Swann Pro-661 Bruksanvisning

Swann övervakningskamera Pro-661

Läs nedan 📖 manual på svenska för Swann Pro-661 (4 sidor) i kategorin övervakningskamera. Denna guide var användbar för 12 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/4

FCC Veriﬁ cation

This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to part 15 of

the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used

in accordance with the instructions, may cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

• Reorient or relocate the receiving antenna

• Increase the separation between the equipment and the receiver

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected

• Consult the dealer or an experienced radio/TV technician for help

WARNING: Modiﬁ cations not approved by the party responsible for compliance could void user’s authority to

operate the equipment.

PRO-661 Dome

English

222

Congratulations on your purchase of this PRO-661 from Swann! You’ve chosen

well: we think this is one of the ﬁ nest CCTV video cameras available. The PRO-661

is great for monitoring a wide open space whilst maintaining a high level of detail,

even in low-light situations.

Placement Guide

The PRO-661 has a 3.6mm built-in which allows it to see almost wide-angle lens

80 degrees horizontally. What does this mean for you when placing it?

• You will be able to see a really

wide area. If it’s mounted high up

in a square corner, you’ll probably be

able to see along both walls. You’ll

be able to monitor a large area with

only one camera.

• Things may look further away than

they really are. Anything further

than a few meters (ten feet or so)

from the camera may appear to be

too small for the level of detail you

require.

• Vertical and horizontal lines might appear curved when they near the edge of

the camera’s view. This is normal, and it’s the side effect of cramming so much

viewing area onto one screen.

The PRO-661 is great for monitoring rooms or areas as wide as, or wider than, they

are long. For really wide areas, you may need a second camera.

Typically, it is best mounted in a corner looking across and down into the room,

so that it can look over intervening obstacles. The higher the ceiling the camera is

mounted on, the more it will be able to see and the harder it’ll be for an intruder

to access the camera or interfere with it.

Tips:

• Try to aim the camera at an area which is evenly lit, as objects or people in shadows

near brightly lit objects are very hard to see.

• It’s better to have the camera in the shade looking into the light than vice-versa.

• Avoid having bright light sources in your image. This includes the obvious (such as the

sun or an artiﬁ cial light source) but also things such as reﬂ ections. Cars are notorious

for reﬂ ected light sources, as are buildings with a lot of windows, mirrors and so forth.

80° 10m

33ft

16.8m

55ft

Technical Speciﬁ cations

Video

Image Sensor 1/3” CCD

Video Quality TV Lines 600

Effective Pixels NTSC: 768 x 494

PAL: 752 x 582

Min. Illumination 0.1 Lux

White Balance Automatic / Custom / Manual

Electronic Shutter NTSC: 1/60 ~ 1/100 000

PAL: 1/50 ~ 1/100 000

Gain Control Automatic / Manual

Backlight Comp. Yes (Adjustable)

Wide Dynamic Range Yes (Adjustable)

Lens 3.6mm

Viewing Angle Avg: 75° (H: 80°, V: 70°)

Night Vision

Range None

IR Cut Filter No

Number of IR LEDs 0

Infrared Wavelength NA

IR LED Life (Average) NA

General

Operating Power DC 12V @ 300mA

Operating Temp. -20°C ~ 45°C (-4°F ~ 113°F)

Casing Aluminium

Dimensions 110mm x 110mm x 70mm

(4.33” x 4.33” x 2.75”)

Weight 368g / 0.8lbs (approx)

666

Problem: At night, all I see is white.

Solution: The camera is most likely looking through a window. At night, the light

from inside the room can ‘bounce back’ off a reﬂ ective surface (such as glass,

water, spider webs, some ceramics and so on) and effectively blind the camera. If

you want to see outside, mount the camera outside - we made it weather resistant

for a reason!

Problem: I see only a blank screen where my image should be.

Solution: Check the wiring to the camera, and ensure the camera is being

supplied power from the included power adapter. Try using a different video lead,

or connecting the camera to a different television or monitor. Be sure there are no

devices interrupting your signal, such as a DVR or VCR that isn’t outputting the

signal correctly.

Problem: I can’t see anything at night.

Solution: The PRO-661 dome has great low-light vision (it’ll see better in the near

dark than you do) but it’s just that - light vision. It does need some light to see! low

Security light sets (essentially spotlights triggered by a passive infrared sensor [PIR])

are a good solution if you need targeted light - they’re available from most good

hardware stores.

Some additional, technical remarks: Low Light Vision

• At 0.01lx, you’ll get an image (enough to see something moving, for example)

but it will be very difﬁ cult or impossible to see any useful details.

• At 0.1lx the quality will be signiﬁ cantly improved (enough to see an outline of

WHAT is moving).

• However, you’ll probably want to increase the amount of light signiﬁ cantly (to

1lx or more) before you’ll be able to tell is moving about!who

Under aritﬁ cial lights, the average room is illuminated to somewhere in the vicinity

of 40 ~ 60lx. If you’ve got bright lights and white walls, it may push over 100,

whereas dim lights (or energy saving lamps) and dark walls might put the value

below 20lx. The PRO-661 should work in these conditions, but there’s really no

substitute for actually shining a light on what you want to see.

Installing the Camera

The camera mounts onto the underside of a ﬂ at, vertical or horizontal surface using

screws. The surface must have sufﬁ cient strength to hold the camera. Materials

such as hardwood, brick or masonry are good options, and we’ve included all the

gear you’ll need to mount it there (except the tools - sorry, you’ll still need your

own drill). You can mount the camera onto a metal surface, but you’ll need to

supply your own mounting hardware.

To mount the camera:

• Using the small hex key

(supplied), undo the two locking

screws on the sides of the PRO-

661 dome.

• Remove the top of the dome.

• Attach the base plate of the

dome to the wall/ceiling in the

position you’d like using the

supplied screws. If mounting

to brickwork, concrete or

other masonry surface, use the

included wall plugs.

• Aim the camera in the direction you’d like. It can help to move a monitor

or television out to the camera’s location to ensure you get it aimed and

positioned properly.

• Once the camera is aimed, re-attach the dome cover. Ensure that the black,

protective plastic isn’t obscuring the camera’s vision.

Tips: Positioning your Cables

• When running your cable, try to avoid bending it at sharp angles.

• Don’t put your cable near live electrical wiring. AC electricity generates radio

“noise” which can interfere with the signal from your camera.

Tips: Weatherprooﬁ ng

• The PRO-661 is built to be weather resistant. It’ll stand up to getting wet

occasionally, but it’s not intended to be underwater all the time. When

mounting the camera, ensure that it’s not in a location where water is likely to

pool or build up over time.

• Long term exposure to direct sunlight will adversely affect the camera. Over

time, the infrared and ultraviolet radiation will eventually begin to degrade the

integrity of the plastic cover, reducing transparency and making it brittle (and,

therefore, more vulerable to vandalism or accidental damage). Basically, put it

in the shade!

The three screw holes, as seen from above.

Produktspecifikationer

Varumärke:	Swann
Kategori:	övervakningskamera
Modell:	Pro-661

Behöver du hjälp?

Om du behöver hjälp med Swann Pro-661 ställ en fråga nedan och andra användare kommer att svara dig

Ditt namn*

Din e-post*

Skriv din fråga här

övervakningskamera Swann Manualer

Swann SWNHD-866MSD Bruksanvisning

3 Oktober 2024

Swann Pro DVR8-4000 Bruksanvisning

16 September 2024

Swann SW312-HMD-CA Bruksanvisning

16 September 2024

Swann PRO-A851 Bruksanvisning

15 September 2024

Swann DVR4-1000 Bruksanvisning

9 September 2024

Swann PRO-760 Bruksanvisning

9 September 2024

Swann SW231-WMX Bruksanvisning

9 September 2024

Swann ADS-466 Bruksanvisning

8 September 2024

Swann Enforcer SWPRO-4KMQB Bruksanvisning

6 September 2024

Swann SWVID-PENBL4 Bruksanvisning

2 September 2024

övervakningskamera Manualer

Nyaste övervakningskamera Manualer

Philips B120E Bruksanvisning

16 Januari 2025

Dahua Technology Pro IPC-HDPW5442G-Z Bruksanvisning

10 Januari 2025

Hikvision DS-2CE59U1T-AVPIT3ZF Bruksanvisning

8 Januari 2025

Hikvision IDS-2CD7526G0-IZHSY Bruksanvisning

8 Januari 2025

Hikvision DS-2CD2163G0-I(S) Bruksanvisning

8 Januari 2025

Hikvision DS-2CD2H83G1-IZS Bruksanvisning

8 Januari 2025

Speco Technologies O5LB1 Bruksanvisning

8 Januari 2025

ZKTeco AntarVis 2.0 Bruksanvisning

8 Januari 2025

Speco Technologies O2P30X Bruksanvisning

8 Januari 2025

TP Link InSight S345ZI Bruksanvisning

8 Januari 2025