Watson AM-192-B Bruksanvisning
Watson
Accus kamera
AM-192-B
Läs nedan 📖 manual på svenska för Watson AM-192-B (4 sidor) i kategorin Accus kamera. Denna guide var användbar för 3 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare
Sida 1/4
Thank you for choosing Watson Pro
Please read this user manual carefully, and keep
it for reference before using the battery.
AM-192-B
VM-192-B
Buddy System
Li-ion Battery with LED
and 3-Stud or V-Mount
SAFETY INSTRUCTIONS
Make sure the battery is fully charged before use.
When not in use, remove the battery from its device. Some
electronic equipment will draw current even when the switch is off.
Do not short-circuit the terminals. This battery is protected with
an internal self-resetting fuse, but short circuits may still cause
severe damage to the battery.
Do not attempt to open the battery case under any circumstances.
Do not remove the battery from any equipment that is powered on.
Always power off your equipment before removing the battery.
Use the battery under proper environmental conditions: 14°F to
122°F (-10°C to 50°C) with a Relative Humidity (RH) less than 85%.
The battery may be warm during use or recharging. This is normal.
The battery should be charged up to 40% for storage longer than
one month, and should be charged every 6 months.
Keep the battery away from fire, heat, and high pressure.
Do not expose the battery to rain or moisture.
Do not drop the battery or subject it to strong shocks.
Keep this unit away from water and any flammable gases or liquids.
Clean the battery and terminals with only a clean, soft,
and dry cloth.
When operation time has noticeably decreased, the battery may
need to be replaced.
Keep this product away from children.
Store the battery in a cool, dry place.
5
6
OVERVIEW
. Battery-level check button
. Battery-level LED meter
Shows remaining capacity of
the battery. When capacity
reaches less than 9%, the
bottom LED will flash.
Slide lock
. D-tap output
12 V, 10 A max
. USB output
Press the battery-level check
button to start charging or to
power your USB device.
1. Mounting interface: 3-stud
or V-mount
1
2
3
4
5
6
4
2
3
1
IMPORTANT
You must connect both halves
of the buddy system battery in
order for it to be operational.
You can only connect the
halves of buddy system
batteries with matching
serial numbers.
After assembling the two
halves, the 100% battery
level LED will light up for
three seconds. Then, the
battery level will display the
current charge amount.
Produktspecifikationer
| Varumärke: | Watson |
| Kategori: | Accus kamera |
| Modell: | AM-192-B |
Behöver du hjälp?
Om du behöver hjälp med Watson AM-192-B ställ en fråga nedan och andra användare kommer att svara dig
Accus kamera Watson Manualer
18 September 2024
18 September 2024
18 September 2024
18 September 2024
18 September 2024
18 September 2024
18 September 2024
18 September 2024
18 September 2024
18 September 2024
Accus kamera Manualer
- Accus kamera Sony
- Accus kamera JVC
- Accus kamera Nissin
- Accus kamera Ikan
- Accus kamera SeaLife
- Accus kamera Anton/Bauer
- Accus kamera BlueShape
- Accus kamera Hedbox
- Accus kamera SWIT
- Accus kamera Bebob
- Accus kamera PAG
Nyaste Accus kamera Manualer
1 Januari 2025
27 December 2024
11 December 2024
11 December 2024
11 December 2024
23 September 2024
23 September 2024
23 September 2024
23 September 2024
23 September 2024