Appa 62 Bruksanvisning

Appa Multimeter 62

Läs nedan 📖 manual på svenska för Appa 62 (6 sidor) i kategorin Multimeter. Denna guide var användbar för 2 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/6





Safety Information

Understand and follow operating instructions carefully.

Use the meter only as specified in this manual; other-

wise, the protection provided by the meter may be

impaired.



 WARNING

˙ When using test leads or probes, keep your fingers

behind the finger guards.

˙ Remove test lead from Meter before opening the

battery door or Meter case.

˙ Use the Meter only as specified in this manual or the

protection by the Meter might be impaired.

˙ Always use proper terminals, switch position, and

range for measurements.

˙ Never attempt a voltage measurement with the test

lead inserted into the A input terminal.

˙ Verify the Meter’s operation by measuring a known

voltage. If in doubt, have the Meter serviced.

˙ Do not apply more than the rated voltage, as

marked on Meter, between terminals or between

any terminal and earth ground.

˙ Do not attempt a current measurement when the

open voltage is above the fuse protection rating.

Suspected open circuit voltage can be checked with

voltage function.

˙ Only replace the blown fuse with the proper rating

as specified in this manual.

˙ Use caution with voltages above 30 Vac rms, 42

Vac peak , or 60 Vdc. These voltages pose a shock

hazard.

˙ To avoid false readings that can lead to electric

shock and injury, replace battery as soon as low

battery indicator

<<appears.

˙ Disconnect circuit power and discharge all high-

voltage capacitors before testing resistance,

continuity, diodes, or capacitance.

˙ Do not use Meter around explosive gas or vapor.

˙To reduce the risk of fire or electric shock do not

expose this product to rain or moisture.

Symbols as marked on the meter and

Instruction card



 Risk of electric shock



 See instruction card

 DC measurement



 Equipment protected by double or reinforced

insulation

<< Battery



 Fuse



 Earth

<AC measurement



 Conforms to EU directives

Do not discard this product or throw away

Measuring AC/DC Voltage And

Frequency



Warning

Warning

WarningWarning

. . . . . .

. . . . . .. . . . . . . . . .

. . . .

. . . . . . . .

. . . .

. . . . . . . .

. . . . . .

. . . . . .. . . . . .

. . . .

. . . . . . . .

. . . . . .

. . . . . .. . . . . .

. . . .

. . . . . . . .

. . . .

. . . . . . . .

Safety sheet

Safety sheetSafety sheet

. . . .

. . . . . . . .

. . . . .

. . . . . . . . . .

. . . .

. . . . . . . .

. . . . . .

. . . . . .. . . . . .

. . . .

. . . . . . . .

. . . . . .

. . . . . .. . . . . .

. . . .

. . . . . . . .

. . . .

. . . .. . . .

. . . .

. . . . . . . .

. . . . .

. . . . .. . . . .





Read First

Testing for Continuity and Diode

APPA

61/62/62T /62R Instruction

Digital Multimeter Card

Resistance

and Capacitance

(Capacitance for 62, 62T, 62R only)

BlackRedBlackRed

Black

Red

Black

Red

Bad Diode

Good Diode

Note – To improve the measurement accuracy of small

value capacitor, record the reading with the test leads

open then substract the residual capacitance of the

Meter and leads from measurement.

CUNKNOWN = CMEASUREMENT

- CRESIDUAL

MIN MAX Record (For 62, 62T, 62R only)



 Caution

˙ Disconnect the test leads from the test points before

changing the position of the function rotary switch.

˙ Never connect a source of voltage with the function

rotary switch in Ω/ ;/ A // Hz position.

˙ Do not expose Meter to extremes in temperature or

high humidity.

˙ Never set the meter in  A function to measure

the voltage of a power supply circuit in equipment

that could result in damage the meter and the

equipment under test.

Maintenance

Do not attempt to repair this Meter. It contains no

user-serviceable parts. Repair or servicing should

only be performed by qualified personnel.

Cleaning

Periodically wipe the case with a dry cloth and

detergent. Do not use abrasives or solvents.

Disable Auto Power Off

NCV

1. Volt sense switch will be activated on any function

or at OFF status.

2. Test leads are not used for the Volt sense test.

3. Press the Volt sense button. The display goes

black, a tone sounds and the red LED lights up to

verify the instrument is operational. The Volt sense

button must be held down to detect the presence

of voltage without use of the leads.

4. If a voltage of 50V to 600V (50 to 500Hz) is

detected near the top of meter a continuous tone

sounds and the red LED near the top of meter

Illuminates.

Fuse Replacement (For 62, 62T, 62R only)

Refer to the following figure to replace fuse :

Battery Replacement

Refer to the following figure to replace the batteries :



 Caution

˙ Replace the batteries as soon as the low batteries

indicator "<" appears, to avoid false reading.

˙ Batteries 1.5V x 2



 Caution

˙ Use only a fuse with the amperage, interrupt,

voltage, and speed rating specified.

˙ Fuse rating : 10A, 500V

Non-Contact Voltage (Volt sense)

Auto Power Off (Battery Saver)

Manual Ranging and Auto Ranging

10 min

Specifications

General Specifications

Display : 2000 counts.

Polarity Indication : Automatic, positive implied,

negative indicated.

Overrange Indication : “OL” or “-OL”.

Batteries

Life : Alkaline 250 hours

Low Batteries Indication : “<” is displayed when

the batteries voltage drops below operating voltage.

Auto Power Off : Approx 10 minutes.

Operating Ambient : Non-condensing ≦

≦

≦≦50F,

51.8F ~ 86F (≦

≦

≦≦80% R.H) 87.8F ~ 104F (≦

≦

≦≦75% R.H),

105.8F ~ 122F (≦

≦

≦≦45% R.H)

Storage Temperature : -4F to 140F , 0 to 80%

R.H. when battery removed from Meter.

Temperature Coefficient :

0.15 x (Spec.Accy) / F ,< 64.4F or > 82.4F.

Measure : Samples 2 times per second nominal.

Altitude : 6561.7 ft (2000m)

Safety : Complies with EN61010-1, UL61010-1,

IEC 61010-1,

V/Ω : CAT.III. 600V, CAT.II. 1000V.

A : CAT.III. 500V (for 62/62T/62R only)

Pollution degree : 2

Power Requirements :

1.5V x 2 IEC LR03, AM4 or AAA size

Dimensions (W x H x D) : 74mm x 156mm x 44mm

Weight : (320g) including battery.

Accessories : Battery (installed), Test leads and

user manual.

Measuring DC / AC Current

(For 62, 62T, 62R only)

Disconnect

Temperature °C ,°F

DCV

Display Hold

Produktspecifikationer

Varumärke:	Appa
Kategori:	Multimeter
Modell:	62

Behöver du hjälp?

Om du behöver hjälp med Appa 62 ställ en fråga nedan och andra användare kommer att svara dig

Ditt namn*

Din e-post*

Skriv din fråga här

Multimeter Appa Manualer

Appa 62 Bruksanvisning

13 September 2024

Appa 61 Bruksanvisning

27 Juli 2024

Appa 97 Bruksanvisning

27 Juli 2024

Appa 72 Bruksanvisning

22 Juli 2024

Multimeter Manualer

Nyaste Multimeter Manualer

PCE Instruments PCE-123 Bruksanvisning

23 Oktober 2024

Voltcraft VC870 Bruksanvisning

21 Oktober 2024

Kyoritsu KEW1021R Bruksanvisning

18 Oktober 2024

Keithley DMM6500 Bruksanvisning

18 Oktober 2024

Testboy TB 65 Bruksanvisning

17 Oktober 2024

PCE Instruments PCE-228 Bruksanvisning

16 Oktober 2024

PCE Instruments PCE-PHM 14 Bruksanvisning

16 Oktober 2024

PCE Instruments PCE-LT 15 Bruksanvisning

16 Oktober 2024

PCE Instruments PCE-ITM 20 Bruksanvisning

16 Oktober 2024

PCE Instruments PCE-IT 200 Bruksanvisning

16 Oktober 2024