Svan SVEC4RN1 Bruksanvisning

Svan Ugn SVEC4RN1

Läs nedan 📖 manual på svenska för Svan SVEC4RN1 (17 sidor) i kategorin Ugn. Denna guide var användbar för 2 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Sida 1/17
INSTRUCTIONS FOR THE
INSTALLATION
MODELO: SVEC3BF
SVE3BF
SVEC4BF
SVE5B1
SVEC5BF
SVEC3W
SVEC2BF
SVEC1BF
SVE4BW3
SVE4B3
SVEC4RN1
SVEC4RC1
User’s instructions
Igniting the burners
In these models the knob controls both ignition and the safety
device. Proceed as follows to ignite the burners:
1) Turn the chosen knob.
2) Keep the knob strongly pressed in for 3/4 seconds to permit
the spark to light the gas
that exits from the flametamer and to permit the thermocouple
to heat up.
3) Release the knob after about 3/4 seconds and adjust the
flame as desired, rotating
the knob anti-clockwise. Repeat points 1 and 2 if the flame
does not remain on.
Using the burners
For greater efficiency and less gas consumption use pots and
pans with the right diameters for the burners. Avoid having flames
extending out from underneath the pans (refer to the table).
Table of recommended pans
Burner Ø Pan diameter in cm
Auxiliary
Semi rapid
Rapid
Triple ring
from dia. 8 to dia. 14
from dia. 14 to dia. 20
from dia. 20 to dia. 28
Above dia. 26
Automatic safety valves
This safety device automatically closes the gas valve if the
inconvenience caused by failure to comply with this rule.
CLEANING AND MAINTENANCE
GENERAL
Cleaning and maintenance should be carried out with the
appliance cold especially when cleaning the enamelled parts.
Avoid leaving alkaline or acid substances(lemon juice,vinegar
2
etc.)on the surfaces.
Avoid using acid or chlorine-based cleaning products.
ENAMELLED PARTS
All of the enamelled parts must be washed only with a sponge
and soapy water or with non-abrasive products.
BURNERS AND GRIDS
These parts can be removed and cleaned with appropriate
products.
After cleaning ,the burners and their flame distributors must be
well dried and correctly replaced.
It is very important to check that the burner flame distributor F
and the cap C has been correctly positioned ( fig. 6) -failure to do
so can cause serious problems.
Check that the electrode S is always clean to ensure trouble-free
sparking.
Check that the probe T is always clean to ensure correct
operation of the safety valves ( for models with safety device ).
Both the probe and ignition plug must be very carefully cleaned
GAS TAPS
Periodic lubrication of the gas taps must be carried out by
specialist personnel only.
In the event of operating faults in the gas taps, call the Service
Department.
3

Produktspecifikationer

Varumärke: Svan
Kategori: Ugn
Modell: SVEC4RN1

Behöver du hjälp?

Om du behöver hjälp med Svan SVEC4RN1 ställ en fråga nedan och andra användare kommer att svara dig




Ugn Svan Manualer

Ugn Manualer

Nyaste Ugn Manualer