Da-Lite Fast-Fold Bruksanvisning

Da-Lite Projektionsduk Fast-Fold

Läs nedan 📖 manual på svenska för Da-Lite Fast-Fold (4 sidor) i kategorin Projektionsduk. Denna guide var användbar för 12 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/4

INSTRUCTION BOOK FOR

Fast-Fold® Truss Frame

Instructions

1. Unfold the 4 sections of truss frame, lock all latches and lay

face up on the loor.

2. Attach top and bottom sections to side sections using speedy

cranks. Observe color tapes so they match.

3. Unfold truss feet located in top and bottom truss sections

to raise frame of the loor.

NOTE 1: Frames have rivnuts at the hinge points on the top

and bottom sections. Insert a speedy crank through the

unthreaded rivnut and tighten into the threaded rivnut.

This will lock hinge joint securely.

NOTE 2: On screens 25' and over, another section of 6" truss

is provided. This section will mount on the top of the TOP

frame section and will appear to make an inverted “L”. “L”

section extends toward back of screen. Fasten top ”L” section

to TOP truss with speedy cranks. Observe color tapes so they

match. Flat steel diagonal braces are provided. These are

attached between the “L” section and the TOP truss frame

section. Tighten all speedy cranks securely.

Attach back braces to the BOTTOM section of the truss frame

section with speedy cranks. Observe color tapes so they

match. Tighten all speedy cranks securely.

4. Attach truss legs to side frame members at desired height,

using speedy cranks. Note color tape on legs and frame.

When matched, the screen height will be 44" of the loor.

If legs are too high, top section or sections may be folded

over. Do not tighten speedy cranks until all are started,

then tighten.

5. Lay the frame on the loor.

6. Match top of screen surface (labeled TOP) with top of frame.

7. Snap all four corners.

8. Starting at the bottom section, snap the center button.

Continue snapping the remaining buttons.

9. Attach Leg to each side of frame using at least 2 Speedy

Cranks per leg. NOTE: Speedy Crank at bottom of leg should

be on side of leg away from screen. Do not tighten Speedy

Cranks until all are started.

10. Height Adjustment. Fast-Fold® Truss screen height is

adjustable in 6" increments either up or down. Normal

screen height is 44" from bottom of frame to loor and

is the standard height for use with presentation

drapery accessories.

NOTE: Do not extend frame so that more than half of the

frame height is above the top of the legs.

11. Raise front foot of each leg and lock corner brace.

12. With one person at each leg, raise to standing position.

NOTE: With very large screens, more than 2 people may be

required.

13. Lower back foot, lock corner brace and attach”A” brace from

rear foot to back member of truss leg.

14. Attach anti-sway braces to legs.

15. To pack, reverse procedure. Use caution to prevent

surface damage.

Fast-Fold® Truss Frame Construction

Side Truss

Bottom Truss

Front Foot

Back Foot

Truss Leg

Screen

Surface

ABrace

Detail Of Corner

Assy. Fasten Trusses

With Speedy Cranks

Make Sure Speedy

Crank Is Inserted

Through All Threaded

Hinge Joints

Anti-Sway Brace

(Mounted Insde When

Used Without Drapes)

Anti-Sway Brace

(Mounted Outside When Used

With Drapes)

Under 25' Wide

Side Truss

Bottom Truss

Front Foot

Back Foot

Screen

Surface

ABrace

Detail Of Corner

Assy. Fasten Trusses

With Speedy Cranks

Make Sure Speedy Crank

Is Inserted Through All

Threaded Hinge Joints

Anti-Sway Brace

(Mounted Insde

When Used

Without Drapes)

Anti-Sway Brace

(Mounted Outside When

Used With Drapes)

25' And Wider

Truss “L” Section

Back Brace

Mounted To Bottom Of

Frame From Behind At

Hinge Locations With

(8) Speedy Cranks Each

Short Speedy Crank

Diagonal Brace

Short Speedy Crank

Assembled End View Of

Frame And "L" Section

Left Side Of Truss

Frame Is Removed For

Better Viewing Of

Truss Leg

Left Side Of Truss

Frame Is Removed

For Better Viewing Of

Truss Leg

Produktspecifikationer

Varumärke:	Da-Lite
Kategori:	Projektionsduk
Modell:	Fast-Fold
Färg på produkten:	Zwart
Anslutningsteknik:	Bedraad
Förvaringsväska:	Ja
Bärmetod:	Hoofdband
Rekommenderad användning:	Oproepen/muziek
Typ av headset:	Stereofonisch
Impedans:	42 Ohm
Placera högtalare hörlurar:	Circumaural
Hörlurars frekvensområde:	10 - 20000 Hz
Mikrofontyp:	In lijn
Hörlurskänslighet:	99 dB
Kontrollknappar:	Meerdere toetsen
Diameter på högtalaren:	40 mm
Drivrutinstyp:	Dynamisch
Typ produkt:	Headset