Whirlpool AWA 5067 Bruksanvisning

Whirlpool tvättmaskin AWA 5067

Läs nedan 📖 manual på svenska för Whirlpool AWA 5067 (15 sidor) i kategorin tvättmaskin. Denna guide var användbar för 7 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/15

CONTENTS

BEFORE USING THE WASHING MACHINE

FIRST WASH CYCLE

PRECAUTIONS AND GENERAL RECOMMENDATIONS

DESCRIPTION OF THE WASHING MACHINE

PREPARATION OF THE WASHING

DETERGENTS AND ADDITIVES

CLEANING THE FOREIGN BODY TRAP

DRAINING RESIDUAL WATER

CARE AND MAINTENANCE

TROUBLESHOOTING GUIDE

AFTER-SALES SERVICE

TRANSPORT AND HANDLING

INSTALLATION

BEFORE USING THE WASHING MACHINE

1.Remove the packaging and check

a.Cut and remove the shrink-wrap.

b.Remove the top protection and the protective

corners.

c. Remove the bottom protection by tilting and

turning the appliance on one rear bottom

corner.

2.Remove the transport bracket

 The appliance is fitted with transport screws and

a transport bracket to prevent damage during

transport. Before using the washing machine

you must remove the transport bracket (see

Installation/Remove the transport bracket).

Do not forget to screw back 4 screws to the rear

panel by which was fixed the transport bracket - to

avoid noisy and vibration of the machine.

3.Install the washing machine

 Place the appliance on a flat and stable floor

surface.

 Adjust the feet to ensure that the machine is

stable and level (see Installation/Adjust the

feet).

4.Water supply

 Connect the water supply inlet hose in

accordance with the regulations of your local

water company (see Installation/Connect the

water inlet hose).

Water supply: Cold water only

Tap: 3/4 threaded hose connection

Pressure: 100-1000 kPa (1-10 bar).

For Great Britain & Ireland only:

 Water inlet: hot and cold fill. The warm water

inlet temperature must not exceed 60° C.

5.Drain hose

 Connect the drain hose to the siphon or hook it

over the edge of a sink with the U bend (see

Installation/Connect the water drain hose).

 If the washing machine is connected to a built-

in drainage system, ensure the latter is equipped

with a vent to avoid simultaneous loading and

draining of water (siphoning effect).

6.Electrical connection

 Electrical connections must be carried out by a

qualified technician in compliance with the

manufacturers instructions and the current

standard safety regulations.

 The technical data (voltage, power and fuses)

are given on the rating plate on the rear of the

appliance.

 The appliance must be connected exclusively by

means of a socket with an earth connection in

accordance with current regulations. The

appliance must be earthed by law. The

manufacturer declines all liability for damage to

persons or property deriving directly or

indirectly from failure to observe the directions.

 Do not use extension leads or multi sockets.

 Before any maintenance on the washing

machine disconnect it from the mains supply.

 Access to the mains plug or to disconnection

from the mains supply via a double-pole switch

must be ensured at all times following the

installation.

 Do not operate the washing machine if it has

been damaged during transport. Inform the

After-Sales Service.

 Mains cable replacement is only to be carried out

by After-Sales Service.

 The appliance must be connected to an effective

earthing installation, in compliance with the

regulations in force. In particular, appliances

installed in premises containing a shower or a bath

must be protected by a differential residual current

device of at least 30 mA. Earthing the appliance is

obligatory under the law. The manufacturer declines

all liability for damage to persons or property

deriving either directly or indirectly from failure to

observe the directions above.

 The washing machine may only be used in the

household for the prescribed uses.

Dimensions:

Width: 400 mm

Height: 900 mm

Depth: 600 mm

FIRST WASH CYCLE

PRECAUTIONS AND GENERAL RECOMMENDATIONS

1.Packing

 The packaging materials are 100% recyclable and

bear the recycling symbol . Adhere to local

regulations when disposing of packaging material.

2.Energy saving tips

 Achieve the best use of energy, water, detergent

and time by using the recommended maximum

load size.

 Do not exceed the detergent dosages indicated

in the manufacturers instructions.

 The Eco Ball - a special system in the outlet - will

prevent detergent loss from the drum to avoid

detergent loss into the environment.

 Use Prewash for heavily soiled laundry only!

Save detergent, time, water and energy

consumption by not selecting Prewash for

slight to normally soiled laundry.

 Pretreat stains with stain remover or soak dried

in stains in water before washing to reduce the

necessity of a hot wash program.

 Save energy by using a 60° C instead of a 90° C

wash programme or a 40° C instead of a 60° C

wash programme.

 Save energy and time by selecting a high spin

speed to reduce the water content in laundry

before using a tumble dryer (for machines with

adjustable spin speed).

3.Disposing of packaging and old appliances

 The washing machine is built from reusable

materials. The washing machine must be

disposed of in compliance with current local

waste disposal regulations.

 Before scrapping old machine, cut of the power cable

so that the washing machine cannot be connected to

the mains.

 Remove detergent from compartment if you

intend scrapping your appliance.

4.Child safety

 Children must not be allowed to play with or in

the appliance.

5.General recommendations

 Do not leave the appliance connected when not

in use. Turn off the tap.

 Before cleaning or carrying out maintenance

switch off the washing machine and disconnect

it from the mains supply.

 To clean the outside of the washing machine,

use a neutral detergent and a damp cloth.

 Do not use abrasive detergents.

 Do not attempt to force the lid open.

 If necessary, the power cable may be replaced

with an identical one obtained from our After-

Sales Service. The power cable must only be

replaced by a qualified technician.

6.EC Declaration of Conformity

 This washing machine has been designed,

constructed and distributed in compliance with

the safety requirements of EC Directives:

73/23/EEC Low Voltage Directive

89/336/EEC EMC Directive

93/68/EEC CE Marking Directive

We recommend that the first wash cycle be carried out empty. This will remove any residual water used

in the factory checks.

1.Turn on the tap.

2.Close the drum flaps. 3.Pour a small amount of detergent (about 30 ml) into the detergent dispenser .

4.Select a short programme and low spin speed (see programme chart).

5.Switch on the appliance.

Produktspecifikationer

Varumärke:	Whirlpool
Kategori:	tvättmaskin
Modell:	AWA 5067
Typ av operation:	Draaiknop
Färg på produkten:	Roestvrijstaal
Bredd:	560 mm
Djup:	550 mm
Höjd:	593 mm
Energie-efficiëntieklasse:	A
Förpackningens bredd:	594 mm
Djuppackning:	560 mm
Förpackningshöjd:	590 mm
Total inomhuskapacitet (ugnar):	58 l
Antal ugnar:	1
Lätt att städa:	Ja
Kontrollposition:	Voorkant
Att laga:	Ja
Total ugnseffekt:	1820 W
Ugn med nettokapacitet:	58 l
Över- och undervärme:	Ja
Ugnskraft:	1820 W
Strömförbrukning (typiskt):	1820 W