Boss B65LED Bruksanvisning
Boss
Bil högtalare
B65LED
Läs nedan 📖 manual på svenska för Boss B65LED (4 sidor) i kategorin Bil högtalare. Denna guide var användbar för 13 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare
Sida 1/4

B65LED
Installation Instructions
300 Watts / 6.5” (165 mm)
3-Way Full Range Speakers (1 Pair)
Thank you for purchasing a BOSS Audio Systems product. Please read through these
instructions carefully so you will know how to install this product properly.
Package Contents
• 2x Speakers with grilles
• 2x Speaker wires with polarity connectors
• 8x Mounting screws and clip nuts
• Installation Instructions/ Cut-out Template/
Warranty
Specications
• 3-way full range system
Woofer: 6.5” (165 mm)
polypropylene cone, rubber surround
Midrange: 1” (25 mm)
Tweeter: 0.5” (13 mm)
• Output power: max 300 W
• Nominal impedance: 4 Ω
• Frequency response: 75 Hz – 20 kHz
• Sensitivity: 87 dB (1 watt/1 meter)
• LED Power supply: 12 V/DC
• LED current consumption: 20 mA
Speaker dimensions
A
B
A. Overall diameter: 6.61” (168 mm)
B. Mounting hole diameter: 5.59” / (142 mm)
C. Mounting depth: 2.13” (54 mm)
D. Grill protrusion: 0.79” (20 mm)
E. Overall speaker with grill: 6.89” (175 mm)
F. Tweeter protrusion: 0.5” (13 mm)
G. Outer motor diameter: 3.15” (80 mm)
C
D
E
F
G
- 1 -

Installation Precautions
• Consult an expert when in doubt about installation. Professional installation is always recommended.
• Prior to installation, disconnect the negative terminal of the vehicle battery.
• Connect the LED lighting to 12V power supply only. Do not connect to 24V power supply.
• When installing the speakers, take into consideration the risks that can arise from devices being torn
away in the case of an accident. Therefore, make sure the speakers are rmly secured and the mounting
area is sufciently stable.
• Avoid routing wires near any sharp or moving parts. Run wires away from other wires that may cause
unwanted noise. Insulate bare wires properly.
• If you must modify the vehicle for the speaker installation, make sure you do not impair the safety and
structural integrity of the vehicle.
• Before you drill or cut any holes, investigate your vehicle’s layout very carefully. Take special care when
you work near the fuel tank, fuel lines, hydraulic lines and electrical wiring.
Mounting
You can t the speakers in the factory speaker openings in a vehicle, or create a cutout in a vehicle for
speaker installation.
Option 1: Mounting in the factory speaker location
1. Make sure the factory speaker opening (e.g. in the door or kick panel) ts the speaker in size.
2. Remove the panel which hides the factory speaker locations, and then remove the old speaker.
3. Connect the speaker to the factory speaker wiring with correct polarity. If factory speaker wiring is
corroded, use supplied speaker wires.
4. Fasten the speaker into the factory opening with the supplied screws. Some vehicles may require a
speaker mounting adapter.
Make sure the speaker sits ush across the entire mounting surface.
Make sure the newly installed speaker does not interfere with any operations (e.g. windows rolling all the
way down if in a door, or trunk mechanism if in the rear deck, etc.)
5. Perform a quick test, then reinstall the panel. Be sure to properly break in speakers and not reach max
volume until after two 20-minute cycles at regular volume.
- 2 -

Option 2: Mounting in a new location
1. Remove the interior vehicle panel (e.g. from the door or rear deck) where the speakers are to be
mounted.
2. Cut a mounting hole and screw holes on the mounting surface as follows:
Verify the supplied template matches the speaker and mounting cut-out.
Cut out the template along the cut line. Use the cut-out template to mark the mounting hole and screw
holes on the mounting surface. Then cut the holes for the speaker to be mounted.
3. Slide the speaker from the top into the hole, and correctly place the supplied speaker grill over the top.
4. Fasten the speaker with four supplied screws and clip nuts.
Make sure the speaker sits ush across the entire mounting surface.
Make sure the newly installed speaker does not interfere with any operations (e.g. windows rolling all the
way down if in a door, or trunk mechanism if in the rear deck, etc.).
5. Using the supplied speaker wires, connect the speaker to the source unit.
6. Perform a quick test, then reinstall the panel. Be sure to properly break in speakers and not reach max
volume until after two 20-minute cycles at regular volume.
Wiring
Audio signal wiring
• Using the supplied speaker wires, connect the speakers to the audio outputs on your 12 V/DC source
unit (e.g. an amplier), the red wire to the positive terminal and the black wire to the negative terminal.
Make sure the wires are rmly attached to the terminals.
Amplifier
(12V)
Left Right
Speaker
terminals
Speaker wires
Speaker wires
• Make sure the speakers are wired correctly at 4 ohms. Observe speaker polarity when making
connections.
- 3 -
Produktspecifikationer
Varumärke: | Boss |
Kategori: | Bil högtalare |
Modell: | B65LED |
Behöver du hjälp?
Om du behöver hjälp med Boss B65LED ställ en fråga nedan och andra användare kommer att svara dig
Bil högtalare Boss Manualer

24 September 2024

21 September 2024

19 September 2024

7 September 2024

5 September 2024

3 September 2024

3 September 2024

3 September 2024

2 September 2024

2 September 2024
Bil högtalare Manualer
- Bil högtalare Sony
- Bil högtalare Philips
- Bil högtalare JBL
- Bil högtalare Kenwood
- Bil högtalare Pioneer
- Bil högtalare Alpine
- Bil högtalare Pyle
- Bil högtalare Caliber
- Bil högtalare Renkforce
- Bil högtalare Clatronic
- Bil högtalare Blaupunkt
- Bil högtalare Exibel
- Bil högtalare Crunch
- Bil högtalare Hifonics
- Bil högtalare Rockford Fosgate
- Bil högtalare Marquant
- Bil högtalare Kicker
- Bil högtalare Clarion
- Bil högtalare Mac Audio
- Bil högtalare Renegade
- Bil högtalare Focal
- Bil högtalare Auna
- Bil högtalare JL Audio
- Bil högtalare Magnat
- Bil högtalare Lanzar
- Bil högtalare Hertz
- Bil högtalare Mr Handsfree
- Bil högtalare Metra
- Bil högtalare Fusion
- Bil högtalare Infinity
- Bil högtalare Axton
- Bil högtalare Soundstream
- Bil högtalare DLS
- Bil högtalare Deaf Bonce
- Bil högtalare Ferguson
- Bil högtalare Mtx Audio
- Bil högtalare Aquatic AV
- Bil högtalare AudioControl
- Bil högtalare ESX
- Bil högtalare Planet Audio
- Bil högtalare SoundMAX
- Bil högtalare Memphis Audio
- Bil högtalare Sinustec
- Bil högtalare Sinus Live
- Bil högtalare Audiotec Fischer
Nyaste Bil högtalare Manualer

7 Januari 2025

1 Januari 2025

1 Januari 2025

JL Audio Stealthbox SB-F-150-SPRCRW/13TW5v2/TN Bruksanvisning
31 December 2025
28 December 2024

28 December 2024

27 December 2024

27 December 2024

27 December 2024

27 December 2024