Azden 35XT Bruksanvisning

Läs nedan 📖 manual på svenska för Azden 35XT (12 sidor) i kategorin Inte kategoriserad. Denna guide var användbar för 7 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Sida 1/12
INSTRUCTION MANUAL
330 DUAL-CHANNEL CAMERA-MOUNT
UHF WIRELESS MICROPHONE SYSTEM
330UPR - 35BT - 35HT - 35XT
Thank you for purchasing the Azden 330 Dual-Channel Wireless Microphone system. The
components included with your system will vary depending on the system configuration you
purchased. Below are the possible system configurations available with the 330UPR Dual-Channel
Receiver.
330LT
1 x 330UPR Dual-Channel Receiver
1 x Stereo Mini-Plug to Dual XLR Cable
1 x Stereo Mini-Plug to Mini-Plug Cable
2 x 35BT Body-Pack Transmitter
2 x EX-503L Lavalier Microphone
330LH
1 x 330UPR Dual-Channel Receiver
1 x Stereo Mini-Plug to Dual XLR Cable
1 x Stereo Mini-Plug to Mini-Plug Cable
1 x 35BT Body-pack Transmitter
1 x EX-503L Lavalier Microphone
1 x 35HT Handheld Microphone / Transmitter
330LX
1 x 330UPR Dual-Channel Receiver
1 x Stereo Mini-Plug to Dual XLR Cable
1 x Stereo Mini-Plug to Mini-Plug Cable
1 x 35BT Body-Pack Transmitter
1 x EX-503L Lavalier Microphone
1 x 35XT XLR Plug-in Transmitter
CAUTION
• Do not use batteries other than the ones specified in this manual. Do not mix fresh battery with
used battery.
• When installing batteries, make sure the battery polarity is correct as marked inside the battery
compartment.
• Remove the batteries before long-term storage of the transmitters or receiver.
• Do not submerge any of the components in water.
Quick Start Guide
1. Install new AA alkaline batteries into the receiver and transmitters.
2. Connect the EX-503L lavalier microphone(s) to the MIC input on the 35BT(s).
3. Turn on your transmitters. You should see information displayed on the LCD. Be sure to also turn
the AUDIO switch to ON.
4. Set the transmission frequency for each transmitter by pressing the Channel Up/Down buttons.
Each transmitter will need to be set to a different frequency in order to run them at the same time
without interference. Keep the group number the same (1st two digits) and separate the
frequency numbers (2nd two digits) by at least 16.
5. Turn on both channels of the receiver. You can toggle the information for each channel by pressing
the DISP 1/2 button located below the LCD.
6. Set the group and frequency numbers on each channel of the receiver to match those set
previously on the transmitters.
7. The receiver should now be connected to the transmitters. To check, you can connect headphones
to the PHONE jack of the receiver and listen for audio.
For a more detailed description of component controls, functions and setup, please continue
reading this manual.
3

Produktspecifikationer

Varumärke: Azden
Kategori: Inte kategoriserad
Modell: 35XT

Behöver du hjälp?

Om du behöver hjälp med Azden 35XT ställ en fråga nedan och andra användare kommer att svara dig




Inte kategoriserad Azden Manualer

Azden

Azden 35XT Bruksanvisning

24 Augusti 2024
Azden

Azden SMH-X Bruksanvisning

15 Augusti 2024

Inte kategoriserad Manualer

Nyaste Inte kategoriserad Manualer