Bertoni F1 Bruksanvisning

Läs nedan 📖 manual på svenska för Bertoni F1 (8 sidor) i kategorin Bilbarnstol. Denna guide var användbar för 3 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Sida 1/8
MANUAL INSTRUCTION
GROUP I, II
(9-25 kgs)
ECE R44/04
F1
CAR SEAT
IMPORTANT! KEEP FOR FURTHER REFERENCES .
READ CAREFULLY!
EN
EXTREME HAZARD
Do not use in passenger
seats equipped with Airbags
(SRS)
Only suitable if the approved vehicles are fitted with
3-points static or 3-point retractor safety-belts.
Approved to UN/ECER Regulation No. 16 or other
equivalent standarts.
MAINTENANCE AND CLEANING
1. The car seat can be cleaned using lukewarm water and soap. Do not use aggressive cleaners
like abrasives or thinner.
o
2. The cover should be washed by hand at a maximum temperature of 30 C. Do not put in the
dryer.
Step 1. Take the car seat out of your car.
step 2. Clean food particles and dirt with a vacuum. If possible, use a vacuum cleaner’s furniture
attachment to clean the small, hard-to reach areas of the car seat.
Step 3. Clean off the plastic portions of the seat with gentle soap and water.
Step 4. Remove the entire car seat cover, if possible, and run it through your washing machine
gentle cycle.
Step 5. Spot clean the stained spots on the car seat if you cannot remove the cover, make certain
you can use the soap on the car seat’s material by checking the package’s guidelines.
Step 6. Re-install the clean car seat in your car, and take special care that all parts of the car seat
are present and installed safely and correctly.
REMOVING AND REPLACING THE COVER AND BELT PADS
1. . ( )Loosen the belts pads See “Adjusting the height of the shoulder belts”
2. . ( .20)Loosen the cover all around Fig
3. .Pull the belts, buckle tongues and buckle through the cover
4. .Remove the cover
5. .After washing, attach the belt pads and place the cover on the shell
6. Thread the buckle, tongues and belts through the cover and fasten the cover at the release
button/positioning handle.
7. .Secure the cover on the pins
8. .Close the buckle and thread the belts through the belt pads, cover and shell
9. .Connect the shoulder belts to the belt yoke
10. .Fasten the cover all around, behind the pins

Produktspecifikationer

Varumärke: Bertoni
Kategori: Bilbarnstol
Modell: F1

Behöver du hjälp?

Om du behöver hjälp med Bertoni F1 ställ en fråga nedan och andra användare kommer att svara dig




Bilbarnstol Bertoni Manualer

Bilbarnstol Manualer

Nyaste Bilbarnstol Manualer