Camry EL10 Bruksanvisning
Camry
Resväska vågar
EL10
Läs nedan 📖 manual på svenska för Camry EL10 (2 sidor) i kategorin Resväska vågar. Denna guide var användbar för 7 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare
Sida 1/2
11EL-001E R1
Care and maintenance:
1.Wipe the scale with a slightly damp cloth. DO NOT immerse the scale in
water or use chemical/abrasive cleaning agents.
2.DO NOT stress the triangle ring for long time. During travel, keep the scale
away from objects with sharp ends (such as toy, stationery etc.), in case the
scale is switched on frequently and consume battery power.
3.To make sure accuracy, DO NOT use this scale in strong-magnetic field.
4.Keep the scale away from babies and children to avoid danger of swallow
the batteries and small components.
Room temperature
1. Press to switch on the device, wait until LCD shows zero. Press
to view temperature (in Celsius and Fahrenheit).
When converting to temperature display mode, LCD shows"----", meaning
the scale is testing temperature and will display temperature reading in
2 seconds.
Press again
to revert the normal weighing mode.
2.
hook
triangle ring
webbing belt
removable
battery case
/slot
luggage handle
CR20 32
3V
corner A
notch B
notch C
Battery case
Specifications
1. Room temperature display
2. Zero and tare
3. 0.44 mm) LCD digits
4. Low battery / over load indication
5. Capacity: 50 kg /110 lb
6. Graduation: 50g / 0.1 lb
7. Power:1x3V lithium cell(CR2032)
"(11.3
Switch on/off (press for 2 seconds to switch off)
Convert between weight unit and temperature
Key illustration
Weighing
1. Strap the webbing belt through the luggage handle, and secure the
hook of the belt onto the triangle ring.
2. Press to switch on the scale before lifting (ensure no stress)
3. When display shows zero, press to select weight unit.
4. To re-weigh: press to reset LCD display to zero.
5. Lift the scale gently. Make sure the scale is horizontal and balanced.
LCD shows the weight of luggage. Wait for weight reading to stop and
stabilise, flash 3 times and locked. Scale will display weight reading for
2 minutes and automatically switch off.
6. When weight reading is locked, press to reset LCD display to zero
and start new weighing. Scale will automatically switch off if idle for
1 minute.
To replace battery
LCD will display "Lo" when battery power is low. Replace battery as follows:
1. Hold the scale in one hand. The thumb and index finger of the other
hand hold and press on the screw threads of the battery case and pull
out the battery case from the slot.
2. Push corner A outswards to release the used battery.
3. To insert new battery, slide one side of new battery beneath the retainer
notch B & C. Press the other side of battery till it clips underneath the
corner A. Ensure to observe the polarity as illustrated in the drawing.
4. Insert the battery case back to the slot on the scale.
The scale is powered by 1x3V (CR2032) lithium battery. At the first time of use,
open battery case cover on the right end of the scale. Remove battery isolation
sheet before use.
Power
Produktspecifikationer
| Varumärke: | Camry |
| Kategori: | Resväska vågar |
| Modell: | EL10 |
Behöver du hjälp?
Om du behöver hjälp med Camry EL10 ställ en fråga nedan och andra användare kommer att svara dig
Resväska vågar Camry Manualer
15 Oktober 2024
Resväska vågar Manualer
Nyaste Resväska vågar Manualer
17 Oktober 2024
17 Oktober 2024