Binatone Latitude 50 Bruksanvisning

Binatone Walkie-talkies Latitude 50

Läs nedan 📖 manual på svenska för Binatone Latitude 50 (2 sidor) i kategorin Walkie-talkies. Denna guide var användbar för 9 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/2

USER GUIDE

Antenna

PTT(push to talk)

button

-press and hold

To transmit.

(Power)/(M)button

-press and hold to

Speaker

LCD screen

-Displays the current

Channel selection and

Other radio symbols.

CALL button

-press to send a ringing

Tone to other PMR units.

MIC(microphone)

(UP)/(DOWN)buttons

-press to change

channels and volume

settings.

1.LCD Screen

Channel Number. Changes from 1 to

8 as selected by the user.

Displays when Battery level goes low.

Displayed when in channel selection mode.

Displayed when in volume selection mode.

Displayed when transmitting a signal.

Displayed when receiving a signal.

2. Installation

2.1 Removing the Belt clip

a. Pull the belt clip Latch

away from the PMR.

b. While pulling the belt

clip latch, push up

the belt clip as

shown in Fig. 1.

2.2 Installing the Belt clip

a. Slide the belt clip into

the slot as shown in

Fig. 2.

b. A “click” indicates the

belt clip is locked into

position.

2.3 Installing the Batteries

a. Press down firmly at the top of the battery compartment cover and then

b. Insert the 3xAAA batteries. Position the

batteries according to the polarity marking

on the battery compartment. See Fig.3

c. Replace the battery cover. See Fig. 4.

Notes:

·Use only same type and make of batteries on the PMR units.

·The PMR units have a built-in Power Saver (PS) for maximum

battery life, but when not in use, turn the units OFF to save

battery power

·Remove the batteries if the units will not be used for a long period

of time.

Battery meter

The battery icon is located in the left corner of the LCD panel. This battery icon

will appear and flash when the battery is low to indicate that you should change

the batteries soon, otherwise it will turn off.

Battery life

The PMR has a built in power saver feature to make the batteries

last longer. But when you are not using the handset, it's better to

switch off to save the battery power.

3. Operation

3.1 Turning the Unit ON/OFF

To Turn ON;

a. Press and hold the /M (Power) button. A special “beep" sound

will be heard. The LCD screen will display the current channel.

To switch OFF;

b. Press and hold the /M (Power) button. A “beep" sound

will be heard and the LCD screen will turn blank.

3.2 Adjusting the Speaker volume

There are 8 volume levels.

To adjust the speaker volume level, press the (UP) button to

increase, or press the (DOWN) button to decrease. The LCD

screen will display the speaker volume level and LE. .

3.3 Receiving a Call

The unit is continuously in receive mode when the unit is turned

ON and not transmitting. When a signal is received on the current

channel, the receive signal icon“RX” will be displayed on the LCD

screen.

3.4 Transmitting (sending)

a. Press and hold the PTT (Push to Talk) button to transmit your

voice. The transmit signal icon “TX” will display on the LCD

screen.

b. Hold the unit in a vertical position with the Mic (Microphone) 5

cm away from the mouth. While holding the PTT button, speak

into the microphone in a normal tone of voice.

c. Release the PTT button

Important:

··In order for other people to receive your transmission, they must

also be on the same channel that you are currently using. Refer

to the "Changing Channel" section for more information.

··When the PTT and/or CALL buttons are continuously pressed,

your PMR cannot receive any transmissions.

3.5 Roger Beep

The Roger Beep is a tone which is automatically transmitted

whenever the PTT button is released. This alerts the

receiving party that you have ended the transmission, and

you are now in receive mode.

3.6 Changing Channels

The PMR has 8 available channels. To change channels, in

a. Press the /M (Menu) button, the channel number on the LCD

screen will start blinking.

b. While the Channel number is blinking, press the (UP) or

(DOWN) button to select the desired channel. The

channel changes from 1 to 8, or vice versa.

c. Press the /M (Menu) button to confirm your setting and return

to the standby mode.

Note:

·Refer to the "Channel Table" section of this Owner’s Manual

for detailed frequency listing.

3.7 Calling (Paging) Tone

You can use the CALL button to send a tone to other users on

the same channel. To activate this feature;

a. With the PMR in standby mode, press and release the CALL

button. The unit will transmit a 2-second page tone to the other

unit/s set with the same channel within transmitting range .

4. Auxiliary Features

4.1 Power Saving

Your PMR unit has special circuitry designed to extend the life

of your battery. When the unit is not used for 4 seconds, it will

automatically switch into a low power mode. The Power Saving

feature does not affect the PMR ability to receive transmissions.

When a signal is detected, it automatically returns to full power

mode.

0 Range (Km)

Signal Strength

Range Slope

Optimum (open area) (1)

Medium ground based

obstruction (2)

Heavily built up area (3)

The Transmission range of the product is dependent on the environment

terrain where it is being used he following diagram attempts to guide

the user on the sort of performance to expect for everyday use.

Range Check

The Transmission range will be affected as shown in the above diagram.

The transmitting range typical values for different environment conditions

will be (1) km (2) 1.5 km (3) 750m. It should be remembered that

these are only guide values as actual achieved distances will be

dependent on the environment and terrain.

5. Effective Range

6. Specifications

Channels Available 8 Channels

Output Power(TX) 0.5W

Range Up to 3 Km (2 Miles)

to finish transmitting.

standby mode;

slide the cover down to remove it.

. T

turn the PMR unit

ON or OFF.

- press to change

the PMR channel.

Channel Frequency Table

Channel Frequency(MHz) Channel Frequency(MHz)

1 446.00625 5 446.05625

2 446.01875 6 446.06875

3 446.03125 7 446.08125

4 446.04375 8 446.09375

Private Mobile Radio

VALUE

RANGE

Symptom Solution

No power.

Reception

is weak.

Cannot change

channels.

Range is limited.

Wearing the radio close to the body, such as in a pocket or on

a belt, will decrease range; change the location of the radio.

limit the range significantly.may

Open fields provide the maximum range, while steel/concrete

structures, heavy foliage, and use in buildings and in vehicles

The maximum range will vary depending on terrain and environment,

Replace with new if the battery charge level is low.batteries

Batteries may be weak.

Sound distortion

problems.

Radios too far apart. Obstacles interfere with transmission.

Tak range up to l is

Km in clear unobstructed conditions.

Radios too close. Radios must be at least 1.5 meters apart;

your distance.increase

If you are transmitting, speak in a normal tone of voice, 5 cm

away from the Mic (microphone.).

If you are receiving, lower the volume to a comfortable level.

The may be weak.batteries

Check the batteries are installed properly.

Replace the old batteries with new ones.

Press the (UP) button to increase the receiver volume level.

The receiving signal may be weak and/or out of range.

To change channels, press the (Menu) button once then

press the (UP) or (DOWN) buttons to change the current

Batteries may be weak.

Waste electrical products must not be

disposed of with household waste.

This equipment should be taken to

your local recycling centre for safe

treatment.

CAUTION

Damaged Antenna

Do not use any PMR that has a damaged antenna. If a damaged antenna comes

in contact with the skin, a minor burn may result.

Potentially Explosive Atmospheres

Turn your PMR OFF when in any area with a potentially explosive atmosphere, unless

it is a type especially qualified for such use (for example, Factory Mutual Approved).

Sparks in such areas could cause an

explosion or fire resulting in injury or even death.

Batteries

Do not replace or charge batteries in a potentially explosive atmosphere. Contact

sparking may occur while installing or removing batteries and cause an explosion.

WARNING

For Vehicles with an Air Bag

Do not place your PMR in the area over an air bag or in the air bag deployment area.

Air bags inflate with great force. If a PMR is placed in the air bag deployment

area and the air bag inflates, the PMR may be propelled with great force and

cause serious injury to the occupants of the vehicle.

Batteries

All batteries can cause property damage and/or bodily injury such as burns if

conductive material such as jewelry, keys, or beaded chains touch exposed

terminals. The material may complete an electrical circuit (short circuit) and

become quite hot. Exercise care in handling any charged battery, particularly

when placing it inside a pocket, purse, or other container with metal objects.

NOTE: Areas with potentially explosive atmospheres are often, but not always,

clearly marked. They include fueling areas such as below deck on boats; fuel or

chemical transfer or storage facilities; areas where the air contains chemicals or

particles, such as grain, dust, or metal powders; and any other area where you

would normally be advised to turn off your vehicle engine.

Blasting Caps and Areas

To avoid possible interference with blasting operations, turn your PMR OFF near

electrical blasting caps or in a “blasting area” or in areas posted: “Turn off the two-

way radio.” Obey all signs and instructions.

To clean your PMR, use a soft cloth dampened with water. Do not use cleaners or

solvent, which may cause damage that may not be covered by guarantee.

This equipment is intended for use in:

Austria

Finland

Latvia

Denmark

Ireland

Portugal

Estonia Italy Slovenia

Spain

Belgium

France

Liechtenstein

Sweden

Bulgaria

Germany

Luxemburg

Switzerland

Croatia

Greece

The Netherlands

Turkey

Cyprus

Hungary

Norway

Czech

Iceland

Poland

Romania

Countries of use

Ver ,Aug. 0

Guarantee

A gos 1 9

This product is guaranteed against manufacturing defects

for a period of 1 Year.

This does not cover the product where the fault is due to

misuse, abuse, use in contravention of the instructions,

or where the product has been the subject of unauthorised

modifications or alterations, or has been the subject of

In the event of a problem with the product within the

guarantee period please return it to your nearest Argos store.

If the item is shown to have had an inherent defect present at

the time of sale, the store will provide you with a replacement.

Your statutory rights remain unaffected.

Guarantor; Argos Ltd

489 - 499 Avebury Boulevard

Central Milton Keynes

MK9 2NW

commercial use.

Product

BINATONE TELECOM PLC

1 Apsley Way London NW2 7HF,United Kingdom.

Tel: +44(0) 20 8955 2700 Fax: +44(0) 20 8344 8877

e-mail: binatoneuk@binatonetelecom.co.uk

________________________________________ .

EC Declaration of Conformity

We the manufacturer / Importer Binatone Telecom Plc :

1 Apsley Way London

NW2 7HF, United Kingdom.

Declare under our sole responsibility that the following product

Type of equipment: Private Mobile Radio

Model Name: Series

Country of Origin: China

Brand: Binatone

complies with the essential protection requirements of R&TTE Directive 1999/5/EC on the

approximation of the laws of the Council Directive 2004/108/EC on the approximation of

the laws of the Member States relating to electromagnetic compatibility (EMC) and the

European Community Directive 2006/95/EC relating to Electrical Safety.

Assessment of compliance of the product with the requirements relating to the essential

requirements according to Article 3 R&TTE was based on Annex III of the Directive

1999/5/EC and the following standard:

EMC:

Electrical Safety:

The product is labelled with the European Approval Marking CE as show. Any Unauthorized

modification of the product voids this Declaration.

Manufacturer / Importer

(signature of authorized person)

London,

Signature: Place & Date: 8th-Jun-09

Latitude 50

ETSI EN 301 489 -5 V1.3.1(2002-08)

ETSI EN 301 489-1 V1.8.1(2008-04)

ETSI EN 300 296-2 V1.1.1(2001-03)

EN 60950-1:2006

7. Safety

8. Cleaning and Care

10. Troubleshooting Guide

channel.

If you need help 

The Help Line is available

from 9.00 am to 5.00 pm, Monday to Friday, on

0845 345 9677

Calls are charged at Local Call rate.

Produktspecifikationer

Varumärke:	Binatone
Kategori:	Walkie-talkies
Modell:	Latitude 50
Färg på produkten:	Wit
Användarmanual:	Ja
Kraftkälla:	AC
Anslutningsteknik:	Bedraad
Batteri/Batterispänning:	9 V
Certifiering:	EN14604
Inspänning:	220 V
Detektortyp:	Luchtkwaliteit detector
Anslutbar:	Ja
Kompatibel batteristorlek:	6F22
Batterier-ingår:	Ja
Testknapp:	Ja
Larm decibel:	85 dB
Backupbatterij:	Ja
Slå larm:	Ja