Bauknecht GT 193 A2+ Bruksanvisning

Bauknecht Frys GT 193 A2+

Läs nedan 📖 manual på svenska för Bauknecht GT 193 A2+ (48 sidor) i kategorin Frys. Denna guide var användbar för 10 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Sida 1/48
INSTRUCTIONS FOR USE
GB
1. Lid handle
2. Lock (if provided)
3. Seal
4. Defrost water drain plug (if present)
5. Control panel
6. Basket (if present)
7. Condenser (located at the rear)
INSTALLATION
Please refer to the chapter "BEFORE USING THE
APPLIANCE".
Unpack the appliance.
Remove the 4 protection pieces inserted between
lid and appliance.
Ensure that the defrosting water drainage plug (if
provided) is correctly positioned (4).
For best operation of the appliance and in order to
avoid damage when the lid is opened, leave a space of
at least 7 cm from the rear wall and 7 cm at the sides.
Fit the accessories (if provided).
1. Thermostat: it can be used to adjust the internal
temperature of the appliance.
2. Red LED (if provided): Indicates that the appliance
temperature is not sufficiently low.
3. Green LED (if provided): indicates that the appliance is on.
4. Yellow/orange illuminated button (if provided):
activates/deactivates the fast freeze function.
The exact configuration of the controls may vary
according to the model.
Switching on the appliance
The appliance is factory set for optimum operation at a
temperature of -18°C.
Plug in the appliance.
The green LED lights up (if provided).
Also the red LED (if provided) will switch on because the
temperature inside the appliance is not yet sufficiently low
for food storage. The red LED will normally switch off
within the first six hours after the appliance is switched on.
After connecting the appliance to the mains supply and when
the optimal temperature has been reached (this phase takes
about 1 hour during which the lid will not open), ensure that
the fast freeze button is not pressed (the yellow LED, if
provided, is off).
Place food inside the product only when the red LED (if
provided) has switched off.
Thanks to the efficient lid seal, the appliance lid will not re-
open easily immediately after closing. Wait a few minutes
before re-opening the lid of the appliance.
Temperature Adjustment
Use the thermostat to select the ideal storage temperature. To
adjust the internal temperature, proceed as follows:
Turn the thermostat knob to 1 for a storage temperature
that is less cold.
Turn the thermostat knob to 6 for a colder storage
temperature.
For partial loads, or when the load indicator is below the "e"
symbol inside the appliance (if present), it is advisable to
move the thermostat to the lower position (on "e", if present
on the thermostat scale).
Climatic Class Amb. T. (°C) Amb. T. (°F)
SN From 10 to 32 From 50 to 90
N From 16 to 32 From 61 to 90
ST From 16 to 38 From 61 to 100
T From 16 to 43 From 61 to 110
CO Small
INSTRUCTIONS FOR USE
BEFORE USING THE APPLIANCE
Your new appliance is designed exclusively for domestic use
and for storing frozen food, freezing fresh food and making
ice cubes.
Regulations require that the appliance is earthed.
The manufacturer declines all liability for injury to
persons or animals and for damage to property
resulting from failure to observe the above
procedures and reminders.
1. After unpacking, make sure that the appliance is
undamaged and that the lid closes perfectly tight. Any
damage must be reported to your dealer within 24
hours after delivery of the appliance.
2. Wait at least two hours before switching the appliance
on in order to ensure the refrigerant circuit is fully
efficient.
3. Installation of the appliance and electrical connections
must be carried out by a qualified electrician, in
accordance with the manufacturer's instructions and
local safety regulations.
4. Clean the inside of the appliance before using it.
Before connecting the appliance to the mains supply,
ensure that the voltage corresponds to that given on the
rating plate located on the rear of the appliance.
Electrical connections must be made in accordance
with local regulations.
FREEZING FOOD
Preparation of fresh food for freezing
Before freezing, wrap and seal fresh food in: aluminium
foil, cling film, air and water-tight plastic bags,
polyethylene containers with lids, provided they are
suitable for freezing foods.
Food must be fresh, mature and of prime quality in order
to obtain high quality frozen food.
Fresh vegetables and fruit should preferably be frozen as
soon as they are picked to maintain the full original
nutritional value, consistency, colour and flavour.
Always leave hot food to cool before placing in the
appliance.
Freezing fresh food
Place foods to be frozen in direct contact with the walls
of appliance:
A) - foods to be frozen,
B) - foods already frozen.
Avoid placing foods to be
frozen in direct contact with
food already frozen.
For best and fastest freezing,
foods should be split into small
portions; this will also be useful
when the frozen items are to
be used.
1. At least 24 hours before
storing fresh food in the
appliance, press the fast freeze
button.
2. Place the food to be frozen
and keep the lid of the
appliance closed for 24 hours. The fast freeze function
automatically deactivates after about 50 hours.
FOOD STORAGE
Refer to the table on the appliance (if provided).
Classification of frozen
foods
Put the frozen products
into the appliance and
classify them; The storage
date should be indicated on
the packs, to allow use
within expiry dates.
Advice for storing frozen
food
When purchasing frozen food products:
Ensure that the packaging is not damaged (frozen food in
damaged packaging may have deteriorated). If the
package is swollen or has damp patches, it may not have
been stored under optimal conditions and defrosting may
have already begun.
When shopping, leave frozen food purchases until last
and transport the products in a thermally insulated cool
bag.
Once at home, place the frozen foods immediately in the
appliance.
Avoid, or reduce temperature variations to the
minimum. Respect the best-before date on the package.
Always observe the storage information on the package.
Note:
Eat fully or partially defrosted foods immediately.
Do not refreeze unless the food is cooked after it has
thawed. Once cooked, the thawed food can be refrozen.
If there is a long power failure:
Do not open the appliance lid except to place ice packs
(if provided) over the frozen foods on the right and left
of the appliance. This will slow down the rise in
temperature.
MONTHS FOOD
INSTRUCTIONS FOR USE
PRECAUTIONS AND ADVICE
After installation, make sure the appliance is not
resting on the power cable.
Do not store glass containers with liquids in the appliance,
as they could burst.
Do not eat ice cubes or ice lollies immediately after taking
them out of the appliance, since they could cause cold
burns.
Before carrying out any maintenance or cleaning operation,
unplug the appliance or disconnect the electrical power
supply.
Do not install the appliance in places exposed to direct
sunlight or near heat sources, as this will result in higher
energy consumption.
Do not store or use petrol or other flammable liquids and
gases in the vicinity of this or other electrical appliances.
The fumes can create a fire hazard or explosion.
Install and level the appliance on a floor able to take its
weight and in a place suitable for its size and use.
Install the appliance in a dry and well-ventilated place. The
appliance is arranged for use in places with temperatures
inside the following ranges defined according to the
climatic class given on the dataplate located on the back.
The appliance may not work properly if left for a long time
at temperatures outside the range provided for.
It is advisable to leave the appliance connected, even if
empty even for short periods.
Be careful not to damage the floors (e.g. parquet) when
moving the appliance. To facilitate moving, it is advisable to
empty the appliance beforehand, if possible.
Do not use mechanical devices or any means other than
those recommended by the manufacturer to speed up the
defrosting process.
Do not use electrical appliances inside it, unless they are of
the type recommended by the manufacturer.
This appliance is not intended for use by people
(including children) with limited physical, sensory or
mental abilities or without experience and
knowledge of it, unless they are supervised or
instructed in its use by a person responsible for their
safety.
To prevent the risk of children becoming trapped
and suffocating, do not let them play or hide inside
the appliance.
The power cable must only be replaced by an
authorised person.
Do not use extension leads or multi-adapters.
It must be possible to disconnect the power supply
by unplugging or by means of a double-pole mains
switch installed ahead of the socket.
Make sure the voltage specified on dataplate
matches the voltage in your home.
Do not swallow the liquid (non-toxic) contained in
the ice packs (if provided).
Limit the number of times the appliance door is
opened.
DEFROSTING THE
APPLIANCE
The appliance should be defrosted
when the thickness of ice on the
walls reaches 5-6 mm.
Disconnect the appliance from
the mains power supply.
Remove the packs of food from
the appliance and wrap them
close together in newspaper and
store in a very cool place or
thermally insulated bag.
Leave the appliance lid open.
Remove the internal defrost water drain plug (depending
on model).
Remove the external defrost water drain plug (depending
on model) and reposition it as shown in the figure.
Place a bowl beneath the drainage channel to collect the
residual water. If available, use the divider.
Speed up defrosting by using a spatula to detach the ice
from the appliance walls.
Remove the ice from the bottom of the appliance.
In order to avoid permanent damage to the
appliance interior, do not use pointed or sharp metal
instruments for removing the ice.
Do not use abrasive products or heat up the interior
artificially.
Dry the interior of the appliance thoroughly.
On completion of the defrosting, refit the plug.
CARE AND MAINTENANCE
Remove the ice from the upper edge (see the
Troubleshooting Guide).
Clean the inside after defrosting, using a sponge dampened
with warm water and/or mild detergent.
Clean the side motor cooling grille (depending on model).
Remove dust from the condenser on the rear of the
appliance.
Before carrying out maintenance, unplug the appliance.
Do not use abrasive products, scourers or stain-
removers (e.g. acetone, trichloroethylene) to clean the
appliance.
To obtain the best results from your appliance, carry
out cleaning and maintenance at least once a year.
CHANGING THE LID LIGHT BULB (if provided)
Disconnect the appliance from the
mains power supply.
Remove the diffuser by following
the sequence of steps shown in the
figure.
Unscrew the light bulb and replace
it with an identical bulb of the same
wattage and voltage.
Refit the diffuser and plug in the appliance.
TROUBLESHOOTING GUIDE
1. The red LED (if provided) remains alight.
Is there a power failure?
Is defrosting in progress?
Is the appliance lid properly closed?
Is the appliance positioned near a heat source?
Is the thermostat setting correct?
Are the ventilation grille and condenser clean?
2. The appliance is too noisy.
Is the appliance perfectly horizontal?
Is the appliance in contact with other furniture or objects that
may cause vibrations?
Has the packaging been removed from under the appliance?

Produktspecifikationer

Varumärke: Bauknecht
Kategori: Frys
Modell: GT 193 A2+

Behöver du hjälp?

Om du behöver hjälp med Bauknecht GT 193 A2+ ställ en fråga nedan och andra användare kommer att svara dig




Frys Bauknecht Manualer

Frys Manualer

Nyaste Frys Manualer