Da-Lite Designer Contour Electrol 89758W Bruksanvisning

Da-Lite Projektionsduk Designer Contour Electrol 89758W

Läs nedan 📖 manual på svenska för Da-Lite Designer Contour Electrol 89758W (8 sidor) i kategorin Projektionsduk. Denna guide var användbar för 8 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/8

INSTRUCTION BOOK FOR

Designer Contour® Electrol®

With Built-In Infared Remote

Important Safety Instructions

When using your video equipment, basic safety precautions

should always be followed, including the following:

1. Read and understand all instructions before using.

2. Position the cord so that it will not be tripped over, pulled,

or contact hot surfaces.

3. If an extension cord is necessary, a cord with a current rating

at least equal to that of the appliance should be used. Cords

rated for less amperage than the appliance may overheat.

4. To reduce the risk of electric shock, do not disassemble this

appliance. Contact an authorized service dealer when repair

work is required. Incorrect reassembly can cause electric

shock when the appliance is used subsequently.

5. The use of an accessory attachment not recommended by

the manufacturer may cause a risk of ire, electric shock,

or injury to persons.

Save These Instructions

Installation

Carefully unpack screen and remove outer wrapping from case.

Remove the black tape from the slat bar after the case has been

installed.

There are three ways to install the Designer Contour® Electrol® with

built-in Infrared Remote: Wall Mount, Ceiling Mount, or Ceiling Hook.

Procedures for each method are as follows:

Wall Mount

1. Secure the wall mount bracket to the wall at the desired height.

Bracket should be fastened to wall studs or some reinforcement

within the wall. Concrete or brick walls require special fasteners

and anchors.

2. Make sure the bracket is level. See igure 1 for reference

dimensions.

3. Keep in mind you will need at least 5/8" between the ceiling and

the top of the wall mount bracket to be able to position the case

on the bracket.

4. Mount the screen case on the wall bracket as shown in igure 1.

Be sure the case is fully seated on the bracket. Tighten the stop

screws against the wall bracket.

Ceiling Mount

1. Do not remove the wall mount bracket, even if you are not using

it for mounting. This provides structural stability to the case.

2. Be sure the ceiling has adequate reinforcement to attach the

screen brackets.

3. The top of the screen case has a channel that the ceiling mount

brackets slide into. Remove the end cap on the right end of the

case and insert the brackets into the case channel. Lock the

brackets in place by tightening two set screws. Refer to igure 2.

Mount can not be more than 12" from end of case.

4. Hold the screen case up to the ceiling and mark the hole

locations. Drill holes into the ceiling and attach screen with the

appropriate fasteners for your ceiling.

Ceiling Hook

1. Do not remove the wall mount bracket, even if you are not using

it for mounting. This provides structural stability to the case.

2. Be sure the ceiling has adequate reinforcement to attach a hook

anchor.

3. The top of the screen case has a channel that the ceiling hook

brackets slide into. Remove the end cap on the right end of the

case and insert the brackets into the case channel. Lock the

brackets in place by tightening two set screws. Refer to igure 3.

4. The brackets can be attached anywhere within 12" of the end of

the case.

5. Attach an S-hook or similar fastener to the large center hole on

the bracket.

Figure 1

⁄" ⁄"

Case Hook

Wall Mount

Bracket

4 ¼"

4 ⅝"

Stop Screw

Figure 2

Set Screws (2)

Ceiling

Mount Holes

Endcap

Screws (3)

Figure 3

Set Screws (2)

Hook Mount

Hole

Endcap

Screws (3)

Produktspecifikationer

Varumärke:	Da-Lite
Kategori:	Projektionsduk
Modell:	Designer Contour Electrol 89758W
Färg på produkten:	Zwart
Vikt:	1430 g
Bredd:	482 mm
Djup:	130 mm
Höjd:	44 mm
Förpackningens vikt:	2200 g
Förpackningens bredd:	482 mm
Djuppackning:	130 mm
Förpackningshöjd:	44 mm
Antal USB 2.0-portar:	1
Mikrofon, linjeingång:	Ja
Videokapacitet:	Nee
Rackmontering:	Ja
Frekvensomfång:	10 - 23000 Hz
AUX ingång:	Ja
Antal kanaler:	8 kanalen
Total harmonisk distorsion (THD):	0.05 procent
XLR in:	Ja
Mikrofoningångsimpedans:	3300 Ohm
XLR ut:	2
Rackkapacitet:	1U
AC-ingångsspänning:	100 -240 V
AC-ingångsfrekvens:	50/60 Hz
Antal mikrofoningångar:	6
Linjeingångar (RCA):	2
Skrämmande kraft:	24 V
Säkring:	0.5 A