Whirlpool AKZ 185 Bruksanvisning

Whirlpool Ugn AKZ 185

Läs nedan 📖 manual på svenska för Whirlpool AKZ 185 (8 sidor) i kategorin Ugn. Denna guide var användbar för 11 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Sida 1/8
3
CONTENTS GB
INSTALLATION PAGE 4
ELECTRICAL CONNECTION PAGE 5
BEFORE USING THE OVEN PAGE 6
PROTECTING THE ENVIRONMENT PAGE 6
PRECAUTIONS AND GENERAL
RECOMMENDATIONS PAGE 6
OVEN ACCESSORIES PAGE 7
OVEN FUNCTIONS PAGE 8
CLEANING THE OVEN AND ITS
ACCESSORIES PAGE 9
TROUBLESHOOTING GUIDE PAGE 10
AFTER SALES SERVICE PAGE 10
DECLARATION OF CONFORMITY CE PAGE 10
4
Technical information for the installer
After removing the oven from its packaging,
before making the connections place it on the
polystyrene foam base to protect it from
damage.
Do not attempt to lift the oven by the handle.
Lift at the sides as shown in the figure
(see arrow).
Check that the appliance has not been
damaged in transit.
Oven dimensions and kitchen unit
dimensions are shown in the figure opposite.
Kitchen units in contact with the oven must
be heat resistant (80°C min).
If plastic laminates or cement are not
sufficiently heat-resistant, warping, bubbling
or detachment of the finish may result.
Install the oven in the housing, lifting it at the
sides, taking care not to trap the wires of the
electrical supply cable.
For correct ventilation, follow the ventilation
opening directions shown in the figure
(500 min x 80 mm and 500 min x 50 mm
inside the cabinet).
Secure the oven to the kitchen unit with
screws (A) as shown.
The oven has also been designed for
building-in under a cooktop.
NOTE: To allow for proper ventilation, we
recommend that you leave an opening of at least
500 x 80 mm or an equivalent area in the lower
section of the housing.
An additional opening of 5 mm is required
between the oven top rim and the cooktop lower
rim: this opening must not be closed by strips or
housing crosspieces.
During oven installation, care must be taken to
ensure that the sides are not touching the front
edges of the housing or adjacent drawers and
doors (see picture).
INSTALLATION
No contacts
5
Important: do not connect to the power
supply before you have finished
connecting the oven and cooktop.
Make sure the appliance is installed and
connected to the electricity supply by a
qualified technician in accordance with
the manufacturers instructions and in
compliance with local regulations.
The installer is responsible for the correct
electrical connection of the appliances
and the observance of the relative safety
recommendations.
The appliance must be connected to the
electricity supply by means of an all-pole
disconnect switch with minimum contact
gap of 3 mm.
The appliances must be earthed by law.
Do not use multiple plug adapters or
extension leads.
After the oven has been installed, the
electrical components must be
concealed.
Make sure that the voltage shown on the
rating plate is the same as the power
supply voltage in your home. The rating
plate is on the front edge of the oven
cavity (visible with oven door open).
ELECTRICAL CONNECTION

Produktspecifikationer

Varumärke: Whirlpool
Kategori: Ugn
Modell: AKZ 185

Behöver du hjälp?

Om du behöver hjälp med Whirlpool AKZ 185 ställ en fråga nedan och andra användare kommer att svara dig




Ugn Whirlpool Manualer

Ugn Manualer

Nyaste Ugn Manualer