Black Decker BCD6SD Bruksanvisning

Black Decker Diskmaskin BCD6SD

Läs nedan 📖 manual på svenska för Black Decker BCD6SD (6 sidor) i kategorin Diskmaskin. Denna guide var användbar för 2 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF
Sida 1/6
Owner’s manual
1 866 341 3738
ww magnavox.com/en/content/7-supportw.
1 866 341 3738
ww magnavox.com/en/content/7-suppow. rt
Manuel du propriétaire
Important safety instructions
Read these instructions.
Keep these instructions.
Heed all warnings.
Follow all instructions.
Do not use this apparatus near water.
Clean only with dry cloth.
Do not block any ventilation openings. Install in
accordance with the manufacturer’s instructions.
Do not install near any heat sources such as
radiators, heat registers, stoves, or other apparatus
(including ampliers) that produce heat.
Do not defeat the safety purpose of the polarized or
grounding-type plug. A polarized plug has two blades
with one wider than the other. A grounding type plug
has two blades and a third grounding prong. The wide
blade or the third prong are provided for your safety. If
the provided plug does not t into your outlet, consult
an electrician for replacement of the obsolete outlet.
Protect the power cord from being walked on or
pinched particularly at plugs, convenience
receptacles, and the point where they exit from the
apparatus.
Only use attachments/accessories specied by the
manufacturer.
Use only with the cart, stand, tripod,
bracket, or table specied by the
manufacturer, or sold with the
apparatus. When a cart is used, use
caution when moving the cart/
apparatus combination to avoid injury
from tip-over.
Unplug this apparatus during lightning storms or when
unused for long periods of time.
Refer all servicing to qualied service personnel.
Servicing is required when the apparatus has been
damaged in any way, such as power-supply cord or
plug is damaged, liquid has been spilled or objects
have fallen into the apparatus, the apparatus has
been exposed to rain or moisture, does not operate
normally, or has been dropped.
13.
14.
No te to the CATV system installer:
This reminder is provided to call the CATV system
installer’s attention to Article 820-40 of the NEC that
provides guidelines for proper grounding and, in
particular, species that the cable ground shall be
connected to the grounding system of the building, as
close to the point of cable entry as practical.
Example of antenna grounding as per NEC -
National Electric Code
ANTENNA LEAD IN WIRE
GROUND CLAMP
ANTENNA DISCHARGE UNIT (NEC
SECTION 810-20)
ELECTRIC SERVICE EQUIPMENT
GROUNDING CONDUC RS (NEC TO
SECTION )810-21
POWER SERVICE GROUNDING
ELECTRODE STEM (NEC ART 250, SY
PART H)
GROUND CLAMPS
1.
2.
3.
4.
5.
6.
7.
8.
9.
10
.
11
.
12
.
Wall mount bracket kit
Brand Model # Screw dimension
75”
SANUS
F80b
M8 x 0.787” (20mm)
65” M6 x 0.472” (12mm)
55” M6 x 1.378” (35mm)
50”
43” SAN-25BB M4 x 1.378” (35mm)
40”
32” AST16
● Your TV meets the VESA standard for wall mounting.
Consult with your local dealer for a wall mount bracket
which is compatible with your TV model.
● The recommended wall mount bracket kit (sold separately)
allows the mounting of the TV on the wall.
● For detailed information on installing the wall mount, refer
to the wall mount Instruction book.
● Funai Corporation is not responsible for any damage to the
product or injury to yourself or others if you elect to install
the TV wall mount bracket or mount the TV onto the bracket
on your own.
● The wall mount bracket must be installed by experts.
Funai Corporation is not liable for these types of accidents or
injuries noted below.
● Install the wall mount bracket on a sturdy vertical wall.
● If installed onto a ceiling or slanted wall, the TV and wall
mount bracket may fall which could result in a severe
injury.
● Do not use screws that are longer or shorter than their
specified length. If screws too long are used this may
cause mechanical or electrical damage inside the TV set.
If screws too short are used this may cause the TV set to
fall.
● Do not fasten the screws by excessive force. This may damage
the product or cause the product to fall, leading to an injury.
● For safety reasons use 2 people to mount the TV onto a
wall mounting bracket.
● Do not mount the TV onto the wall mounting bracket while
your TV is plugged in or turned on. It may result in an
electrical shock injury.
When installing the unit on the wall, allow this much space.
Top : 11.8” (30 cm)
Left and right side : 5.9” (15 cm)
Bottom : 3.9” (10 cm)
Notice
MAGNAVOX and SMART. VERY SMART. are registered trademarks of
Koninklijke Philips N.V. and are used under license from Koninklijke Philips
N.V.
Funai Corporation reserves the right to change products at any time
without being obliged to adjust earlier supplies accordingly.
The material in this Owner's manual is believed adequate for the intended
use of the system. If the product or its individual modules or procedures
are used for purposes other than those specified herein, confirmation of
their validity and suitability must be obtained. Funai Corporation warrants
that the material itself does not infringe any United States patents. No
further warranty is expressed or implied.
Funai Corporation cannot be held responsible neither for any errors in the
content of this document nor for any problems as a result of the content
in this document. Errors reported to Funai Corporation will be adapted and
published on the Funai Corporation support website as soon as possible.
Pixel characteristics
This LCD product has a high number of color pixels. Although it has
effective pixels of 99.999% or more, black dots or bright points of light (red,
green or blue) may appear constantly on the screen. This is a structural
property of the display (within common industry standards) and is not a
malfunction.
Warranty
No components are user serviceable. Do not open or remove covers to the
inside of the product. Repairs may only be done by service centers and
official repair shops. Failure to do so shall void any warranty, stated or
implied.
Any operation expressly prohibited in this Owner’s manual, any
adjustments or assembly procedures not recommended or authorized in
this Owner’s manual shall void the warranty.
Federal communications commission notice
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
●
Reorient or relocate the receiving antenna.
●
Increase the separation between the equipment and the receiver.
●
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
●
Consult the dealer or an experienced radio or television technician for
help.
Modications
This apparatus may generate or use radio frequency energy. Changes or
modifications to this apparatus may cause harmful interference.
Any modifications to the apparatus must be approved by Funai Corporation.
The user could lose the authority to operate this apparatus if an
unauthorized change or modification is made.
Cables
Connections to this device must be made with shielded cables with
metallic RFI/EMI connector hoods to maintain compliance with FCC Rules
and regulations.
Canadian notice
CAN ICES-3 (B)/NMB-3 (B)
Analog and digital television receiving apparatus, Canada BETS-7/NTMR-7.
The following FCC/IC RSS applies to the wireless LAN
adapter included in this product.
FCC caution: Any changes or modications not expressly approved by
the party responsible for compliance could void the user’s authority to
operate this equipment.
This transmitter must not be co-located or operated in conjunction
with any other antenna or transmitter.
FCC/IC RF Exposure Compliance
This equipment complies with FCC/IC radiation exposure limits
set forth for an uncontrolled environment and meets the FCC radio
frequency (RF) Exposure Guidelines and RSS-102 of the IC radio
frequency (RF) Exposure rules.
This equipment should be installed and operated keeping the radiator
at least 20cm or more away from your body.
Compliance with FCC requirement 15.407(c)
Data transmission is always initiated by software, which is the
passed down through the MAC, through the digital and analog
baseband, and finally to the RF chip. Several special packets are
initiated by the MAC. These are the only ways the digital baseband
portion will turn on the RF transmitter, which it then turns off at the
end of the packet. Therefore, the transmitter will be on only while one
of the aforementioned packets is being transmitted. In other words,
this device automatically discontinue transmission in case of either
absence of information to transmit or operational failure.
This device complies with Part 15 of FCC Rules and Industry
Canada licence-exempt RSS standard(s). Operation is subject
to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of this
device.
5150-5250 MHz band is restricted to indoor operations only.
High-power radars are allocated as primary users (i.e. priority
users) of the bands 5250-5350 MHz and 5650-5850 MHz and
that these radars could cause interference and/or damage to LE-
LAN devices.
Compliance with FCC requirement 15.407(c) and IC
requirement RSS-210 A9.4.4
Data transmission is always initiated by software, which is the
passed down through the MAC, through the digital and analog
baseband, and finally to the RF chip. Several special packets are
initiated by the MAC. These are the only ways the digital baseband
portion will turn on the RF transmitter, which it then turns off at the
end of the packet. Therefore, the transmitter will be on only while
one of the aforementioned packets is being transmitted. In other
words, this device automatically discontinue transmission in case
of either absence of information to transmit or operational failure.

Produktspecifikationer

Varumärke: Black Decker
Kategori: Diskmaskin
Modell: BCD6SD

Behöver du hjälp?

Om du behöver hjälp med Black Decker BCD6SD ställ en fråga nedan och andra användare kommer att svara dig


Diskmaskin Black Decker Manualer

Black Decker

Black Decker BCD6SD Bruksanvisning

8 Januari 2025

Diskmaskin Manualer

Nyaste Diskmaskin Manualer

Siemens

Siemens SE 25M260 Vaatwasser Bruksanvisning

9 Januari 2025
Siemens

Siemens SE 25A092 Vaatwasser Bruksanvisning

9 Januari 2025
Siemens

Siemens SE 25A931 Vaatwasser Bruksanvisning

9 Januari 2025
Siemens

Siemens SK 25200 Vaatwasser Bruksanvisning

9 Januari 2025
Siemens

Siemens SE 34A563 Vaatwasser Bruksanvisning

9 Januari 2025
Siemens

Siemens SE 25E851 Vaatwasser Bruksanvisning

9 Januari 2025
Siemens

Siemens SE24A932 Vaatwasser Bruksanvisning

9 Januari 2025
Siemens

Siemens SE24M261 Vaatwasser Bruksanvisning

9 Januari 2025
Siemens

Siemens SE 20T290 Vaatwasser Bruksanvisning

9 Januari 2025
Siemens

Siemens SE 24E242 Vaatwasser Bruksanvisning

9 Januari 2025