Da-Lite Perm-Wall 78676 Bruksanvisning
Da-Lite
Projektionsduk
Perm-Wall 78676
Läs nedan 📖 manual på svenska för Da-Lite Perm-Wall 78676 (4 sidor) i kategorin Projektionsduk. Denna guide var användbar för 5 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare
Sida 1/4
INSTRUCTION BOOK FOR
Perm Wall Frame
2
Perm Wall Installation
The Perm Wall frame should be fastened to a wall. The frame is not designed for “lying” installations.
1. Assemble frame sections together by inserting plastic corner
brackets to tubes and securing the corners with #12 sheet
metal screws. If you have a larger jointed frame, insert steel
bracket on one section of frame into other section matching
the color code. Insert 1032 screw through tube and bracket
and fasten with wing nut.
NOTE: If the viewing surface is attached to the frame before
the frame is secured to the wall, the frame may bow.
2. Place bottom of frame at desired height on wall. Make sure
bottom is level. Drill through aluminum tubing every 18" to 24"
and fasten to wall with appropriate fastener (not supplied) for
type of wall construction.
NOTE: Use appropriate fastener for wall construction, i.e.
wood screws if wall behind frame is wood construction or
other appropriate fastener if dry wall or plaster or cement
block construction.
3. Make sure that sides are at 90 degrees or right angle to
bottom and fasten to wall in like manner. Next fasten top of
frame to wall in the same manner, making sure that the
center is the same distance from the bottom as it is at the
sides of frame. This is most important for proper surface it.
NOTE: If a center spreader is shipped with frame, insert
center spreader between the bottom and the top of frame as
a guide. This is most important to insure that the top and
bottom are equal distance apart across the entire top of
frame. Lack of care in this regard will result in poor it of
surface. Center spreader can be removed once top of frame
is fastened to the wall.
4. Carefully snap surface onto frame. This completes
the installation.
3
Cleaning
Da-Mat®, High Contrast Da-Mat®, Pearlescent, Cinema Vision,
High Contrast Cinema Vision, High Contrast Cinema Perf,
Audio Vision, High Contrast Audio Vision, Da-Tex® (Rear) and
Dual Vision surfaces can be cleaned as follows:
Using a white clean cloth (100% cotton preferred) that is
dampened with clear water, gently wipe the area in one direction.
Do not use a circular motion. Using a dry 100% cotton cloth,
wipe dry after each cleaning session. To clean a stubborn stain
or a sticky surface, use denatured alcohol (methanol or methyl
alcohol) following the same procedure as for water.
Corner Plastic Bracket
Frame
Tubing
#12 Sheet Metal
Screw
Detail View Of
Frame Corner
Color Coded
Bands To
Simplify
Assembly (For
Large Screens
With Width 96"
And Over)
Binding With
Snap Buttons
Precisely
Placed
Studs For
Snap
Buttons
Wing Nut Concealed
By Binding
Detail View Of
Frame Joint
Anodized
Aluminum Frame
Steel Bracket
Frame Tubing
Picture
Surface
Produktspecifikationer
| Varumärke: | Da-Lite |
| Kategori: | Projektionsduk |
| Modell: | Perm-Wall 78676 |
Behöver du hjälp?
Om du behöver hjälp med Da-Lite Perm-Wall 78676 ställ en fråga nedan och andra användare kommer att svara dig
Projektionsduk Da-Lite Manualer
6 Oktober 2024
2 Oktober 2024
29 September 2024
27 September 2024
26 September 2024
25 September 2024
5 September 2024
29 Augusti 2024
21 Augusti 2024
18 Augusti 2024
Projektionsduk Manualer
- Projektionsduk Draper
- Projektionsduk Pyle
- Projektionsduk Optoma
- Projektionsduk AV:link
- Projektionsduk Projecta
- Projektionsduk Duronic
- Projektionsduk Celexon
- Projektionsduk Lumene
- Projektionsduk Stewart
- Projektionsduk Avers
- Projektionsduk Instaal
- Projektionsduk Elite ProAV
- Projektionsduk KHOMO GEAR
- Projektionsduk EPV
Nyaste Projektionsduk Manualer
11 Oktober 2024
29 September 2024
25 September 2024
25 September 2024
23 September 2024
23 September 2024
Celexon Ultramobile Plus Professional 194 x 146 Bruksanvisning
22 September 2024
22 September 2024
22 September 2024
22 September 2024