Vestfrost SW 355-2 M Bruksanvisning

Vestfrost kylskåp SW 355-2 M

Läs nedan 📖 manual på svenska för Vestfrost SW 355-2 M (32 sidor) i kategorin kylskåp. Denna guide var användbar för 3 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Sida 1/32
SW ... M
UK Instructions for use
DK Brugsanvisning
-2-
GB
Thank you for purchasing your new fridge/
freezer from Vestfrost. Please note that
these instructions apply to all fridge/freezers
in the SW range. Illustrations and ttings
may therefore not necessarily correspond
exactly to your model.
Warning
As the refrigerant used in this appliance is a
ammable gas (Isobutane R600a), special
care must be taken to prevent damage
to the refrigerant circuit and piping during
transport and installation.
If damage does occur, avoid sparks or
naked ame in the vicinity of the appliance,
ensure that the room is well ventilated,
disconnect the power supply, and contact
your supplier.
The unit must only be serviced by quali-
ed technicians from an approved service
centre.
Old appliances
Old refrigerators and freezers are often
tted with complicated latches that can
only be opened from the outside. If you
have one of these old units stored away
somewhere, or if you scrap one, remember
to destroy the latch rst in order to prevent
children from being exposed to great dan-
ger by getting locked inside the unit.
Before use
Before operating your new appliance,
please read the following instructions care-
fully as they contain important information
on safety, installation, operation and main-
tenance. Keep the instructions for future
reference.
On receipt, check to ensure that the appli-
ance has not been damaged during trans-
port. Transport damage should be reported
to the local distributor before the appliance
is put to use.
Remove the packaging. Clean the inside of
the cabinet using warm water with a mild
detergent. Rinse with clean water and dry
thoroughly (see cleaning instructions). Use
a soft cloth.
If during transport the appliance has been
laid down, or if it has been stored in cold
surroundings (colder than +5°C), it must be
allowed to stabilise in an upright position for
at least an hour before being switched on.
Contents
Get to know your fridge/freezer........3
Installation and start-up.....................4
Reversing the door(s).......................7
Electrical connection.........................8
Operation and function.....................9
Refrigerator section..........................9
Freezer section...............................11
Cleaning and maintenance.............13
Fault nding....................................14
Warranty, spare parts and service..15
Disposal..........................................16
-3-
GB
Get to know your fridge/freezer
g. 1
Control panel
Lighting
Shelf with storage boxes
Bottle rack
Glass shelf
Door shelf
Nameplate
Crisper bins
Freezing tray
Sealing strip
Freezer drawers
Door handle
Defrost water drain
Kick plate
Adjustable feet
-4-
GB
Placement
For safety and operational reasons, the
appliance must not be installed outdoors.
The appliance should be placed on a level
surface in a dry, well ventilated room (max.
75% relative air humidity). Never place the
appliance close to sources of heat such as
cookers or radiators, and avoid placing it in
direct sunlight.
Room temperature
The climate class is stated on the
nameplate (see g. 1 on page 3 and g. 18
on page 15). This species the optimum
room temperature.
Climate class Optimum room tem-
perature
SN +10 ºC to +32 ºC
N+16 ºC to +32 ºC
ST +18 ºC to +38 ºC
T+18 ºC to +43 ºC
Installation
The surface on which the appliance is to be
placed must be level. Do not use a frame or
similar.
The appliance can be installed as a free-
standing unit against a wall or built into a
kitchen element (g. 2). If two appliances
are placed side by side, there must be at
least 30 mm clearance between them (g.
3).
After installation, the plug should be
accessible.
600
600 600
30
g. 2
Installation and start-up
Fig. 3
-5-
GB
Ventilation
It is important that the appliance be well
ventilated and that air can circulate un-
hindered above, below and around it. The
gures below illustrate how the necessary
air circulation can be ensured (gs 6-7).
1650/1950
100
100
1560/1860
g. 6 g. 7
The appliance viewed from
above
If the appliance is placed beside a wall,
there must be sufcient room for the freezer
door to be opened wide enough to allow the
drawers to be pulled out (g. 4).
600
610 g. 4
Distance pieces
The distance pieces on the rear of the
appliance ensure sufcient air circulation.
Fit the two distance pieces supplied with the
appliance as shown in g. 5.
g. 5
-6-
GB
Setting up
It is important that the appliance be
absolutely level. To level the appliance,
remove the kick plate below the door and
screw the adjustable feet up or down (gs
8-9). If necessary, it is possible to adjust the
back feet before the upright is installed. Use
a spirit level to check that the appliance is
absolutely level.
If the appliance is to be placed on a soft
surface, e.g. oorboards or a carpet, it is
best to recheck whether the appliance is still
level after a period of time as the underlying
surface may give under the weight of the
appliance.
g. 8
g. 9
Do not tilt the upright more than 7 degrees
to avoid damaging the oor.
>7º
<7º
g. 10
g. 11

Produktspecifikationer

Varumärke: Vestfrost
Kategori: kylskåp
Modell: SW 355-2 M

Behöver du hjälp?

Om du behöver hjälp med Vestfrost SW 355-2 M ställ en fråga nedan och andra användare kommer att svara dig




kylskåp Vestfrost Manualer

kylskåp Manualer

Nyaste kylskåp Manualer