Da-Lite Senior Electrol Bruksanvisning
Da-Lite
Projektionsduk
Senior Electrol
Läs nedan 📖 manual på svenska för Da-Lite Senior Electrol (8 sidor) i kategorin Projektionsduk. Denna guide var användbar för 2 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare
Sida 1/8
INSTRUCTION BOOK FOR
Senior Electrol®
2
Important Safety Instructions
When using your video equipment, basic safety precautions should always be followed, including the following:
1. Read and understand all instructions before using.
2. Position the cord so that it will not be tripped over, pulled, or
contact hot surfaces.
3. If an extension cord is necessary, a cord with a current rating
at least equal to that of the appliance should be used. Cords
rated for less amperage than the appliance may overheat.
4. To reduce the risk of electric shock, do not disassemble this
appliance. Contact an authorized service dealer when repair
work is required. Incorrect reassembly can cause electric
shock when the appliance is used subsequently.
5. The use of an accessory attachment not recommended by
the manufacturer may cause a risk of ire, electric shock, or
injury to persons.
Pre-Installation
Installation
1. Carefully unpack screen and remove outer wrapping
from case.
2. Remove instruction cover plate (Fig. 1). Do not remove metal
shipping brace (secures roller), wrapping paper, or tape strips
until screen is installed.
3. Make sure to recheck measurement of screen location
before installation.
NOTE: Screen is not centered in box. Screen surface
is set 18⅝" from motor end.
Ironing Board
Some Senior Electrols, depending on size and type of picture
surface, contain an ironing board to latten the fabric (long strip
attached). The ironing board is part of the screen. Do not remove
or alter (Fig. 2).
Hangers (If required)
1. Make sure one hanger is approximately 25" from end
of case (motor end).
2. Make sure second hanger is approximately 11 ½" from
opposite end of case.
3. Place a third hanger on the center line of fabric.
4. Make sure hangers are placed to it into notches provided
on screens equipped with an ironing board.
5. Make sure hanger used on motor end does not interfere
with motor access door.
Figure 2
Hex Head
Screws Tape Strip
Shipping
Brace
(Not on 3"
Roller) Ironing
Board
Wall Type Hanger
Picture
Surface
Picture
Surface
Picture Surface
Ceiling Type
Hanger
Rafters
Wall or Ceiling Mount With Hangers
Wall Type Hangers with ceiling hanger adapters are
standard equipment. For wall type, use wall hanger only.
For ceiling type installation, use the wall type hanger and
ceiling adapters as shown in Fig. 3 on page 4.
Recessed Above Ceiling
Other methods of installation will no doubt
suggest themselves especially in new buildings
where it would be an easy matter to provide a
recess for the screen to conceal it when not in use.
Do Not Seal In-Allow Access.
For Exposed Installation
If the screen is to be mounted in an exposed
position, it may be covered with inished plywood,
veneer paneling, plastic wall covering or a valance.
Figure 1
Instruction Cover
Case
3
Installation
Screen Adjustment
NOTE: Unit is not to be installed in air handling space.
1. Level unit lengthwise with a carpenter's level and plum
level.
CAUTION! Do not completely seal in unit. Access
room must be allowed for motor repair or fabric
replacement.
2. Remove shipping brace by removing 3 hex head screws
(Fig. 2).
CAUTION! Do not cut wrapping paper or tape with
knife or any sharp tool. Remove by hand.
3. Remove wrapping paper and tape strips (Fig. 2).
4. Install electrical hook up that applies to your unit. Make
sure to review your Electrical Installation Checklists and
wiring diagrams (included) for either 120 volt switch,
220/240 volt switch, or DRC low voltage control. Unit
should be installed by a qualiied electrician.
NOTE: Must be installed in accordance with the
requirements of the Local Building Codes, the Canadian
Electrical Code (CEC), CAN/CSA C22.1 and the National
Electric Code (NEC), NFPA 70.
5. Test installation by carefully running surface up and
down several times. Be prepared to stop screen.
6. Check for satisfactory condition by running screen a
few times.
NOTE: The picture surface, when rolled down, should
have a full wrap around the roller. Do not allow any part
of the roller to become exposed.
Surface travel is stopped automatically in the fully opened and closed positions by limit switches that are properly adjusted at Da-Lite.
Should it be necessary to adjust for more or less drop of picture (viewing area), proceed in the following manner:
More Screen Drop
1. Place operating switch in “down” position.
2. When the screen stops, turn the “down” limit knob one-
quarter turn clockwise.
3. Test by raising picture surface approximately two feet, then
lower again. Repeat until desired drop is attained.
CAUTION! When screen is in bottom position, do not
adjust for more than 3" of additional drop. Roller should
not be exposed.
Less Screen Drop
1. Raise picture surface approximately two feet above desired
level.
2. Place operating switch in position.“of”
3. Turn the “down” limit knob one-quarter turn
counterclockwise.
4. Test by raising and lowering picture surface.
5. Repeat steps 3 and 4 until desired drop is attained.
NOTE: Limit “down” switch knob controls stopping point of
picture surface in bottom position.
Limit “up” switch knob controls stopping point of picture surface
inside case.
Produktspecifikationer
| Varumärke: | Da-Lite |
| Kategori: | Projektionsduk |
| Modell: | Senior Electrol |
Behöver du hjälp?
Om du behöver hjälp med Da-Lite Senior Electrol ställ en fråga nedan och andra användare kommer att svara dig
Projektionsduk Da-Lite Manualer
6 Oktober 2024
2 Oktober 2024
29 September 2024
27 September 2024
26 September 2024
25 September 2024
11 September 2024
5 September 2024
2 September 2024
1 September 2024
Projektionsduk Manualer
- Projektionsduk Draper
- Projektionsduk Pyle
- Projektionsduk Vestel
- Projektionsduk Kodak
- Projektionsduk GPX
- Projektionsduk Optoma
- Projektionsduk AV:link
- Projektionsduk Luxburg
- Projektionsduk Elite
- Projektionsduk Projecta
- Projektionsduk Oregon Scientific
- Projektionsduk Duronic
- Projektionsduk Elite Screens
- Projektionsduk EluneVision
- Projektionsduk Celexon
- Projektionsduk Lumene
- Projektionsduk Stewart
- Projektionsduk AWOL Vision
- Projektionsduk Avers
- Projektionsduk Instaal
- Projektionsduk Elite ProAV
- Projektionsduk KHOMO GEAR
- Projektionsduk EPV
Nyaste Projektionsduk Manualer
28 Januari 2025
11 Oktober 2024
29 September 2024
25 September 2024
25 September 2024
23 September 2024
23 September 2024
Celexon Ultramobile Plus Professional 194 x 146 Bruksanvisning
22 September 2024
22 September 2024
22 September 2024