Whirlpool AKP 508/GR Bruksanvisning

Whirlpool Ugn AKP 508/GR

Läs nedan 📖 manual på svenska för Whirlpool AKP 508/GR (9 sidor) i kategorin Ugn. Denna guide var användbar för 9 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Sida 1/9
3
TABLE OF CONTENTS GB
INSTALLATION PAGE 4
ELECTRICAL CONNECTION PAGE 5
BEFORE USING THE OVEN PAGE 6
PROTECTING THE ENVIRONMENT PAGE 6
PRECAUTIONS AND GENERAL
RECOMMENDATIONS PAGE 6
OVEN ACCESSORIES PAGE 7
COOKING CHART PAGE 8
CLEANING THE OVEN AND ACCESSORIES PAGE 9
TROUBLESHOOTING GUIDE PAGE 10
AFTER-SALES SERVICE PAGE 11
DECLARATION OF CONFORMITY CE PAGE 11
53473-gb.fm5 Page 3 Thursday, March 8, 2001 1:18 PM
4
Technical information for the installer
After removing the oven from its packaging,
before making the connections place it on the
polystyrene foam base to protect it from
damage.
Do not attempt to lift the oven by the handle.
Lift at the sides as shown in the figure (see
arrow).
Check that the appliance has not been
damaged in transit.
Oven dimensions and kitchen unit
dimensions are shown in the opposite figure.
Kitchen units in contact with the oven must
be heat resistant (80° C min).
Install the oven in the housing, lifting it at the
sides, taking care not to trap the wires of the
electrical supply cable.
For correct ventilation, follow the ventilation
opening directions shown in the figure
(500 min x 80 mm and 500 min x 50 mm
inside the cabinet).
Secure the oven to the kitchen unit with
screws (A) as shown.
The oven has also been designed for
building-in under a cooktop.
NOTE: To allow for proper ventilation, we
recommend that you left an opening of at least
500 x 80 mm or an equivalent area in the lower
section of the housing.
An additional opening of 5 mm is required
between the oven top rim and the cooktop lower
rim: this opening must not be closed by strips or
housing crosspieces.
During oven installation, care must be taken to
ensure that the sides are not touching the front
edges of the housing or adjacent drawers and
doors (see picture).
INSTALLATION
No contacts
53473-gb.fm5 Page 4 Thursday, March 8, 2001 1:18 PM
5
Warning: Do not connect to the power
supply before you have finished
connecting the oven.
Make sure the oven is installed and
connected to the electricity supply by a
qualified technician in accordance with
the manufacturer’s instructions and in
compliance with local regulations.
The installer is responsible for the correct
electrical connection of the oven and the
observance of the relative safety
regulations.
The oven must be connected to the
electricity supply by means of an all-pole
disconnect switch with minimum contact
gap of 3 mm.
The oven must be earthed by-law.
Do not use multiple plug adapters or
extension leads.
After the oven has been installed, the
electrical components must be
inaccessible.
Make sure that the voltage shown on the
rating plate is the same as the power
supply voltage in your home. The rating
plate is on the front edge of the oven
cavity (visible with oven door open).
ELECTRICAL CONNECTION
53473-gb.fm5 Page 5 Thursday, March 8, 2001 1:18 PM

Produktspecifikationer

Varumärke: Whirlpool
Kategori: Ugn
Modell: AKP 508/GR

Behöver du hjälp?

Om du behöver hjälp med Whirlpool AKP 508/GR ställ en fråga nedan och andra användare kommer att svara dig




Ugn Whirlpool Manualer

Ugn Manualer

Nyaste Ugn Manualer