOWING:
A. Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer.
B. Before servicing or cleaning the unit, switch power to “OFF” at the service panel and lock the service, disconnecting means to prevent power from
being switched on accidentally. When service-disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag
to service panel.
Caution: For general ventilation only. Do not use to exhaust hazardous or explosive material or vapors.
Warning: TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:
A. Never leave surface units unattended at high settings. Boilovers cause smoking and greasy spillover that may ignite. Heat oils slowly on low /
medium settings.
B. Always turn ON when cooking at high heat or when ambeing foods (i.e. Crepes Suzette, Cherries Jubilee, Peppercorn Beef Flambe’).
C. Clean ventilating fans frequently. Grease should not be allowed to accumulate on fan or lter.
D. Use proper pan size. Always use cookware appropriate for the size of the surface element.
Warning: TO REDUCE THE RISK OF INJURY TO PERSON IN THE EVENT OF A RANGE TOP GREASE FIRE,
OBSERVE THE FOLLOWING:
A. SMOTHER FLAME with a close tting lid, cookie sheet or metal tray, then turn burner o. BE CAREFUL TO PREVENT BURNS. IF the ames
do not go out immediately, EVACUATE AND CALL THE FIRE DEPARTMENT.
B. NEVER PICK UP A FLAMING PAN. YOU MAY GET BURNED!
C. including wet dish clothes and towels; a violent steam explosion will result.DO NOT USE WATER,
D. Use extinguisher, ONLY if:
1. You know you have a class ABC extinguisher, and you know how to operate it.
2. The re is small and contained in the area where it started.
3. The re department is being called.
4. You can ght the re with your back to an exit!
Warning: TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, OR INJURY TO PERSON, OBSERVE THE
FOLLOWING:
A. Installation work and electrical wiring must be done by qualied person(s) in accordance with all applicable codes and standards, including re-
rated construction codes and standards.
B. Sucient air is needed for proper combustion and exhausting of gases through the ue (chimney) of fuel burning equipment to prevent back
drafting. Follow the heating equipment manufacturer’s guideline and safety standards, such as those published by the National Fire Protection
Association (NFPA), and the American Society for Heating, Refrigeration, and Air Condition Engineers (ASHRAE) and the local code authorities.
C. When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.
D. Ducted fans must always be vented to the outdoors.
Warning: TO REDUC TH RISK OF FIRE, U METAL DUCTWORK ONLY! E E SE
Caution: T avoid re, electrical hock, or njury turn o circuit breaker to power upply re servicing. Switches e the rocker tyle switches. o s i , s befo ar s
The light switch is an “ON”, “OFF” witch. The motor witch, also a rocker tyle, is a 2-speed switc with a “LOW PEED” to the left and “HIGH s s s h S
SPEED” to the right. The aluminum lter hould be removed frequently washed in hot detergent water. Rinse in clear, warm water and shake o s and
excess oisture before replacing. The charcoal lter hould not be washed, but may wiped o periodically with a damp cloth. This lter hould be m s be s
replaced every ix onths! In cleaning, never e scouring powder r teel , as s ill ar the nish. Removelter and motor sembly s m us o s wool pads thi w m as
for equent cleaning. Clean entire hood and lter with hot water d mild household detergent. Exercise care when using cleaning agents fr an or
detergents of the fan. All done by due to possible deterioration of electrical components repair should be work qualied personnel. Should
replacement parts be required refer to the ood model and appropriate part number all hoods hnumber in correspondence. Range are either ducted or
ductless. Ducted with aluminum a round, rectangular, or 500 EZV, 1600EZV). Ductless oods hoods, lter come with either EZV models (1200, 1600, h
with charcoal lters are re-circulating models (500 require outside venting. When venting to the outside, EZV, 1600 EZV, or oods 1700). Ducted h
make sure the duct run is to avoid the use of elbows Use duct tape on all as short as possible. Try in the duct run. joints! Do not use a duct smaller
than discharge on the hood. Discharged air must be directed to the building’s exterior.
CAUTION – To e e reduc th risk of fir e and o t properly exhaust air, sur t duct air outsid D not vent exhaust air be e o e – o
int spaces wit in walls or ceilings or int attics, crawl spaces, or garages.o h o
CAUTION – To reduce th e risk of fir a e nd electric shock, install this ran hood only wit Integral Blowers man ge h ufactured
by UMI for t model y have. he ou
Item No. 0 -00-001 Revised: 07/24/12 AH
Item No. 0 -00-001 Revised: 07/24/12 AH
Caution: Turn off electrical power first!
1. Your Air -O -t H has been test packag readyood ed and ed o-use, requiri n further assembly, only installation. ng o
2. After removin from carton, slid out aluminum mes greas filter.g hood e h e
3. Unscrew remov t electrical outlet box cover locat at t si of t motor compartment. and e he ed he de he
4. Positi hood against cabinet bottom wit back against wall. Mark hol locations, t lay h aside. Driv #10on h 4 e hen ood e
screws halfway int thes locations and remove. If necessary t us furri strips t provi soli bas for o e o e ng o de a d e
mounting. Th bottom of t rang hood shoul install minimum of 30” abov cooking surface. e he e d be ed a e
5. For venti Air oods, mark t duct hol location bottom of cabinet or vertical wall a cutout. For roundng -O-H he e on nd
duct models, install damper i duct collar wit butterfly louvers openi upward. For rectangular ¼” x 10” duct n h ng 3
models, reinstall t damper assembly. O back mount dampers t hin pivot shoul b at t top; top he n ed he ge d e he on
mounted, t hi shoul i t back. he nge d be n he
6. Bri 12 volt power cabl throug wall or cabinet. Install approv 7/8” power supply connector (not ng 0 e h an ed
furnished).
7. Positi hood screw holes at bottom of cabinet. Bri power cabl through connector, vent modelson on 4 ng e and on ed
seal ductwork over duct collar. Ali hoo wit cabinet tight screws. gn d h and en
8. Connect t black wir from t power supply cabl t t black wir i t electrical outlet box. Repeat procedure he e he e o he e n he
wit t white wires usi wir nuts or any other suitabl insulat connector. Groun t unit accordi t localh he ng e e ed d he ng o
code. Replac t electrical outlet box cover. e he
9. O vent models, secure ductwork t collar wit sheet metal screws or furnac tape. B sur t damper shuttern ed o h e e e he
moves fre ely.
10. Instal maximu 60l m -watt light bulb.
11. hReplac filter or filters. Tur electrical power your e n on and o is now ready t use.od o
Item No. 0 -00-001 Revised: 07/24/12 AH
EZ-Vent INSTALLATION
INSTRUCTIONS
Models: 1600 Series
Below are four types of ventilation options available with the 1600 series range hoods.
7” Round, Vertical Discharge
Knock-out both top openings. Mount the duct work to the 7”
round discharge recessed into the top of the hood. Be cautious
not to block the fan or damper blades with screws. Remove the
charcoal filter pad, baffle plate, and 3”x10” damper and discard.
An optional 7” round damper is available (part number 5AH-35-
707).
3 1/4” x 10”, Vertical Discharge (from top of hood)
Knock-out top 3”x10” duct opening near the back. Attach 3”x10”
damper plate on the top of the hood with damper blade opening
to a vertical position. Remove charcoal filter pad and discard.
For best results, seal all seams with duct tape.
3 1/4” x 10”, Horizontal Discharge (from rear of hood)
Knock-out rear 3”x10” duct opening. Attach 3”x10” damper
plate on the back of the hood with damper blade opening to
horizontal position. Remove charcoal filter pad and discard.
For best results, seal all seams with duct tape.
Re- - circulating (non vented / ductless)
The range hood is shipped in this configuration. No
modifications are required.
Remove Phillips head screw holding in the baffle plate and
discard both.
Remove Phillips head screw holding 3”x10” damper plate and
discard both. For best results, seal all seams with duct tape.
** Revision 2/09 – Electrical cut-
out is
now located on the opposite side
than shown. While facing the hood
it is now located on the right- side
rear. We no longer provide an
electrical cut-out on the rear.

Produktspecifikationer

Varumärke: Summit
Kategori: Fläktkåpa
Modell: RHW20

Behöver du hjälp?

Om du behöver hjälp med Summit RHW20 ställ en fråga nedan och andra användare kommer att svara dig


Fläktkåpa Summit Manualer

Summit

Summit SEH3636SSADA Bruksanvisning

29 September 2024
Summit

Summit SEH4624SS Bruksanvisning

29 September 2024
Summit

Summit SEH3630SSADA Bruksanvisning

29 September 2024
Summit

Summit SEH4624SSADA Bruksanvisning

29 September 2024
Summit

Summit SEH4630SS Bruksanvisning

29 September 2024
Summit

Summit SEH4630SSADA Bruksanvisning

29 September 2024
Summit

Summit SEH4636SS Bruksanvisning

29 September 2024
Summit

Summit SEH4636SSADA Bruksanvisning

29 September 2024
Summit

Summit SEH1536SS Bruksanvisning

29 September 2024
Summit

Summit HC20WWADA Bruksanvisning

29 September 2024

Fläktkåpa Manualer

Nyaste Fläktkåpa Manualer

Neff

Neff D61MAC1X0B Bruksanvisning

27 Oktober 2024
Klarstein

Klarstein 10033709 Bruksanvisning

27 Oktober 2024
Halifax

Halifax FTHI740K Bruksanvisning

27 Oktober 2024
Hoover

Hoover HDTI6500/1X Bruksanvisning

27 Oktober 2024
Heinner

Heinner HTCH-440FS Bruksanvisning

27 Oktober 2024
ATAG

ATAG WG411V Bruksanvisning

27 Oktober 2024
Broan

Broan BKDB136WW Bruksanvisning

27 Oktober 2024
XO

XO R30SC Bruksanvisning

26 Oktober 2024
IKEA

IKEA DATID HW570 Bruksanvisning

24 Oktober 2024
Candy

Candy CDG6MB Bruksanvisning

24 Oktober 2024